82291-28-9

Upstream product

• 108-43-0 3-monochlorophenol 
• 87-65-0 2,6-Dichlorophenol 

Relevant academic research and scientific papers

Temperature dependence of DCDD/F isomer distributions from chlorophenol precursors

The temperature dependence of the gas-phase, rate-limited formation of dichlorodibenzo-p-dioxin (DCDD) and dichlorodibenzofuran (DCDF) isomers from 2,6-dichlorophenol and 3-chlorophenol, respectively, has been studied experimentally in an isothermal flow reactor over the range 300-900°C under pyrolytic, oxidative and catalytic conditions and computationally using semi-empirical molecular orbital methods. At high temperatures, distributions of sets of DCDD/F condensation products are consistent with the calculated thermodynamic distributions, indicating that the relative rates of formation are governed by differences in symmetry and steric hindrance present in the isomer product structures. At low temperatures, however, this is not the case. In the case of 1,6- and 1,9-DCDD formed from 2, 6-dichlorophenol via Smiles rearrangement, the 1,6 isomer is favored at low temperatures more than thermodynamically predicted. This result appears to be consistent with kinetic effects of either the expansion of the five-membered ring Smiles intermediate or a lower activation energy six-membered ring intermediate pathway that produces only the 1,6 isomer. For formation of 1,7-, 3,7- and 1,9-DCDF from 3-chlorophenol, the 1,7 isomer fraction increases at low temperatures whereas thermodynamics predicts a decrease. This result can be attributed to steric effects in alternative sandwich-type approach geometries of phenoxy radicals to form the o, o′-dihydroxybiphenyl (DOHB) intermediate via its keto-tautomers. Higher level molecular theory (ab initio) is needed to provide a more quantitative description of these kinetics.

Identification of surrogate compounds for the emission of PCDD/F (I-TEQ value) and evaluation of their on-line realtime detectability in flue gases of waste incineration plants by REMPI-TOFMS mass spectrometry

Correlations between products of incomplete combustion (PIC), e.g., chloroaromatic compounds, can be used to characterise the emissions from combustion processes, like municipal or hazardous waste incineration. A possible application of such relationships may be the on-line real-time monitoring of a characteristic surrogate, e.g., with Resonance-Enhanced Multiphoton Ionization-Time-of-Flight Mass Spectrometry (REMPI-TOFMS). In this paper, we report the relationships of homologues and individual congeners of chlorinated benzenes (PCBz), dibenzo-p-dioxins (PCDD), dibenzofurans (PCDF) and phenols (PCPh) to the International Toxicity Equivalent (I-TEQ) of the PCDD/F (I-TEQ value) in the flue gas and stack gas of a 22 MW hazardous waste incinerator (HWI). As the REMPI detection sensitivity is decreasing with the increase of the degree of chlorination, this study focuses on the lower chlorinated species of the compounds mentioned above. Lower chlorinated species, e.g., chlorobenzene (MCBz), 1,4-dichlorobenzene, 2,4,6-trichlorodibenzofuran or 2,4-dichlorophenol, were identified as I-TEQ surrogates in the flue gas. In contrast to the higher chlorinated phenols, the lower chlorinated phenols (degree of chlorination 4) were not reliable as surrogates in the stack gas. The identified surrogates are evaluated in terms of their detectability by REMPI-TOFMS laser mass spectrometry. The outcome is that MCBz is the best suited surrogate for (indirect) on-line measuring of the I-TEQ value in the flue gas by REMPI-TOFMS. The correlation coefficient r of the MCBz concentration to the I-TEQ in the flue gas was 0.85.