544-76-3Relevant articles and documents
Conversion of palmitic acid to jet fuel components over Mo/H-ZSM-22 bi-functional catalysts with high carbon reservation
Cao, Hongbin,Shi, Yanchun,Wu, Yulong,Yang, Mingde,Zhang, Jimei
, (2020)
The optimal preparation conditions of Mo/H-ZSM-22 bi-functional catalysts were obtained via the sublimation phenomenon of MoO3 at high calcination temperatures, which was beneficial for the well-dispersion of MoOx species with 5?10 nm particles. High reduction temperature enhanced the reduction from Mo6+ to Mo4+ and even from Mo4+ to Mo°, which would be beneficial for iso-alkanes formation with higher carbon reservation. Importantly, 89.3 % selectivity of C16 alkanes of which 61.7 % were iso-C16 alkanes were obtained with complete deoxygenation of palmitic acid, which was the highest selectivity of C16 alkanes over Mo/H-ZSM-22 bi-functional catalyst prepared at a calcination temperature of 550 °C and at a reduction temperature of 600 °C. The results would offer a novel candidate of bi-functional catalysts for upgrading of microalgae-based bio-oil to high-value jet fuel components with high selectivity of iso-alkanes and carbon reservation.
Decarboxylation of fatty acids over Pd supported on mesoporous carbon
Simakova, Irina,Simakova, Olga,M?ki-Arvela, P?ivi,Murzin, Dmitry Yu.
, p. 28 - 31 (2010)
Fatty acid decarboxylation was studied in a semibatch reactor over 1 wt.% Pd/C (Sibunit) using five different fatty acids, C17-C20 and C22, as feeds. The same decarboxylation rates were obtained for pure fatty acids, whereas extensive catalyst poisoning and/or sintering and coking occurred with low purity fatty acids as reactants. One reason for catalyst poisoning using behenic acid (C22) as a feedstock was its high phosphorus content. The decarboxylation rate of fatty acids decreased also with increasing fatty acid to metal ratio.
Catalytic performance and deoxygenation path of methyl palmitate on Ni2P/SiO2 synthesized using the thermal decomposition of nickel hypophosphite
Guan, Qingxin,Han, Fei,Li, Wei
, p. 31308 - 31315 (2016)
In this paper, the catalytic performance and deoxygenation path of methyl palmitate on Ni2P/SiO2 catalysts were systematically studied in a continuous flow fixed-bed reactor. A series of Ni2P/SiO2 catalysts (with different molar ratios of P/Ni and Ni2P loadings) were synthesized at 300°C using the thermal decomposition of nickel hypophosphite. The increased molar ratio of P/Ni generates phosphate-rich nickel phosphide catalysts and increasing conversion. Interestingly, Ni2P/SiO2 showed significantly higher conversion of methyl palmitate in comparison with Ni/SiO2. Furthermore, an activation temperature higher than 500°C would significantly reduce the catalytic activity, as a result of the sintering of Ni2P. The pressure in a range of 3.0 to 0.5 MPa almost has no effect on the deoxygenation of methyl palmitate, but significantly affects the reaction path and product distribution. Finally, a possible deoxygenation path over Ni2P/SiO2 was proposed based on a GC-MS investigation.
Cobalt Complexes of Bulky PNP Ligand: H2Activation and Catalytic Two-Electron Reactivity in Hydrogenation of Alkenes and Alkynes
Fayzullin, Robert R.,Gallagher, James M.,Khaskin, Eugene,Khusnutdinova, Julia R.,Lapointe, Sébastien,Osborne, James,Pandey, Dilip K.
supporting information, p. 3617 - 3626 (2021/11/16)
The reactivity of cobalt pincer complexes supported by the bulky tetramethylated PNP ligands Me4PNPR(R = iPr, tBu) has been investigated. In these ligands, the undesired H atom loss reactivity observed earlier in some classical CH2-arm PNP cobalt complexes is blocked, allowing them to be utilized for promoting two-electron catalytic transformations at the cobalt center. Accordingly, reaction of the formally CoIMe complex 3 with H2 under ambient pressure and temperature afforded the CoIII trihydride 4-H, in a reaction cascade reasoned to proceed by two-electron oxidative addition and reductive eliminations. This mechanistic proposal, alongside the observance of alkene insertion and ethane production upon sequential exposure of 3 to ethylene and H2, prompted an exploration into 3 as a catalyst for hydrogenation. Complex 4-H, formed in situ from 3 under H2, was found to be active in the catalytic hydrogenation of alkenes and alkynes. The proposed two-electron mechanism is reminiscent of the platinum group metals and demonstrates the utility of the bulky redox-innocent Me4PNPR ligand in the avoidance of one-electron reactivity, a concept that may show broad applicability in expanding the scope of earth-abundant first-row transition-metal catalysis.
Highly active cobalt complex catalysts used for alkene hydrosilylation
Liu, Yu,Li, Jiayun,Bai, Ying,Peng, Jiajian
, (2021/07/02)
A series of nitrogen phosphine ligands were synthesized, and the hydrosilylation reaction of alkenes catalyzed using MCl2 in the presence of these ligands was investigated. FeCl2/1(N1, N1, N2, N2-Tetrakis[(diphenylphosphino)methyl]ethane-1,2-diamine) showed low catalytic activity. MnCl2/1, CrCl3/1 and NiCl2/1 showed some catalytic activity. The CoCl2/N,P-ligand catalyst system showed high activity as well as excellent selectivity (The selectivity of the β-adduct was ~100%.) in the hydrosilylation reaction. CoCl2/1 showed the highest catalytic activity (~ >99.9% conversion of 1-octene). Additionally, no α-adduct, dehydrogenative silylation product and octane were detected.