58200-70-7

Usage

General Description

White solid. Insoluble in water.

Air & Water Reactions

Insoluble in water.

Reactivity Profile

1,2,3,4,6,7,9-HEPTACHLORODIBENZO-P-DIOXIN may be sensitive to prolonged exposure to light.

Fire Hazard

Flash point data for 1,2,3,4,6,7,9-HEPTACHLORODIBENZO-P-DIOXIN are not available. 1,2,3,4,6,7,9-HEPTACHLORODIBENZO-P-DIOXIN is probably combustible.

InChI:InChI=1/C12HCl7O2/c13-2-1-3(14)9-10(4(2)15)21-12-8(19)6(17)5(16)7(18)11(12)20-9/h1H

Upstream product

• 87-86-5 Pentachlorophenol 
• 7778-73-6 pentachloro-phenol; potassium-compound 
• 58200-75-2 potassium salt of 2,3,5,6-tetrachlorophenol 
• 39227-28-6 1,2,3,4,7,8-hexachlorodibenzodioxin 
• 7572-29-4 dichloroethyne 
• 74-86-2 acetylene 
• 88-06-2 2,4,6-Trichlorophenol 
• 58-90-2 2,3,4,6-tetrachlorophenol 

Relevant academic research and scientific papers

PCDD/F inhibition by prior addition of urea to the solid fuel in laboratory experiments and results statistical evaluation

The objectives of this work were to study the effect of urea addition to the fuel before the combustion on the suppression of PCDD/F emissions, to examine the influence of urea to PCDD/F isomer patterns by employing statistical analysis techniques and to determine the most effective method of urea addition. Urea in the form of powder and as an aqueous solution was mixed with RDF and the fuel mixtures were incinerated in a lab-scale reactor at 1000°C. PCDD/F emitted during combustion experiments were collected in a quartz wool filter downstream the reactor unit. Analysis and quantification of PCDD/F showed that urea significantly affected PCDD/F emissions. Combustion of RDF containing 10% w/w urea resulted in PCDD/F emissions lower than 8 I-TEQ ng/g RDF, while the corresponding average value from single RDF combustion was 17 I-TEQ ng/g RDF. The PCDD/F prevention capacity of urea was independent from the method of urea addition to the fuel, as similar results were obtained after the addition of urea in the solid and in the aqueous phases. Results assessment by statistical methods showed that isomer patterns remained almost stable and were not affected by the method of urea addition.

Effects of oxygen on formation of PCB and PCDD/F on extracted fly ash in the presence of carbon and cupric salt

The effect of oxygen-nitrogen atmosphere (N2 + 10%O2, N2 + 1%O2 and 99.999% N2) on the formation of PCB, PCDD and PCDF by the de novo synthetic reactions in the system consisting of extracted fly ash

The effect of oils on PAH, PCDD, PCDF, and PCB emissions from a spark engine fueled with leaded gasoline

The effect of synthetic and mineral oils on the formation of polyaromatic hydrocarbons (PAHs), polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs), and biphenyls (PCBs) in emissions from a spark ignition engine was studied on a Skoda Favorit engine fueled with leaded gasoline. The test cycle simulated urban traffic conditions on a chassis dynamometer, in accordance with the ECC 83.00 test. The data for selected PAHs as well as PCDDs, PCDFs, and PCBs congener profiles are presented. PCDD/Fs emissions for an unused oil and the oil after 10 000-km operation varied from 300 to 2000 fmol/m3, PCBs emissions from 75 to 178 pmol/m3, and PAHs emissions from 150 to 420 μg/m3. The content of PCBs in oils varied from 2 to 920 mg/kg.

Copper-catalyzed chlorination and condensation of acetylene and dichloroacetylene

The chlorination and condensation of acetylene at low temperatures is demonstrated using copper chlorides as chlorinated agents coated to model borosilicate surfaces. Experiments with and without both a chlorine source and borosilicate surfaces indicate the absence of gas-phase and gas-surface reactions. Chlorination and condensation occur only in the presence of the copper catalyst. C2 through C8 organic products were observed in the effluent; PCDD/F were only observed from extraction of the borosilicate surfaces. A global reaction model is proposed that is consistent with the observed product distributions. Similar experiments with dichloroacetylene indicate greater reactivity in the absence of the copper catalyst. Reaction is observed in the gas-phase and in the presence of borosilicate surfaces at low temperatures. The formation of hexachlorobenzene is only observed in the presence of a copper catalyst. PCDD/F were only observed from extraction of the borosilicate surfaces. A global reaction model is proposed for the formation of hexachlorobenzene from dichloroacetylene. (C) 2000 Elsevier Science Ltd.

