7440-04-2 Usage
Description
Different sources of media describe the Description of 7440-04-2 differently. You can refer to the following data:
1. Osmium was discovered by English chemist Smithson Tennant in 1804. The element was named osmium after the Greek word, osme, which means a smell, because of the pungent and peculiar odor of its volatile oxide.
Osmium occurs in nature, always associated with other platinum group metals. It usually is found in lesser abundance than other noble metals. Its most important mineral is osmiridium (or iridosmine), a naturally occurring mineral alloyed with iridium.
The commercial applications of osmium are limited and considerably fewer than other platinum group metals. Its alloys are very hard and are used to make tips of fountain-pen nibs, phonograph needles, and pivots. The metal also exhibits effective catalytic properties in hydrogenation and other organic reactions. Such catalytic applications, however, are limited and osmium fails to replace other noble metals, particularly palladium and platinum, which are more effective as catalysts and cost less.
2. Osmium is silvery white, hard transition metals with a high melting point. osmium is one of the rarest elements on earth.
Chemical Properties
Different sources of media describe the Chemical Properties of 7440-04-2 differently. You can refer to the following data:
1. Osmium is a hard, brittle, bluishwhite metal with a BP of 5012 °C (Lide, 2006). It has the distinction of being the element in the PGE, which has the highest BP and lowest vapor pressure (Lide, 2006). Its physical characteristics make it difficult to manipulate; therefore, osmium is primarily used in the creation of alloys with other PGE, notably platinum and palladium.
2. Bluish-white lustrous metal; brittle and fairly hard; close-packed hexago- nal crystal system; density 22.48 g/cm3; Moh’s hardness 7.0; melts at about 3,050°C; vaporizes above 5,300°C; electrical resistivity 8.12 microhms-cm at 0°C; Young’s modulus 4.0x104 tons/in2; magnetic susceptibility 0.052x10–6 cm3/g; thermal neutron absorption coefficient 15 barns; insoluble in water; insoluble in HCl and H2SO4; slightly soluble in nitric acid and aqua regia; insoluble in ammonia; solubilized by fusion with caustic soda and sodium peroxide or caustic soda and potassium chlorate and the mass dissolved in water.
Physical properties
One of the important properties of osmium is the formation of gases when the metal isexposed to air. These fumes are extremely toxic, which limits osmium’s usefulness. Osmium is ahard, tough, brittle, bluish-white metal that is difficult to use except in a powder form that oxidizesinto osmium tetroxide (OsO4), which not only has objectionable odor but also is toxic.Osmium has a relatively high melting point of 3,054°C and a boiling point of 5,500°C,with a density of 22.61 g/cm3.
Isotopes
Osmium has 41 isotopes, five of which are stable. Two are naturally radioactiveisotopes with very long half-lives. Following are the stable isotopes and their contributionto the element’s natural existence in the Earth’s crust: Os-187 = 1.6%, Os-188 =13.29%, Os-189 = 16.21%, Os-190 = 26.36%, and Os-192 = 40.93%. The remain ing percentage of the element on Earth is in the form of the two naturally radioactiveisotopes: Os-184 = 0.02% and Os-186 = 1.59%. All the other isotopes of osmium areradioactive and artificially produced in nuclear reactors and particle accelerators.
Origin of Name
Its name is derived from the Greek word osme, meaning “odor” or
“smell,” because of the element’s objectionable smell when it is first isolated from platinum
ores using aqua regia.
Occurrence
Osmium is the 80th most abundant element on Earth. As a metal, it is not found free innature and is considered a companion metal with iridium. It is also found mixed with platinum-and nickel-bearing ores. It is recovered by treating the concentrated residue of these oreswith aqua regia (a mixture of 75% HCl and 25% HNO). The high cost of refining osmium ismade economically feasible by also recovering marketable amounts of platinum and nickel.Osmium occurs along with iridium in nature as the mineral iridosmine. It is found inCanada, Russia, and parts of Africa.
Characteristics
Osmium is found in group 8 (VIII) of the periodic table and has some of the same chemical,physical, and historical characteristics as several other elements. This group of similarelements is classed as the platinum group, which includes Ru, Rh, and Pd of the second transitionseries and Os, Ir, and Pt of the third series of transition metals .
History
Discovered in 1803 by Tennant in
the residue left when crude platinum is dissolved by aqua regia.
Osmium occurs in iridosmine and in platinum-bearing river sands of the Urals, North America, and South America.
It is also found in the nickel-bearing ores of the Sudbury,
Ontario, region along with other platinum metals. While the
quantity of platinum metals in these ores is very small, the
large tonnages of nickel ores processed make commercial recovery
possible. The metal is lustrous, bluish white, extremely
hard, and brittle even at high temperatures. It has the highest
melting point and the lowest vapor pressure of the platinum
group. The metal is very difficult to fabricate, but the powder
can be sintered in a hydrogen atmosphere at a temperature
of 2000°C. The solid metal is not affected by air at room temperature,
but the powdered or spongy metal slowly gives off
osmium tetroxide, which is a powerful oxidizing agent and has
a strong smell. The tetroxide is highly toxic, and boils at 130°C
(760 mm). Concentrations in air as low as 10–7 g/m3 can cause
lung congestion, skin damage, or eye damage. The tetroxide
has been used to detect fingerprints and to stain fatty tissue
for microscope slides. The metal is almost entirely used to
produce very hard alloys, with other metals of the platinum
group, for fountain pen tips, instrument pivots, phonograph
needles, and electrical contacts. The price of 99.9% pure osmium
powder — the form usually supplied commercially — is
about $100/g, depending on quantity and supplier. Natural
osmium contains seven isotopes, one of which, 186Os, is radioactive
with a very long half-life. Thirty-four other isotopes
and isomers are known, all of which are radioactive. The measured
densities of iridium and osmium seem to indicate that
osmium is slightly more dense than iridium, so osmium has
generally been credited with being the heaviest known element.
