153221-21-7

Usage

InChI:InChI=1/C13H17NO2/c1-9(15)14-11-7-6-10-4-3-5-13(16-2)12(10)8-11/h3-5,11H,6-8H2,1-2H3,(H,14,15)

Upstream product

• 108-24-7 acetic anhydride 
• 3880-76-0 8-Methoxy-(2R)-2-amino-1,2,3,4-tetrahydronaphthalene hydrochloride 
• 80270-68-4 N-(1,2,3,4-tetrahydro,8-methoxy-2-naphthalenyl)-acetamide 
• 5309-19-3 8-methoxy-2-tetralone 
• 1426931-42-1 N-(8-methoxy-3,4-dihydronaphthalen-2-yl)acetamide 
• 593-56-6 N-methoxylamine hydrochloride 
• 3880-77-1 8-methoxy-2-aminotetralin 
• 75-36-5 acetyl chloride 

Downstream Products

• 81998-18-7 1,2,3,4-tetrahydro-8-methoxy-5-(methylthio)-2-naphthalenamine 

Relevant academic research and scientific papers

Synthesis of 2-amido-2,3-dihydro-1H-phenalene derivatives as new conformationally restricted ligands for melatonin receptors

Tetrahydroanthracene, tetrahydrophenanthrene, and tetrahydrophenalene moieties were used to design novel constrained melatoninergic agents. Compounds 1 and 2 were synthesized from the cyclization of the aryl succinic acids 6a,b followed by catalytic reduction, Curtius degradation to the amino derivatives, and acetylation. The phenalene derivatives 3 were prepared by cyclization of the aza lactones of the corresponding α-N-acetyl amino acids. The ketone derivatives were reduced directly by catalytic hydrogenation to produce the compounds 3. The different compounds were evaluated in vitro in binding assays using 2-[125I]iodomelatonin and chicken brain membranes. Melatonin and 2-acetamido-8-methoxytetralin were used as the reference compounds. The results showed the superiority of the dihydrophenalene framework 3 over those of tetrahydroanthracene and tetrahydrophenanthrene. 3a had relatively good affinity for melatonin receptors (K(i) = 28.7 nM). Introduction of an additional methoxy group gave a derivative (3c) with nanomolar affinity (K(i) = 0.7 nM), confirming the existence of a secondary binding site in the receptor which has been described previously. An increase in the affinity was also observed with the propionamido derivative 3e (K(i) = 6.0 nM). The potential agonist properties of the compound 3e were evaluated on the dermal melanocytes of Xenopus laevis tadpoles. At the concentration of 2.3 nM (5 x K(i)), melatonin gave a melanophore index value of 1. Similarly to melatonin, 3e was shown to be a potent agonist of the melanosome aggregation.

Phosphite-Thiother Ligands Derived from Carbohydrates allow the Enantioswitchable Hydrogenation of Cyclic β-Enamides by using either Rh or Ir Catalysts

Phosphite-thioether ligands with a simple modular architecture, derived from inexpensive l-(+)-tartaric acid and d-mannitol, have been for the first time successfully applied (ee values up to 99 %) in the synthesis of 2-aminotetralines and 3-aminochromane

Indene Derived Phosphorus-Thioether Ligands for the Ir-Catalyzed Asymmetric Hydrogenation of Olefins with Diverse Substitution Patterns and Different Functional Groups

A family of phosphite/phosphinite-thioether ligands have been tested in the Ir-catalyzed asymmetric hydrogenation of a range of olefins (50 substrates in total). The presented ligands are synthesized in three steps from cheap indene and they are air-stable solids. Their modular architecture has been crucial to maximize the catalytic performance for each type of substrate. Improving most Ir-catalysts reported so far, this ligand family presents a broader substrate scope, covering different substitution patterns with different functional groups, ranging from unfunctionalized olefins, through olefins with poorly coordinative groups, to olefins with coordinative functional groups. α,β-Unsaturated acyclic and cyclic esters, ketones and amides werehydrogenated in enantioselectivities ranging from 83 to 99% ee. Enantioselectivities ranging from 91 to 98% ee were also achieved for challenging substrates such as unfunctionalized 1,1′-disubstituted olefins, functionalized tri- and 1,1′-disubstituted vinyl phosphonates, and β-cyclic enamides. The catalytic performance of the Ir-ligand assemblies was maintained when the environmentally benign 1,2-propylene carbonate was used as solvent. (Figure presented.).

