138764-36-0

Upstream product

• 119-61-9 benzophenone 
• 998-30-1 Triethoxysilane 
• 91-01-0 1,1-Diphenylmethanol 

Downstream Products

• 91-01-0 1,1-Diphenylmethanol 

Relevant academic research and scientific papers

Cu(i)-SNS complexes for outer-sphere hydroboration and hydrosilylation of carbonyls

Two new NHC-Cu(i)-[κ2-SNS] complexes were synthesized to directly compare the bifunctional catalytic activity of a hard amido vs. a soft thiolate donor. The Cu thiolate complex catalyzed ketone hydroboration but not hydrosilylation, while the C

Trivalent Rare-Earth Metal Amide Complexes as Catalysts for the Hydrosilylation of Benzophenone Derivatives with HN(SiHMe2)2 by Amine-Exchange Reaction

The rare-earth metal complexes Ln(L1)[N(SiHMe2)2](thf) (Ln=La, Ce, Y; L1=N,N′′-bis(pentafluorophenyl)diethylenetriamine dianion) were synthesized by treating Ln[N(SiHMe2)2]3(thf)2 with L1H2. The lanthanum and cerium derivatives are active catalysts for the hydrosilylation of benzophenone derivatives with HN(SiHMe2)2. An amine-exchange reaction was revealed as a key step of the catalytic cycle, in which Ln?Si?H β-agostic interactions are proposed to promote insertion of the carbonyl moiety into the Si?H bond.

New Zinc Catalyst for Hydrosilylation of Carbonyl Compounds

A new zinc complex was synthesized and applied in the catalytic hydrosilylation of carbonyl compounds. Optimization of the reaction conditions showed that the presence a substoichiometric amount of methanol accelerates the process significantly. The reaction can proceed at very low catalyst load (down to 0.1 molpercent) under mild reaction conditions. The reaction tolerates the presence of C=C bonds, and thus can be useful for the synthesis of allylic alcohols from α,β-unsaturated aldehydes and ketones.

Synthesis of silyl iron hydride: Via Si-H activation and its dual catalytic application in the hydrosilylation of carbonyl compounds and dehydration of benzamides

The hydrido silyl iron complex (o-Ph2PC6H4SiMe2)Fe(PMe3)3H (2) was obtained via the activation of the Si-H bond of the bidentate silyl ligand o-Ph2P(C6H4)SiMe2H (1) by Fe(PMe3)4. 2 showed good to excellent catalytic activity in both the reduction of aldehydes/ketones and the dehydration of benzamide. In addition, with complex 2 as a catalyst, α,β-unsaturated carbonyls could be selectively reduced to the corresponding α,β-unsaturated alcohols. The mechanisms of the formation of 2 and the catalytic dehydration process are proposed and partly experimentally verified.

Synthesis and catalytic application of [PPP]-pincer iron, nickel and cobalt complexes for the hydrosilylation of aldehydes and ketones

A new synthetic strategy for the novel diphosphine-phosphine oxide ligand (1) (Ph2P-(C6H4))2P(O)H was designed. A series of [PPP]-pincer Fe, Ni, and Co complexes were prepared. All of them were formed by chelate-assisted P-H activation. Two metal hydrides [(Ph2P-(C6H4))2P(O)]Fe(H)(PMe3)2 (2) and [(Ph2P-(C6H4))2P(O)]Ni(H)(PMe3) (3) were obtained at room temperature. The combination of ligand 1 with Co(PMe3)4Me or Co(PMe3)4 afforded the same Co(i) complex [(Ph2P-(C6H4))2P(O)]Co(PMe3)2 (4) via P-H bond activation. The catalytic performance of the Fe, Ni, and Co complexes for the hydrosilylation of aldehydes and ketones was explored. At a catalyst loading of 2 mol%, complex 2 displayed the best catalytic activity for the hydrosilylation by using (EtO)3SiH as the hydrogen source under mild conditions. Complexes 2, 3, and 4 were characterized by spectroscopic methods and X-ray diffraction analysis.