Calculations of the density from the space lattice, which
may be more reliable for these elements than actual measurements,
however, give a density of 22.65 for iridium compared
to 22.61 for osmium. At present, therefore, we know either
iridium or osmium is the heaviest element, but the data do not
allow selection between the two.
Uses
Different sources of media describe the Uses of 7440-04-2 differently. You can refer to the following data:
1. Because of its hard brittle nature, the metal osmium has few uses. However, the powderedform can be sintered under high pressure and temperatures to form some useful products,despite its toxicity and malodor. Its main use is as an alloy to manufacture devices that resistwear and stand up to constant use. As an alloy, osmium loses both its foul odor and toxicity.Some of these products are ballpoint and fountain pen tips, needles for record players, andpivot points for compass needles. Osmium alloys are also used for contact points on specialswitches and other devices that require reduced frictional wear. Another use is as a stain for animal tissues that are to be examined with a microscope toimprove the contrast of the specimen.
2. Osmium, plasma standard solution is used as a standard solution in analytical chemistry and atomic absorption spectroscopy. It is also used as a single-element standard solution for plasma emission spectrometry.
Production Methods
Osmium is obtained in the reaction of osmium tetroxide
(OsO4) reduction with carbon at red heat temperature.
Osmium is also obtained from osmiridium. After separation
from other metals with aqua regia, osmiridium is distilled
in chlorine stream with formation of osmium tetrachloride
(OsCl4), from which the metal is recovered by
reduction.
Definition
Different sources of media describe the Definition of 7440-04-2 differently. You can refer to the following data:
1. A transition metal that is found associated with platinum. Osmium is the most dense of all metals. It has a characteristic smell resulting from the production of osmium(VIII) oxide (osmium tetroxide, OsO4). The metal is used in catalysts and in alloys for pen nibs, pivots, and electrical contacts. Symbol: Os; m.p. 3054°C; b.p. 5027°C; r.d. 22.59 (20°C); p.n. 76; r.a.m. 190.23.
2. osmium: Symbol Os. A hard bluewhitemetallic transition element;a.n. 76; r.a.m. 190.2; r.d. 22.57; m.p.3045°C; b.p. 5027°C. It is found associatedwith platinum and is used incertain alloys with platinum and iridium(see osmiridium). Osmium formsa number of complexes in a range ofoxidation states. It was discovered bySmithson Tennant (1761–1815) in1804.
Hazard
Most of the oxides of osmium are not noxious, but are toxic if inhaled or ingested. Thecompound OsO4 is extremely poisonous. It is a powerful oxidizing agent that is soluble inwater and will produce serious burns in skin as it oxidizes the various layers of tissues.
Industrial uses
A platinum-group metal, osmium is noted for its high hardness, about 400 Brinell. The heaviest known metal, it has a high specific gravity, 22.65, and a high melting point, 2698 C. The boiling point is about 5468 C. Osmium has a close-packed hexagonal crystal structure, and forms solid-solution alloys with platinum, having more than double the hardening power of iridium in platinum. However, it is seldom used to replace iridium as a hardener except for fountain-pen tips where the alloy is called osmiridium. Osmium is not affected by the common acids, and is not dissolved by aqua regia. It is practically unworkable, and its chief use is as a catalyst. Osmium tetraoxide, a commercially available yellow solid (melting point 40 C) is used commercially as a stain for tissue in microscopy. It is poisonous and attacks the eyes. Osmium metal is catalytically active, but it is not commonly used for this purpose because of its high price. Osmium and its alloys are hard and resistant to corrosion and wear (particularly to rubbing wear). Alloyed with other platinum metals, osmium has been used in needles for record players, fountain-pen tips, and mechanical parts.
Safety Profile
Poison by intravenous route. An irritant to eyes and mucous membranes. The principal effects of exposure are ocular disturbances and an asthmatic condition caused by inhalation. Furthermore, it causes dermatitis and ulceration of the skin upon contact. When osmium is heated, it gives off a pungent, poisonous fume of osmium tetroxide. One case of osmium poisoning reported in the literature resulted from the inhalation of osmium, which gave rise to a capillary bronchitis and dermatitis. The tetroxide vapor has a pronounced and nauseating odor that should be taken as a warning of a possibly toxic concentration in the atmosphere, and personnel should immedately move to an area of fresh air. The metal itself is not highly toxic. Flammable in the form of dust when exposed to heat or flame. Slight explosion hazard in the form of dust when exposed to heat or flame. Violent reaction or ignition with chlorine trichloride or oxygen dfluoride. Ignites when heated to l00℃ with fluorine. Incandescent reaction in phosphorus vapor. When heated to decomposition it emits toxic fumes of 0s04. See also OSMIUM TETROXIDE
Check Digit Verification of cas no
The CAS Registry Mumber 7440-04-2 includes 7 digits separated into 3 groups by hyphens. The first part of the number,starting from the left, has 4 digits, 7,4,4 and 0 respectively; the second part has 2 digits, 0 and 4 respectively.
Calculate Digit Verification of CAS Registry Number 7440-04:
(6*7)+(5*4)+(4*4)+(3*0)+(2*0)+(1*4)=82
82 % 10 = 2
So 7440-04-2 is a valid CAS Registry Number.
InChI:InChI=1/Os
