Welcome to LookChem.com Sign In | Join Free

Details

Home > Chemical Encyclopedia > Chemical Technology > Organic Chemical Technology >
 Synthetic Method of Glycolonitrile
  • Synthetic Method of Glycolonitrile
  • (CAS no.: ), which is also known as formaldehyde cyanohydrin, could be produced through the following synthetic routes.

    In a 1-l. three-necked flask, fitted with a stirrer, thermometer for reading low temperatures, and a dropping funnel, and surrounded by an ice-salt bath, is placed a solution of 130 g. (2.0 moles) of potassium cyanide in 250 ml. of water. With stirring, a solution of 170 ml. (2.0 moles) of commercial 37% formaldehyde solution1 and 130 ml. of water is admitted slowly from the dropping funnel at such a rate that the temperature never rises above 10° (about 40 minutes is required). After 10 minutes' standing, 230 ml. of dilute sulfuric acid (57 ml. of concentrated sulfuric acid, sp. gr. 1.84, in 173 ml. of water) is added with stirring, the same low temperature being maintained. A copious precipitate of potassium sulfate is formed. The pH of the solution is then about 1.9. A 5% potassium hydroxide solution is then added, dropwise, and with cooling, until the pH is about 3.0 (determined either by means of a pH meter or tropaeolin 00 paper); about 4 ml. of the solution is required. The flask is then removed from the cooling bath, 30 ml. of ether is added, and the mixture is well shaken. The salt is removed by filtration, using a 14-cm. Büchner funnel, and washed with 30 ml. of ether. The filtrate is poured into a 1-l. continuous ether extractor and extracted for 48 hours with 300 ml. of ether. The ether extract is dried for 3–4 hours over 15 g. of anhydrous calcium sulfate (Drierite) and filtered. Ten milliliters of absolute ethanol is added to the filtrate, and the ether is removed on a steam bath. The residue is distilled under reduced pressure using a flask having a Vigreux side arm. After a small (2–3 ml.) fore-run, the glycolonitrile distils smoothly at 86–88°/8 mm. (102–104°/16 mm.). The yield of pure glycolonitrile amounts to 86.5–91 g. (76–80%)


    Prev:No record
    Next:No record
  • Back】【Close 】【Print】【Add to favorite
Periodic Table
    Hot Products