Welcome to LookChem.com Sign In | Join Free

Details

Home > Chemical Encyclopedia > Chemical Technology > Organic Chemical Technology >
 Preparation of o-Phenylene carbonate
  • Preparation of o-Phenylene carbonate
  • o-Phenylene ate (CAS NO.: ), which is known as , o-phenylene ester, could be produced through the following synthetic route.

    Preparation of o-Phenylene carbonate

    In a 5-l. three-necked flask, filled with nitrogen, 110 g. (1.0 mole) of recrystallized catechol is dissolved in 250 ml. of deaerated water containing 88 g. (2.2 moles) of sodium hydroxide. The flask is fitted with a gas inlet tube, a thermometer dipping into the liquid, and an efficient glass mechanical stirrer with a gas-tight rubber slip seal and is immersed in an ice-salt bath. A positive nitrogen pressure of about 1 cm. is maintained by attaching the inlet tube to a source of nitrogen through a line containing a T-tube dipping into mercury. A solution of 200–225 g. (2.0–2.3 moles) of commercial phosgene in 750 ml. of toluene is prepared at 0° by bubbling the gas into toluene in a tared flask, and the solution is added to the flask in portions of about 50 ml. with good mechanical stirring over a period of 60 to 75 minutes. During the addition the temperature is maintained at 0–5° by periodic addition to the mixture of clean cracked ice, free from dirt and iron rust. After addition of the toluene solution of phosgene is completed, the mixture is stirred at 0–5° for 1 hour and then allowed to come to room temperature. The mixture is filtered with suction, and the solid is pressed on the funnel to remove as much water as possible. The aqueous portion of the filtrate is separated, and the solid on the funnel is added to the toluene in the filtrate and dissolved by warming. The warm toluene solution is filtered and distilled under reduced pressure (water aspirator) until the product begins to crystallize. The residue is warmed to redissolve the solid, and then chilled. The o-phenylene carbonate is collected on a suction filter and dried in a vacuum desiccator; the yield is 98–110 g., m.p. 119–120°.

    Concentration of the filtrate yields a second crop of impure product, which is recrystallized from toluene and then melts at 119–120°. The combined yield of pure white o-phenylene carbonate from the first and second crops is 107–116 g. (79–85%).

    Notice: This preparation should be conducted in a hood to avoid exposure to toxic phosgene.


    Prev:No record
    Next:No record
  • Back】【Close 】【Print】【Add to favorite
Periodic Table
    Hot Products