12042-92-1

Basic information

• Product Name: COPPER ALUMINUM OXIDE
• Synonyms: COPPER ALUMINATE;COPPER ALUMINUM OXIDE;dialuminium copper tetraoxide;COPPER ALUMINUM OXIDE, NANOPOWDER, 98.5%;Copperaluminiumoxide;Copper aluminum oxide, 99.5% (metals basis);Copper aluminate, 99.5% trace metals basis
• CAS NO: 12042-92-1
• Molecular Formula: Al2CuO4
• Molecular Weight: 181.51
• EINECS: 234-934-7
• Mol File: 12042-92-1.mol
• Article Data: 1

Chemical Properties

• Boiling Point: °Cat760mmHg
• Flash Point: °C
• Appearance: /nanopowder
• Density: g/cm³
• Storage Temp.: Room Temperature
• Water Solubility: Insoluble in water.
• CAS DataBase Reference: COPPER ALUMINUM OXIDE(CAS DataBase Reference)
• NIST Chemistry Reference: COPPER ALUMINUM OXIDE(12042-92-1)
• EPA Substance Registry System: COPPER ALUMINUM OXIDE(12042-92-1)

Safety Data

• WGK Germany: 3
• Hazardous Substances Data: 12042-92-1(Hazardous Substances Data)

Usage

Uses

Applications for copper aluminum oxide nanocrystalsare included in microbatteries, in micro-electronics, circuits and in nanowire, and in nanofluids.It is also a promising material for thermoelectric devices.

InChI:InChI=1/2Al.Cu.4O/q;;+2;;;2*-1/r2AlO2.Cu/c2*2-1-3;/q2*-1;+2

Related news

p-Type COPPER ALUMINUM OXIDE (cas 12042-92-1) thin films for gas-sensing applications07/28/2019

In this study we deposited new, ternary thin films of copper aluminum oxide with p-type and n-type behavior using RF magnetron sputtering for use as chemical gas sensors. p-Type materials are known to be good catalysts and can be combined with the well-known n-type materials for chemiresistive s...detailed

Relevant articles and documents

Total oxidation of methane over supported CuO: Influence of the MgxAlyO support

Copper oxide supported on Al2O3, MgO and Mg(Al)O mixed oxides with Mg/Al atomic ratios of 1, 3 and 5 were prepared by coprecipitation followed by calcination at 750?°C. These catalysts have been characterized by XRD, EDX, N2 adsorption, TG-DTG, NH3-TPD, CO2-TPD and H2-TPR, and their catalytic properties in the total oxidation of methane were investigated. Correlations between the physico-chemical properties and the catalytic activities were established. The best activity was obtained for the catalyst presenting a distribution of CuO species going from well distributed and aggregated CuO particles to CuAl2O4 phase on a Mg(Al)O support composed of a mixture of γ-alumina and periclase phases. It also possesses high relative amounts of strong acid and of medium and strong basic sites in this series. All the catalysts tested exhibited very good stabilities for the reaction conditions chosen and time-on-stream up to more than 50?h.