7440-38-2Relevant articles and documents
Synthesis of volatile inorganic hydrides by electrochemical method
Turygin,Tomilov,Berezkin, M. Yu.,Fedorov
, p. 1459 - 1478 (2011/02/28)
Published data and results of our investigations on the problem of electrochemical synthesis of arsenic, phosphorus, and germanium hydrides are generalized. The results of the developments of the physicochemical bases of arsine synthesis by electrochemical reduction of arsenic acid, phosphine by reduction of white phosphorus in organic solvents, and monogermane by reduction of germanate in basic conditions are reported. The current yield of hydrides is 95, 90, and 40%, respectively. The promising guidelines of the practical use of electrochemical methods of the synthesis of the hydrides in the manufacture of semiconductor materials for microelectronics, optics, and laser engineering are discussed. The development of an arsine generator attracts considerable interest, which can serve as a basis for an aggregative continuous apparatus used in complex flow charts of manufacture of semiconductor materials.
GASEOUS DIELECTRICS WITH LOW GLOBAL WARMING POTENTIALS
-
, (2010/12/31)
A dielectric gaseous compound which exhibits the following properties: a boiling point in the range between about ?20° C. to about ?273° C.; non-ozone depleting; a GWP less than about 22,200; chemical stability, as measured by a negative standard enthalpy of formation (dHf0); a toxicity level such that when the dielectric gas leaks, the effective diluted concentration does not exceed its PEL; and a dielectric strength greater than air.
Spectrophotometric determination of arsenic via nanogold formation in micellar medium
Pal, Anjali,Maji, Sanjoy Kumar
, p. 1178 - 1182 (2007/10/03)
Colloidal gold nanoparticles are formed in aqueous anionic micellar medium by the quantitative reduction of chloroauric acid (HAuCl4) by arsine (AsH3) gas produced from arsenic bearing sample water. The absorbance of the pink gold sol (λmax at 530 nm) is a measure of arsenic concentration present in the sample. Both, As(III) and As(V) either present individually or in mixture could be determined. The molar absorptivity is 6.1×103 lit mol-1 cm-1 and the Sandell sensitivity is 1.28×10-2 μg cm-2. The gold particles, as observed from the transmission electron microscopy analysis, are spherical in nature, the average size being 14±5 nm. The linear dynamic range (LDR) for the arsenic determination is 0-0.5 ppm (0-6.67×10 -6 M). The limit of detection (LOD) is 0.005 ppm. The 95% confidence limit for 0.2 ppm of arsenic is 0.207±0.007 ppm (for 10 replicates). The relative standard deviation (RSD) is 2+/Fe3+, Ca2+/Mg 2+, PO4-3, SiO3-2, NO3-, Cl-, SO4-2, humic acid, common herbicides/pesticides like 2,4-D, endosulfan, atrazine, etc. and can be applied for the determination of total arsenic concentration in real water samples. The results are in good agreement with the SDDC method. The toxic and volatile organic solvents used for silver diethyldithiocarbamate method could be avoided in this method and hence it is safer, much easier and more reproducible.