14459-95-1 Usage
Chemical Properties
pale yellow solid
Uses
Different sources of media describe the Uses of 14459-95-1 differently. You can refer to the following data:
1. Applied in formation of a xerogel via a cyanogel the gel has potential use in solid-state gas sensors.1
2. Moderately strong oxidizer when coupled with ferricyanide.
3. Potassium ferrocyanide is a yellow crystal also known as
yellow prussiate of potash. It was made by stirring hot potassium
carbonate with wool or horn clippings with an iron rod.
It is soluble in water 1:4 but not in alcohol. Potassium ferrocyanide
was used as a developer for some iron processes and
as an additive for alkaline pyro developers.
Preparation
Potassium hexacyanoferrate(II), K4Fe(CN)6·3H20, is obtained commercially from gasworks
spent oxide (which contains Prussian blue) by treatment with lime and subsequent
treatment of the solution with a soluble potassium salt ; the less soluble potassium hexacyanoferrate(II) can be crystallized from this mixture. In the laboratory it is readily
prepared by treating aqueous iron(II) sulphate with an excess of potassium cyanide ; the
initially precipitated iron(II) cyanide dissolves upon boiling in the excess of potassium
cyanide solution and the ferrocyanide crystallizes on cooling.
General Description
Potassium hexacyanoferrate(II) trihydrate, commonly known as potassium ferrocyanide, is a commonly used anticaking agent. Its cytotoxic and genotoxic effect has been evaluated. The growth of chemical garden in aqueous potassium hexacyanoferrate solution droplets on a superhydrophobic surface has been reported. The inhibition efficiency of potassium ferrocyanide in phosphoric acid solution against the corrosion of mild steel has been investigated.
Purification Methods
The anhydrous salt is prepared by drying at 110o over P2O5 in a vacuum desiccator. To obtain the trihydrate, it is necessary to equilibrate the salt in a desiccator over a saturated aqueous solution of sucrose and NaCl. It can also be precipitated from a saturated solution at 0o by adding an equal volume of cold 95% EtOH, setting aside for several hours, then centrifuge and wash with cold 95% EtOH. It is finally sucked air dry with water-pump vacuum. The anhydrous salt is obtained by drying the hydrate in a platinum boat at 90o in a slow stream of N2 [Loftfield & Swift J Am Chem Soc 60 3083 1938].
Structure and conformation
The trihydrate is diamagnetic
and dimorphic existing in monoclinic (pseudotetragonal) and tetragonal forms. Its infrared spectrum in solution shows a single ν(C≡ N) at 2044 cm-1, but in the solid state a large
number of bands are observed160; ν(Fe-C) occurs at 416cm-1. White, anhydrous
K4Fe(CN)6 is obtained by dehydrating the trihydrate at 100°.
Check Digit Verification of cas no
The CAS Registry Mumber 14459-95-1 includes 8 digits separated into 3 groups by hyphens. The first part of the number,starting from the left, has 5 digits, 1,4,4,5 and 9 respectively; the second part has 2 digits, 9 and 5 respectively.
Calculate Digit Verification of CAS Registry Number 14459-95:
(7*1)+(6*4)+(5*4)+(4*5)+(3*9)+(2*9)+(1*5)=121
121 % 10 = 1
So 14459-95-1 is a valid CAS Registry Number.
InChI:InChI=1/6CN.Fe.4K.3H2O/c6*1-2;;;;;;;;/h;;;;;;;;;;;3*1H2/q6*-1;+2;4*+1;;;