104720-99-2Relevant academic research and scientific papers
Metal-Free Synthesis of Unsymmetrical Aryl Selenides and Tellurides via Visible Light-Driven Activation of Arylazo Sulfones
Fagnoni, Maurizio,Li, Ankun,Li, Yuxuan,Liu, Junjie,Lu, Kui,Protti, Stefano,Shan, Xiwen,Tian, Miaomiao,Zhao, Xia
supporting information, p. 7358 - 7367 (2020/12/01)
A protocol for the visible light driven preparation of unsymmetrical (hetero)aryl selenides and tellurides is described herein. The method exploits the peculiar photoreactivity of arylazo sulfones that act as thermally stable, precursors of aryl radicals under both photocatalyst- and additive-free conditions. The method developed shows an impressive versatility (more than fifty compounds isolated).
Solvent-controlled halo-selective selenylation of aryl halides catalyzed by Cu(II) supported on Al2O3. A general protocol for the synthesis of unsymmetrical organo mono- and bis-selenides
Chatterjee, Tanmay,Ranu, Brindaban C.
, p. 7145 - 7153 (2013/08/23)
Alumina-supported Cu(II) efficiently catalyzes selenylation of aryl iodides and aryl bromides by diaryl, dialkyl, and diheteroaryl diselenides in water and PEG-600, respectively, leading to a general route toward synthesis of unsymmetrical diaryl, aryl-alkyl, aryl-heteroaryl, and diheteroaryl selenides. A sequential reaction of bromoiodobenzene with one diaryl/diheteroaryl/dialkyl diselenide in water and another diaryl/diheteroaryl/dialkyl diselenide in PEG-600 in the second step produces unsymmetrical diaryl, diheteroaryl, or aryl-alkyl bis-selanyl benzene. A library of functionalized organo mono- and bis-selenides, including a potent biologically active molecule and a couple of analogues of bioactive selenides, were obtained in high yields by this protocol. The reactions are chemoselective and high yielding. The Cu-Al2O 3 catalyst is recycled for seven runs without any appreciable loss of activity.
A general and green procedure for the synthesis of organochalcogenides by CuFe2O4 nanoparticle catalysed coupling of organoboronic acids and dichalcogenides in PEG-400
Kundu, Debasish,Mukherjee, Nirmalya,Ranu, Brindaban C.
, p. 117 - 125 (2013/04/10)
A general and efficient procedure has been developed for the synthesis of organochalcogenides (selenides and tellurides) by a simple reaction of organoboronic acids and dichalcogenides catalysed by CuFe2O 4 nanoparticles in PEG-400 without any ligand. This protocol offers the scope for access to a wide spectrum of chalcogenides including diaryl, aryl-heteroaryl, aryl-styrenyl, aryl-alkenyl, aryl-allyl, aryl-alkyl and aryl-alkynyl versions. The catalyst is magnetically separable and recyclable eight times without any loss of appreciable catalytic activity. The products are obtained in high purities after evaporation of solvent followed by filtration column chromatography. The Royal Society of Chemistry.
