67662-96-8Relevant articles and documents
Kinetic Analysis as an Optimization Tool for Catalytic Esterification with a Moisture-Tolerant Zirconium Complex
Dalla-Santa, Oscar,Lundberg, Helena,Szabó, Zoltán,Villo, Piret
, p. 6959 - 6969 (2020/06/27)
This work describes the use of kinetics as a tool for rational optimization of an esterification process with down to equimolar ratios of reagents using a recyclable commercially available zirconocene complex in catalytic amounts. In contrast to previously reported group IV metal-catalyzed esterification protocols, the work presented herein circumvents the use of water scavengers and perfluorooctane sulfonate (PFOS) ligands. Insights into the operating mechanism are presented.
Exploring the catalytic activity of Lewis-acidic uranyl complexes in the nucleophilic acyl substitution of acid anhydrides
Takao, Koichiro,Akashi, Shin
, p. 12201 - 12207 (2017/03/08)
The catalytic activities of several uranyl complexes, such as N,N′-disalicylidene-o-phenelyenediaminato(ethanol)dioxouranium(vi) (UO2(salophen)EtOH), bis(dibenzoylmethanato)(ethanol)dioxouranium(vi) (UO2(dbm)2EtOH), pentakis(N,N-dimethylformamide)dioxouranium(vi) ([UO2(DMF)5]2+), and tetrakis(triphenylphosphine oxide)dioxouranium(vi) ([UO2(OPPh3)4]2+), were examined in the nucleophilic acyl substitution of acid anhydrides. Among them, [UO2(OPPh3)4]2+ was the most efficient to give ethyl acetate and acetic acid from acetic anhydride (Ac2O) and ethanol, and was resistant towards decomposition during the catalytic reaction. Several nucleophiles were also subjected to the catalytic acylation reaction using acetic and pivalic anhydride. Kinetic and spectroscopic studies suggested that [UO2(OPPh3)4]2+ interacts with Ac2O to form [UO2(Ac2O)(OPPh3)3]2+. Interaction of this actual catalyst with additional Ac2O determines the rate of the overall nucleophilic acyl substitution reaction.
Efficient O-Acylation of Alcohols and Phenol Using Cp2TiCl as a Reaction Promoter
Durán-Pe?a, María Jesús,Botubol-Ares, José Manuel,Hanson, James R.,Hernández-Galán, Rosario,Collado, Isidro G.
supporting information, p. 3584 - 3591 (2016/07/28)
A method has been developed for the conversion of primary, secondary, and tertiary alcohols, and phenol, into the corresponding esters at room temperature. The method uses a titanium(III) species generated from a substoichiometric amount of titanocene dichloride together with manganese(0) as a reductant, as well as methylene diiodide. It involves a transesterification from an ethyl ester, or a reaction with an acyl chloride. A radical mechanism is proposed for these transformations.
Direct esterification of carboxylic acids with alcohols catalyzed by Iron(III) acetylacetonate complex
Weng, Shiue-Shien,Chen, Fong-Kuang,Ke, Chih-Shueh
, p. 2615 - 2621 (2013/07/26)
Direct condensation of carboxylic acids and alcohols with electronic, steric, and functional group variations was carried out using the environmentally benign, moisture-stable, inexpensive, and recoverable iron(III) acetylacetonate [Fe(acac)3] as catalyst (5 mol%). This iron salt efficiently catalyzed the esterification of several primary and secondary alcohols in refluxing xylene, without the need for a dehydration reagent. The chemoselectivity of the proposed protocol was demonstrated by the selective esterification of primary alcohol functionality in racemic 1-phenylethane-1,2- diol with benzoic acid. The esterification was also applicable to unmasked α-hydroxyacid, guasiaromatic, heterocyclic, and N-protected amino acids. Supplemental materials are available for this article. Go to the publisher's online edition of Synthetic Communications to view the free supplemental file.
Pentafluorophenylammonium triflate as a mild and new organocatalyst for acylation of alcohols, phenols, and amines under solvent-free condition
Khaksar, Samad,Zakeri, Hasan
, p. 576 - 579,4 (2020/08/31)
A simple, inexpensive, environmentally friendly and efficient route for the acylation of a number of alcohols, phenols and amines using pentafluorophenylammonium triflate (PFPAT) as a catalyst is described. PFPAT organocatalyst is air-stable, cost-effective, easy to handle, and easily removed from the reaction mixtures.
