267003-16-7Relevant academic research and scientific papers
Practical and highly selective sulfur ylide-mediated asymmetric epoxidations and aziridinations using a cheap and readily available chiral sulfide: Extensive studies to map out scope, limitations, and rationalization of diastereo- and enantioselectivities
Illa, Ona,Namutebi, Mariam,Saha, Chandreyee,Ostovar, Mehrnoosh,Chen, C. Chun,Haddow, Mairi F.,Nocquet-Thibault, Sophie,Lusi, Matteo,McGarrigle, Eoghan M.,Aggarwal, Varinder K.
supporting information, p. 11951 - 11966 (2013/09/02)
The chiral sulfide, isothiocineole, has been synthesized in one step from elemental sulfur, γ-terpinene, and limonene in 61% yield. A mechanism involving radical intermediates for this reaction is proposed based on experimental evidence. The application of isothiocineole to the asymmetric epoxidation of aldehydes and the aziridination of imines is described. Excellent enantioselectivities and diastereoselectivities have been obtained over a wide range of aromatic, aliphatic, and α,β-unsaturated aldehydes using simple protocols. In aziridinations, excellent enantioselectivities and good diastereoselectivities were obtained for a wide range of imines. Mechanistic models have been put forward to rationalize the high selectivities observed, which should enable the sulfide to be used with confidence in synthesis. In epoxidations, the degree of reversibility in betaine formation dominates both the diastereoselectivity and the enantioselectivity. Appropriate tuning of reaction conditions based on understanding the reaction mechanism enables high selectivities to be obtained in most cases. In aziridinations, betaine formation is nonreversible with semistabilized ylides and diastereoselectivities are determined in the betaine forming step and are more variable as a result.
A new protocol for the in situ generation of aromatic, heteroaromatic, and unsaturated diazo compounds and its application in catalytic and asymmetric epoxidation of carbonyl compounds. Extensive studies to map out scope and limitations, and rationalization of diastereo- and enantioselectivities
Aggarwal, Varinder K.,Alonso, Emma,Bae, Imhyuck,Hynd, George,Lydon, Kevin M.,Palmer, Matthew J.,Patel, Mamta,Porcelloni, Marina,Richardson, Jeffery,Stenson, Rachel A.,Studley, John R.,Vasse, Jean-Luc,Winn, Caroline L.
, p. 10926 - 10940 (2007/10/03)
A variety of metalated tosylhydrazone salts derived from benzaldehyde have been prepared and were reacted with benzaldehyde in the presence of tetrahydrothiophene (THT) (20 mol %) and Rh2(OAc)4 (1 mol %) to give stilbene oxide. Of the lithium, sodium, and potassium salts tested, the sodium salt was found to give the highest yield and selectivity. This study was extended to a wide variety of aromatic, heteroaromatic, aliphatic, α,β-unsaturated, and acetylenic aldehydes and to ketones. On the whole, high yields of epoxides with moderate to very high diastereoselectivities were observed. A broad range of tosylhydrazone salts derived from aromatic, heteroaromatic, and α,β-unsaturated rated aldehydes was also examined using the same protocol in reactions with benzaldehyde, and again, good yields and high diastereoselectivities were observed in most cases. Thus, a general process for the in situ generation of diazo compounds from tosylhydrazone sodium salts has been established and applied in sulfur-ylide mediated epoxidation reactions. The chiral, camphor-derived, [2.2.1] bicyclic sulfide 7 was employed (at 5-20 mol % loading) to render the above processes asymmetric with a range of carbonyl compounds and tosylhydrazone sodium salts. Benzaldehyde tosylhydrazone sodium salt gave enantioselectivities of 91 ± 3% ee and high levels of diastereoselectivity with a range of aldehydes. However, tosylhydrazone salts derived from a range of carbonyl compounds gave more variable selectivities. Although those salts derived from electron-rich or neutral aldehydes gave high enantioselectivities, those derived from electron-deficient or hindered aromatic aldehydes gave somewhat reduced enantioselectivities. Using α,β-unsaturated hydrazones, chiral sulfide 7 gave epoxides with high diastereoselectivities, but only moderate yields were achieved (12-56%) with varying degrees of enantioselectivity. A study of solvent effects showed that, while the impact on enantioselectivity was small, the efficiency of diazo compound generation was influenced, and CH3CN and 1,4-dioxane emerged as the optimum solvents. A general rationalization of the factors that influence both relative and absolute stereochemistry for all of the different substrates is provided. Reversibility in formation of the betaine intermediate is an important issue in the control of diastereoselectivity. Hence, where low diastereocontrol was observed, the results have been rationalized in terms of the factors that contribute to the reduced reversion of the syn betaine back to the original starting materials. The enantioselectivity is governed by ylide conformation, facial selectivity in the ylide reaction, and, again, the degree of reversibility in betaine formation. From experimental evidence and calculations, it has been shown that sulfide 7 gives almost complete control of facial selectivity, and, hence, it is the ylide conformation and degree of reversibility that are responsible for the enantioselectivity observed. A simple test has been developed to ascertain whether the reduced enantioselectivity observed in particular cases is due to poor control in ylide conformation or due to partial reversibility in the formation of the betaine.
Catalytic asymmetric synthesis of epoxides from aldehydes using sulfur ylides with in situ generation of diazocompounds
Aggarwal, Varinder K.,Alonso, Emma,Hynd, George,Lydon, Kevin M.,Palmer, Matthew J.,Porcelloni, Marina,Studley, John R.
, p. 1430 - 1433 (2007/10/03)
A practical, general, and convergent to epoxides with control of the relative and absolute stereochemistry has been achieved by generating the reactive intermediate (the diazo compound) in situ from tosylhydrazone salts (see scheme, PTC = phase-transfer catalyst, Ts = toluene-4-sulfonyl). High yields (58-82%), high d.r. (88:12-98:2), and high ee values (87-94%) have been obtained using a new class of stable chiral sulfides at low catalyst loading (5 mol%) and [Rh2(OAc)4] (0.5 mol%).
Pyridyl and furyl epoxides of more than 99% enantiomeric purities: The use of a phosphazene base
Solladie-Cavallo, Arlette,Roje, Marin,Isarno, Thomas,Sunjic, Vitomir,Vinkovic, Vladimir
, p. 1077 - 1080 (2007/10/03)
trans-1-(2-Pyridyl)-, trans-1-(3-pyridyl)-, trans-1(2-furyl)-, and trans-1(3-furyl)-2-phenyl epoxides with enantiomeric purities ranging from 96.8 to 99.8% [in favor of the (+, EtOH)-isomer] are obtained in two steps from pure (R,R,R)-oxathiane which is recovered (85-90%) and reused. The chiral bidentate ligand 2-phenyl-(S)-1-(2-pyridyl)ethanol with 99.6% ee was obtained in three steps and 67% overall isolated yield.