Study of evolution of PCDD/F in sewage sludge-amended soils for land restoration purposes

The evolution of polychlorinated dibenzo-p-dioxins (PCDD) and polychlorinated dibenzofurans (PCDF) in sewage sludge-amended soils used in the restoration of degraded lands, like quarries, has been studied. Two experiments were performed: one in the lab, under controlled conditions, and another in a quarry. Two different doses of sewage sludge were applied in both experiments (with two types of application in the quarry experiment) and the evolution of the amended soils were compared with that of the respective control soils (without addition of sewage sludge). The samples were analyzed with a previously validated method by HRGC-HRMS after the extraction and the necessary clean-up steps. The results reveal that polluted sewage sludge increases PCDD/F concentration in soils and that these compounds are persistent in the matrix after long periods of time. (C) 2000 Elsevier Science Ltd. The evolution of polychlorinated dibenzo-p-dioxins (PCDD) and polychlorinated dibenzofurans (PCDF) in sewage sludge-amended soils used in the restoration of degraded lands, like quarries, has been studied. Two experiments were performed: one in the lab, under controlled conditions, and another in a quarry. Two different doses of sewage sludge were applied in both experiments (with two types of application in the quarry experiment) and the evolution of the amended soils were compared with that of the respective control soils (without addition of sewage sludge). The samples were analyzed with a previously validated method by HRGC-HRMS after the extraction and the necessary clean-up steps. The results reveal that polluted sewage sludge increases PCDD/F concentration in soils and that these compounds are persistent in the matrix after long periods of time. Laboratory and field experiments were conducted in Spain to examine the evolution of PCDDs and PCDFs in sewage-sludge-amended soils. The PCDD/F concentrations were measured in the original sewage sludge and in soil samples over time. Results from the laboratory showed that the PCDD/F concentration in amended soils was related directly to the sewage-sludge dose applied. After 1 yr, however, no evolution of PCDD/Fs was observed in any sample. In the field, high dispersion was observed, which did not allow establishment of a concentration trend over time. (from Eighteenth Symp on Halogenated Environ Organic Pollutants-Dioxin '98, Stockholm, Sweden (Aug 17-21, 98)).

The formation of polychlorinated dibenzo-p-dioxins/dibenzofurans from carbon model mixtures containing ferrous chloride

The potential to form polychlorinated dibenzo-p-dioxins/furans (PCDD/F) was investigated in carbon model systems containing ferrous chloride tetrahydrate and a matrix representative of that found in particle emission from the catalytic extraction process (CEP) for wastes. Various types of carbons were used resulting in different PCDD/F yields but, with one exception, similar homologue distributions. Due to the similarity between the turbostratic structure of the carbon in the representative CEP dusts and the carbon blacks used in the model system, experiments were performed using two carbon blacks (termed CBA and CBB). On a mass basis, CBB was more reactive over the temperature range of 275-325°C and reaction times of 20-60 min in the formation of PCDD/F; as well as more adsorptive in terms of the desorption of PCDD/F. On a volume basis, the reactivities and adsorptivities were similar. A maximum in PCDD/F formation occurred at an oxygen concentration of 2% in nitrogen. (C) 2000 Elsevier Science Ltd.

Emissions of polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans from the open burning of household waste in barrels