Transesterification catalyzed by iron(III) β-diketonate species
Weng, Shiue-Shien,Ke, Chih-Shueh,Chen, Fong-Kuang,Lyu, You-Fu,Lin, Guan-Ying
experimental part, p. 1640 - 1648 (2011/04/17)
A practical and clean protocol for transesterification catalyzed by a 5 mol % cheap, non-toxic and moisture stable Fe(acac)3 or other iron(III) β-diketonate species in solvent, such as heptane under azeotropic condition is developed. A remarkable rate enhancement was observed upon the addition of 5 mol % of an inorganic base, such as Na2CO3, which suggests that faster formation of a dimeric μ-alkoxy-bridged iron(III) species under alkaline conditions facilitates catalytic turnover. This system provides smooth transesterification over a wide range of structurally diverse esters and alcohols without disturbing functional groups. In addition, the use of iron β-diketonate complexes as catalysts is more environmentally friendly, safer, and economical than other transition-metal catalysts. Preliminary mechanistic studies indicate that the active catalyst is likely a dimeric μ-alkoxy-bridged iron(III) species, as determined by X-ray crystallography of [Fe(dbm)2(O-n-Bu)]2 derived from the alcoholysis of Fe(dbm)3 under alkaline conditions.
Air-stable titanocene bis(perfluorooctanesulfonate) as a new catalyst for acylation of alcohols, phenols, thiols, and amines under solvent-free condition
Qiu, Renhua,Zhang, Guoping,Ren, Xiaofang,Xu, Xinhua,Yang, Ronghua,Luo, Shenglian,Yin, Shuangfeng
experimental part, p. 1182 - 1188 (2010/06/13)
Air-stable titanocene bis(perfluorooctanesulfonate) [Cp2Ti(OSO2C8F17)2] that shows high Lewis acidity was prepared from Cp2TiCl2 and AgOSO2C8F17. The compound was characterized by different techniques, and examined as a catalyst for acylation reactions. It was found that using equimolar acetic anhydride as acetylating agent and under solvent-free condition, Cp2Ti(OSO2C8F17)2 exhibits high activity and selectivity in the acetylation of various alcohols, phenols, thiols, and amines. Also, good catalytic efficiency is observed in the acylation of 2-phenylethanol across various acylating reagents. The catalyst can be reused without loss of activity in a test of ten cycles. The Cp2Ti(OSO2C8F17)2 catalyst affords a simple, efficient and general method for the acylation of alcohols, phenols, thiols, and amines.
An efficient protocol for alcohol protection under solvent- and catalyst-free conditions
Rao, Ch. Bhujanga,Chinnababu,Venkateswarlu
supporting information; experimental part, p. 8856 - 8858 (2010/02/17)
(Chemical Equation Presented) Asimple and highly efficient protocol for pivaloylation of alcohols without using a catalyst under solvent-free conditions has been developed. The key advantages of the reaction are short reaction time, high yields, simple workup, and no need for further purification. Selectivity was observed between primary alcohols vs. secondary alcohols and aliphatic alcohols vs. aromatic alcohols. The accentuated and relevant phenomenon of this method that we observed is in one-pot conversion of TBS protection into Piv protection of the hydroxyl group. 2009 American Chemical Society.
Synthesis of chloroesters by the cleavage of cyclic and acyclic ethers using La(NO3)3·6H2O as a mild and efficient catalyst under solvent-free conditions
Suresh,Suryakiran,Rajesh,Selvam, J. Jon Paul,Srinivasulu,Venkateswarlu
, p. 92 - 99 (2008/03/14)
A mild and an efficient synthesis of chloroesters is described by the reaction of cyclic and acyclic ethers with acid chlorides in the presence of a catalytic amount of La(NO3)3·6H2O under solvent-free conditions, affording the corresponding chloroesters in excellent yields. Copyright Taylor & Francis Group, LLC.
Cl3CCONH2/PPh3: A versatile reagent for synthesis of esters
Chantarasriwong, Oraphin,Jang, Doo Ok,Chavasiri, Warinthorn
scheme or table, p. 2845 - 2856 (2009/04/11)
Cl3CCONH2/PPh3 was a versatile reagent to convert carboxylic acids into their corresponding acid chlorides. This intermediate was clearly confirmed by spectroscopic methods (IR, 1H, 13C NMR). This one-pot reaction of in situ acid chloride generated with various alcohols successfully furnished the corresponding esters in moderate to excellent yields. Copyright ? Taylor & Francis Group, LLC.
