10264-25-2Relevant articles and documents
Polyamide synthesis from 6-aminocapronitrile, part 2: Heterogeneously catalyzed nitrile hydrolysis with consecutive amine amidation
Van Dijk, Adrianus J.M.,Duchateau, Robbert,Hensen, Emiel J.M.,Meuldijk, Jan,Koning, Cor E.
, p. 7673 - 7681 (2007)
To test the potential of heterogeneous catalysts for the nylon-6 synthesis from 6-aminocapronitrile, a number of zeolites, aluminum silicate, and metal oxides were tested as catalysts for the model reaction of pentanenitrile with water and hexylamine to N-hexylpentanamide. All zeolitic and aluminum silicate systems showed an insufficient performance, while the metal oxides (TiO 2, ZrO2, Nb2O5) showed very promising results. The kinetic behavior of the metal oxides was further investigated. First the nitrile was catalytically hydrolyzed to the terminal amide and subsequently the amidation of the hexylamine occurred. To polymerize 6-aminocapronitrile into nylon-6, more than 99% nitrile conversion was required to obtain a high-molecular-weight polymer. Pentanenitrile conversions larger than 99% can be obtained within six hours, at 230°C, by using ZrO 2 as the catalyst. A kinetic study (by using IR spectroscopy) on the behavior of the metal oxides demonstrated that the adsorbed nitrile was catalytically hydrolyzed at the surface, but remained tightly bound to the surface. Zirconia-catalyzed polymerizations of 6-amino-capronitrile demonstrated that high-molecular-weight nylon-6 is feasible by using this route.
Polyamide synthesis from 6-aminocapronitrile, part 1: N-alkyl amide formation by amine amidation of a hydrolyzed nitrile
Van Dijk, Adrianus J.M.,Heyligen, Tom,Duchateau, Robbert,Meuldijk, Jan,Koning, Cor E.
, p. 7664 - 7672 (2007)
The synthesis of N-hexylpentanamide from a stoichiometric amount of pentanenitrile and hexylamine has been studied as a model reaction for the synthesis of nylon-6 from 6-aminocapronitrile. The reaction was carried out under mild hydrothermal conditions and in the presence of a homogeneous ruthenium catalyst. For the mild hydrothermal conditions the presence of hexylamine distinctively increases the nitrile hydrolysis compared to the nitrile hydrolysis in the absence of hexylamine. Amine-catalyzed nitrile hydrolysis mainly produces the N-substituted amide. A clear product development is observed, consisting of first the terminal amide formation and second the accumulation of N-hexylpentanamide. With a maximum conversion of only 80 % after 18 h, the nitrile hydrolysis rate at 230°C is still much too low for nylon-6 synthesis. Ruthenium dihydride phosphine was therefore used as a homogeneous catalyst, which significantly increases the nitrile hydrolysis rate. At a temperature of 140°C and with only 0.5 mol% [RuH2-(PPh 3)4]a 60% nitrile conversion is already reached within 2 h. Initially the terminal amide is the sole product, which is gradually converted into N-hexylpentanamide. The reaction has a high initial rate, however, for higher conversions a strong decrease in hydrolysis rate is observed. This is ascribed to product inhibition, which results from the equilibrium nature of the reaction.
N-Acyl-N-(4-chlorophenyl)-4-nitrobenzenesulfonamides: Highly selective and efficient reagents for acylation of amines in water
Ebrahimi, Sara,Saiadi, Safoura,Dakhilpour, Simin,Mirsattari, Seyed Nezamoddin,Massah, Ahmad Reza
, p. 95 - 104 (2016/04/26)
A variety of N-acyl-N-(4-chlorophenyl)-4-nitrobenzenesulfonamides (1a-e) were synthesized in one pot from 4-chloroaniline under solvent-free conditions and have been developed as chemoselective N-acylation reagents. Selective protection of primary amines in the presence of secondary amines, acylation of aliphatic amines in the presence of aryl amines, and monofunctionalization of primary-secondary diamines as well as selective N-acylation of amino alcohols using these reagents are described. All of the acylation reactions were carried out in water as a green solvent. High stability and easy preparation of these acylating reagents are other advantages of this method.
Chemo- and regioselective homogeneous rhodium-catalyzed hydroamidomethylation of terminal alkenes to N-alkylamides
Raoufmoghaddam, Saeed,Drent, Eite,Bouwman, Elisabeth
, p. 1759 - 1773 (2013/10/21)
A rhodium/xantphos homogeneous catalyst system has been developed for direct chemo- and regioselective mono-N-alkylation of primary amides with 1-alkenes and syngas through catalytic hydroamidomethylation with 1-pentene and acetamide as model substrates. For appropriate catalyst performance, it appears to be essential that catalytic amounts of a strong acid promoter, such as p-toluenesulfonic acid (HOTs), as well as larger amounts of a weakly acidic protic promoter, particularly hexafluoroisopropyl alcohol (HORF) are applied. Apart from the product N-1-hexylacetamide, the isomeric unsaturated intermediates, hexanol and higher mass byproducts, as well as the corresponding isomeric branched products, can be formed. Under optimized conditions, almost full alkene conversion can be achieved with more than 80 % selectivity to the product N-1-hexylamide. Interestingly, in the presence of a relatively high concentration of HORF, the same catalyst system shows a remarkably high selectivity for the formation of hexanol from 1-pentene with syngas, thus presenting a unique example of a selective rhodium-catalyzed hydroformylation-hydrogenation tandem reaction under mild conditions. Time-dependent product formation during hydroamidomethylation batch experiments provides evidence for aldehyde and unsaturated intermediates; this clearly indicates the three-step hydroformylation/condensation/hydrogenation reaction sequence that takes place in hydroamidomethylation. One likely role of the weakly acidic protic promoter, HORF, in combination with the strong acid HOTs, is to establish a dual-functionality rhodium catalyst system comprised of a neutral rhodium(I) hydroformylation catalyst species and a cationic rhodium(III) complex capable of selectively reducing the imide and/or ene-amide intermediates that are in a dynamic, acid-catalyzed condensation equilibrium with the aldehyde and amide in a syngas environment. Taking control: A rhodium/xantphos homogeneous catalyst system has been developed for direct chemo- and regioselective mono-N-alkylation of primary amides with 1-alkenes and syngas through the new catalytic hydroamidomethylation reaction (see picture). Copyright