Backyard burning of household waste in barrels is a common waste disposal practice for which pollutant emissions have not been well characterized. This study measured the emissions of several pollutants, including polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDDs/PCDFs), from burning mixtures designed to simulate waste generated by a 'recycling' and a 'nonrecycling' family in a 208-L (55-gal) burn barrel at the EPA's Open Burning Test Facility. This paper focuses on the PCDD/PCDF emissions and discusses the factors influencing PCDD/PCDF formation for different test burns. Four test burns were made in which the amount of waste placed in the barrel varied from 6.4 to 13.6 kg and the amount actually burned varied from 46.6% to 68.1%. Emissions of total PCDDs/PCDFs ranged between 0.0046 and 0.48 mg/kg of waste burned. Emissions are also presented in terms of 2,3,7,8-TCDD toxic equivalents. Emissions of PCDDs/PCDFs appear to correlate with both copper and hydrochloric acid emissions. The results of this study indicate that backyard burning emits more PCDDs/PCDFs on a mass of refuse burned basis than various types of municipal waste combustors (MWCs). Comparison of burn barrel emissions to emissions from a hypothetical modern MWC equipped with high-efficiency flue gas cleaning technology indicates that about 2-40 households burning their trash daily in barrels can produce average PCDD/PCDF emissions comparable to a 182 000 kg/day (200 ton/day) MWC facility. This study provides important data on a potentially significant source of emissions of PCDDs/PCDFs. Backyard burning of household waste in barrels is a common waste disposal practice for which pollutant emissions have not been well characterized. This study measured the emissions of several pollutants, including polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDDs/PCDFs), from burning mixtures designed to simulate waste generated by a 'recycling' and a 'nonrecycling' family in a 208-L (55-gal) burn barrel at the EPA's Open Burning Test Facility. This paper focuses on the PCDD/PCDF emissions and discusses the factors influencing PCDD/PCDF formation for different test burns. Four test burns were made in which the amount of waste placed in the barrel varied from 6.4 to 13.6 kg and the amount actually burned varied from 46.6% to 68.1%. Emissions of total PCDDs/PCDFs ranged between 0.0046 and 0.48 mg/kg of waste burned. Emissions are also presented in terms of 2,3,7,8-TCDD toxic equivalents. Emissions of PCDDs/PCDFs appear to correlate with both copper and hydrochloric acid emissions. The results of this study indicate that backyard burning emits more PCDDs/PCDFs on a mass of refuse burned basis than various types of municipal waste combustors (MWCs). Comparison of burn barrel emissions to emissions from a hypothetical modern MWC equipped with high-efficiency flue gas cleaning technology indicates that about 2-40 households burning their trash daily in barrels can produce average PCDD/PCDF emissions comparable to a 182 000 kg/day (200 ton/day) MWC facility. This study provides important data on a potentially significant source of emissions of PCDDs/PCDFs.

Mono- to tri-chlorinated dibenzodioxin (CDD) and dibenzofuran (CDF) congeners/homologues as indicators of CDD and CDF emissions from municipal waste and waste/coal combustion

Total homologue concentrations and select congener concentrations from amongst the mono- to tri-chlorinated dibenzodioxins (CDDs) and dibenzofurans (CDFs) are used to model both Total (mono- to octa-) CDD + CDF emissions and the toxicity equivalent (TEQ) of the 2,3,7,8-chlorine-substituted emissions. Analysis of emission data from two facilities indicates that use of total homologue concentrations shows limited, facility-specific correlations with Total CDDs/CDFs and TEQ. Concentrations of select mono- to tri-CDD/CDF congeners show promising correlation with CDD/CDF TEQ across facilities, suggesting that these compounds can act as TEQ indicators. (C) 2000 Elsevier Science Ltd.

Comparison of 2,4,6-trichlorophenol conversion to PCDD/PCDF on a MSWI- fly ash and a model fly ash

We performed experiments on two different matrices with 2,4,6- trichlorophenol as precursor to Polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD)/F. A municipal solid waste incinerators (MSWI) and a model fly ash were spiked in two different ways. The experiments demonstrated a three times higher formation potential of the trichlorophenol to PCDD on MSWI fly ash compared with the model fly ash used. For both fly ashes the PCDD yield was higher when gaseous trichlorophenol was fed continuously compared to mixing the fly ashes prior to the experiments with the total amount of the precursor. Despite dilution of the fly ashes tenfold with an inactive matrix the conversion of the chlorophenol was very high. (C) 2000 Elsevier Science Ltd.

Determination of polychlorinated dibenzo-p-dioxins and dibenzo-furans in solid residues from wood combustion by HRGC/HRMS

PCDD/PCDF were determined in solid samples from wood combustion. The samples included grate ashes, bottom ashes, furnace ashes as well as fly and cyclone ashes. The solid waste samples were classified into bottom and fly ash from native wood and bottom and fly ash from waste wood. For each of the four classes concentration distribution patterns from individual congeners, the sums of PCDD/PCDF and the international toxicity equivalents (I-TEQ) values are given. The I-TEQ levels of fly ash from waste wood burning can be approximately up to two thousand times higher than the values from fly ashes of natural wood. The I-TEQ levels in bottom ashes from waste wood combustion systems are as low as the corresponding ashes from the combustion of native wood. Grate ash samples from waste wood combustion systems with low carbon burnout show high levels of PCDD/PCDF.