- Mechanism of PCBs formation from the pyrolysis of chlorobenzenes
-
Polychlorinated biphenyls (PCBs) were formed by pyrolysis of chlorobenzenes in a HCl atmosphere. Varieties of substituted chlorobenzenes were used as model compounds to optimize the condensation reaction. Lower chlorinated benzenes produce more PCBs than that of higher ones. Up to 0.7 μg PCBs/mg 1,2,3-trichlorobenzene was produced through the condensation reaction.
- Liu, Peng-Yan,Zheng, Ming-Hui,Zhang, Bing,Xu, Xiao-Bai
-
p. 783 - 785
(2007/10/03)
-
- Formation and decomposition of chloroaromatic compounds in chlorine-containing benzene/oxygen flames
-
Premixed chlorine-containing, fuel-rich, low-pressure benzene/oxygen flames were analysed for the formation of (oxygenated) chloroaromatic compounds and their radicals by means of the condensation/radical-scavenging method (Hausmann, M., Homann, K.-H., 1995. Ber. Busenges. Phys. Chem. 99, 853-862). Several chlorinated organic compounds (methyl chloride, t-butyl chloride, chlorobenzene, chloroform) were used as additives within a maximum concentration of 10% of total fuel. Product identification and quantification were performed by GC/MS. The extent of formation of chloroaromatic compounds in these flames was largest in the cases of chlorobenzene and chloroform as additives. For chlorobenzene, 12 different chloroaromatics could be analysed in between C7H7Cl and C12H9Cl. Their formation is mainly due to conversion of initial chlorobenzene into substituted or oxidised derivatives, or growth products. Additional chlorination of aromatics is shown to be of minor importance in chlorobenzene-containing flames. Three isomeric (o/m/p) scavenging products could be identified for the chlorophenyl radical. In the chloroform case, 15 chloroaromatics could be analysed in between C6H5Cl and C14H9Cl. The weak C-Cl bond in chloroform is responsible for the high extent of chloroaromatics formation, either by Cl abstraction from the additive or by chlorination reactions via Cl radicals. Additionally, specific pathways to (di)chloroaromatics and chlorinated fulvene-type structures are outlined via CHCl2 and CCl2 radicals.
- Burfeindt,Homann
-
p. 439 - 447
(2007/10/03)
-
- The effect of oils on PAH, PCDD, PCDF, and PCB emissions from a spark engine fueled with leaded gasoline
-
The effect of synthetic and mineral oils on the formation of polyaromatic hydrocarbons (PAHs), polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs), and biphenyls (PCBs) in emissions from a spark ignition engine was studied on a Skoda Favorit engine fueled with leaded gasoline. The test cycle simulated urban traffic conditions on a chassis dynamometer, in accordance with the ECC 83.00 test. The data for selected PAHs as well as PCDDs, PCDFs, and PCBs congener profiles are presented. PCDD/Fs emissions for an unused oil and the oil after 10 000-km operation varied from 300 to 2000 fmol/m3, PCBs emissions from 75 to 178 pmol/m3, and PAHs emissions from 150 to 420 μg/m3. The content of PCBs in oils varied from 2 to 920 mg/kg.
- Broz, Jan,Grabic, Roman,Kilian, Juraj,Lojkasek, Milan,Marklund, Stellan,Ocelka, Tomas,Pekarek, Vladimir,Pribyl, Josef,Tydlitat, Vratislav,Vyska, Jan
-
p. 1905 - 1911
(2007/10/03)
-