Synthesis, characterization and reactivity of iron- and cobalt-pincer complexes

The tBuPONOP (2,6-bis(di-tert-butyl-phosphinito)pyridine) complexes of iron and cobalt, (tBuPONOP)FeCl2 (1) and (tBuPONOP)CoCl2 (2)) have been prepared. Both complexes are paramagnetic and the solid-state structures of 1 and 2 were determined by single crystal X-ray diffraction studies. Analogous Fe and Co complexes of the tBuPNP (2,6-bis(di-tert-butyl-phosphinomethyl)pyridine) ligand (3 and 4, respectively) were prepared to allow comparison between the closely related pincer ligands in the hydrosilylation of carbonyl moieties. All four complexes were found to be catalytically active when treated with NaBEt3H, which was assumed to generate a metal-hydride species in-situ.

Selective C-F and C-H Activation of Fluoroarenes by Fe(PMe3)4 and Catalytic Performance of Iron Hydride in Hydrosilylation of Carbonyl Compounds

The reactions of perfluorinated toluene (CF3C6F5), pentafluoropyridine (C5NF5), and hexafluorobenzene (C6F6) with the iron(0) complex Fe(PMe3)4 were investigated. The Fe(I) complexes (4-CF3C6F4)Fe(PMe3)4 (1), (4-C5NF4)Fe(PMe3)4 (2), and (C6F5)Fe(PMe3)4 (3) were obtained by selective activation of the C-F bonds. However, under similar reaction conditions, the reaction of Fe(PMe3)4 with perfluoronaphthalene (C10F8) afforded a π-coordinated Fe(0) complex, (η4-1,2,3,4-C10F8)Fe(PMe3)3 (4), and the expected C-F bond activation reaction was not observed. The expected iron hydride (C6F5)FeH(PMe3)4 (6) could be obtained in a yield of 80% by the reaction of bromopentafluorobenzene with Fe(PMe3)4 and subsequent reduction with NaBH4. The molecular structures of complexes 2, 4, and 6 were determined by single-crystal X-ray diffraction. Complexes 1-4 and 6 could be used as catalysts for the hydrosilylation of carbonyl compounds. Among them, complex 6 is the best catalyst. The selective reduction of carbonyl groups of α,β-unsaturated aldehydes and ketones was also realized with 6 as catalyst.

Syntheses of Sterically Bulky Schiff-Base Magnesium Complexes and Their Application in the Hydrosilylation of Ketones

The sterically bulky Schiff-base ligand 1 (L1H) was treated with CH3MgI in toluene to give the unexpected homoleptic magnesium complex 2 (L1MgL1) in good yield. However, the reaction of sterically more bulky lig

Dehydrogenative coupling of alcohols and carboxylic acids with hydrosilanes catalyzed by a salen-Mn(v) complex

A Mn(v)-salen complex was found to be an effective catalyst for the dehydrogenative coupling of hydroxyl groups with hydrosilane. The reaction conditions were optimized with different silanes and efficient dehydrogenative coupling was achieved by using triethoxysilane and diphenylsilane. Various alcohols and phenols and a limited number of carboxylic acids were converted into the corresponding silyl ethers and silyl esters. A range of functional groups such as chloro, nitro, methoxy, carbonyl and carbon-carbon multiple bonds are tolerated in the reaction.

Synthesis of [POCOP]-pincer iron and cobalt complexes via Csp3-H activation and catalytic application of iron hydride in hydrosilylation reactions

Csp3-H bond activation in diphosphinito pincer ligand (Ph2PO(o-C6H2-(4,6-tBu2)))2CH2 (1) (POCH2OP) was achieved by Fe(PMe3)4 and CoMe(PMe3)4 to afford complexes (POCHOP)Fe(H) (PMe3)2 (2) and (POCHOP)Co(PMe3)2 (4) under mild conditions. Hydrido iron complex 2 reacted with iodomethane via the elimination of methane to deliver complex (POCHOP)FeI(PMe3) (3). The ligand replacement in Ni(PMe3)4 by 1 gave rise to nickel(0) complex (POCH2OP)Ni(PMe3)2 (5) without Csp3-H bond activation of the pincer ligand (1). It was confirmed that the hydrosilylation of aldehydes and ketones could be effectively catalyzed by hydrido iron complex 2. Complexes 2-5 were characterized by spectroscopic methods and X-ray single crystal diffraction analysis. This journal is