2456-68-0Relevant articles and documents
Mild and selective palladium-catalyzed dimerization of terminal alkynes to form symmetrical (Z,Z)-1,4-dihalo-1,3-dienes
Li, Jin-Heng,Liang, Yun,Xie, Ye-Xiang
, p. 8125 - 8127 (2004)
A regioselective and stereoselective palladium-catalyzed dimerization of terminal alkynes method for the synthesis of symmetrical (Z,Z)-1,4-dihalo-1,3- dienes is presented. In the presence of a catalytic amount of PdX2 and 3 equiv of CuX2
Multifunctional palladium catalysis. 2. Tandem haloallylation followed by Wacker-Tsuji oxidation or Sonogashira cross-coupling
Thadani, Avinash N.,Rawal, Viresh H.
, p. 4321 - 4323 (2002)
(equationpresented) Multifunctional palladium catalysis is utilized in the one-pot stereocontrolled synthesis of tetrasubstituted methyl ketones and enynes. The homogeneous palladium dihalide catalyst utilized for the bromo-/chloroallylation of alkynes is
Case Study of N-iPr versus N-Mes Substituted NHC Ligands in Nickel Chemistry: The Coordination and Cyclotrimerization of Alkynes at [Ni(NHC)2]
Tendera, Lukas,Helm, Moritz,Krahfuss, Mirjam J.,Kuntze-Fechner, Maximilian W.,Radius, Udo
supporting information, p. 17849 - 17861 (2021/11/17)
A case study on the effect of the employment of two different NHC ligands in complexes [Ni(NHC)2] (NHC=iPr2ImMe 1Me, Mes2Im 2) and their behavior towards alkynes is reported. The reaction of a mixture of [Ni2(iPr2ImMe)4(μ-(η2 : η2)-COD)] B/ [Ni(iPr2ImMe)2(η4-COD)] B’ or [Ni(Mes2Im)2] 2, respectively, with alkynes afforded complexes [Ni(NHC)2(η2-alkyne)] (NHC=iPr2ImMe: alkyne=MeC≡CMe 3, H7C3C≡CC3H7 4, PhC≡CPh 5, MeOOCC≡CCOOMe 6, Me3SiC≡CSiMe3 7, PhC≡CMe 8, HC≡CC3H7 9, HC≡CPh 10, HC≡C(p-Tol) 11, HC≡C(4-tBu-C6H4) 12, HC≡CCOOMe 13; NHC=Mes2Im: alkyne=MeC≡CMe 14, MeOOCC≡CCOOMe 15, PhC≡CMe 16, HC≡C(4-tBu-C6H4) 17, HC≡CCOOMe 18). Unusual rearrangement products 11 a and 12 a were identified for the complexes of the terminal alkynes HC≡C(p-Tol) and HC≡C(4-tBu-C6H4), 11 and 12, which were formed by addition of a C?H bond of one of the NHC N-iPr methyl groups to the C≡C triple bond of the coordinated alkyne. Complex 2 catalyzes the cyclotrimerization of 2-butyne, 4-octyne, diphenylacetylene, dimethyl acetylendicarboxylate, 1-pentyne, phenylacetylene and methyl propiolate at ambient conditions, whereas 1Me is not a good catalyst. The reaction of 2 with 2-butyne was monitored in some detail, which led to a mechanistic proposal for the cyclotrimerization at [Ni(NHC)2]. DFT calculations reveal that the differences between 1Me and 2 for alkyne cyclotrimerization lie in the energy profile of the initiation steps, which is very shallow for 2, and each step is associated with only a moderate energy change. The higher stability of 3 compared to 14 is attributed to a better electron transfer from the NHC to the metal to the alkyne ligand for the N-alkyl substituted NHC, to enhanced Ni-alkyne backbonding due to a smaller CNHC?Ni?CNHC bite angle, and to less steric repulsion of the smaller NHC iPr2ImMe.
Group 4 Diarylmetallocenes as Bespoke Aryne Precursors for Titanium-Catalyzed [2 + 2 + 2] Cycloaddition of Arynes and Alkynes
Reiner, Benjamin R.,Tonks, Ian A.
supporting information, p. 10508 - 10515 (2019/09/13)
Despite the ubiquity of reports describing titanium (Ti)-catalyzed [2 + 2 + 2] cyclotrimerization of alkynes, the incorporation of arynes into this potent manifold has never been reported. The in situ generation of arynes often requires fluoride, which instead will react with the highly fluorophilic Ti center, suppressing productive catalysis. Herein, we describe the use of group 4 diarylmetallocenes, CpR2MAr2 (CpR = C5H5, C5Me5; M = Ti, Zr), as aryne precursors for the Ti-catalyzed synthesis of substituted naphthalenes via coupling with 2 equiv of an alkyne. Fair-to-good yields of the desired naphthalene products could be obtained with 1% catalyst loadings, which is roughly an order of magnitude lower than similar reactions catalyzed by palladium or nickel. Additionally, naphthalenes find broad applications in the electronics, photovoltaics, and pharmaceutical industries, urging the discovery of more economic syntheses. These results indicate that aryne transfer from a CpR2M(?2-aryne) complex to another metal is a viable route for the introduction of aryne fragments into organometallic catalytic processes.