Density Functional Theory-Inspired Design of Ir/P,S-Catalysts for Asymmetric Hydrogenation of Olefins

In silico-based optimization of Ir/P,S-catalysts for the asymmetric hydrogenation of unfunctionalized olefins using (E)-1-(but-2-en-2-yl)-4-methoxybenzene as a benchmark olefin has been carried out. DFT calculations revealed that the thioether group has a major role in directing the olefin coordination. This, together with the configuration of the biphenyl phosphite group, has an impact in maximizing the energy gap between the most stable transition states leading to opposite enantiomers. As a result, the optimized catalyst proved to be efficient in the hydrogenation of a range of alkenes with the same substitution pattern and olefin geometry as the benchmark olefin, regardless of the presence of functional groups with different coordination abilities (ee values up to 97%). Appealingly, further modifications at the thioether groups and at the biaryl phosphite moiety allowed the highly enantioselective hydrogenation of olefins with different substitution patterns (e.g., α,β-unsaturated lactones and lactams, 1,1′-disubstituted enol phosphinates, and cyclic β-enamides; ee values up to >99%).

Ir/Thioether-Carbene, -Phosphinite, and -Phosphite Complexes for Asymmetric Hydrogenation. A Case for Comparison

We studied for the first time the potential of novel and simple Ir/thioether-NHC complexes in the asymmetric hydrogenation of unfunctionalized olefins and cyclic β-enamides. For comparison, we prepared and applied the analogues thioether-phosphinite/phosphite complexes. We found that the efficiency of the new Ir/thioether-NHC catalyst precursors varies with the type of olefin. Thus, while the Ir/thioether-NHC catalyst precursors provided lower catalytic performance than their related Ir/thioether-P complexes in the hydrogenation of olefins lacking a coordinating group, the catalysts had similar good performance for the reduction of functionalized olefins (e.g., tri- and disubstituted enol phosphonate derivatives). Catalytic results together with the studies of the reactivity toward H2 indicated that the thioether-carbene design favors the formation of inactive trinuclear species, which are responsible for the low activities obtained with these carbene-type catalysts. Nevertheless, this catalyst deactivation can be avoided by using functionalized olefins such as enol phosphonates. We also report the discovery of simple-to-synthesize Ir/thioether-P catalysts containing a simple backbone that gave high enantioselectivities for some trisubstituted olefins, some challenging 1,1′-disubstituted olefins, and cyclic β-enamides.

Asymmetric Hydrogenation of Disubstituted, Trisubstituted, and Tetrasubstituted Minimally Functionalized Olefins and Cyclic β-Enamides with Easily Accessible Ir-P,Oxazoline Catalysts

We have developed a family of Ir-P,oxazoline catalysts for asymmetric hydrogenation. These catalysts, with a simple modular architecture, have shown a high tolerance to the olefin geometry and substitution pattern, and to the presence of several neighboring polar groups. Thus, they were able to successfully hydrogenate disubstituted, trisubstituted, and tetrasubstituted minimally functionalized olefins (with enantiomeric excess values up to 99%). The excellent catalytic performance was also extended to the hydrogenation of cyclic β-enamides.

Alternatives to Phosphinooxazoline (t-BuPHOX) Ligands in the Metal-Catalyzed Hydrogenation of Minimally Functionalized Olefins and Cyclic β-Enamides

This study presents a new series of readily accessible iridium- and rhodium-phosphite/oxazoline catalytic systems that can efficiently hydrogenate, for the first time, both minimally functionalized olefins and functionalized olefins (62 examples in total) in high enantioselectivities (ees up to >99%) and conversions. The phosphite-oxazoline ligands, which are readily available in only two synthetic steps, are derived from previous privileged 4-alkyl-2-[2-(diphenylphosphino)phenyl]-2-oxazoline (PHOX) ligands by replacing the phosphine moiety by a biaryl phosphite group and/or the introduction of a methylene spacer between the oxazoline and the phenyl ring. The modular design of the ligands has given us the opportunity not only to overcome the limitations of the iridium-PHOX catalytic systems in the hydrogenation of minimally functionalized Z-olefins and 1,1-disubstituted olefins, but also to expand their use to unfunctionalized olefins containing other challenging scaffolds (e.g., exocyclic benzofused and triaryl-substituted olefins) and also to olefins with poorly coordinative groups (e.g., α,β-unsaturated lactams, lactones, alkenylboronic esters, etc.) with enantioselectivities typically >95% ee. Moreover, both enantiomers of the hydrogenation product could be obtained by simply changing the configuration of the biaryl phosphite moiety. Remarkably, the new catalytic systems also provided excellent enantioselectivities (up to 99% ee) in the asymmetric hydrogenation of another challenging class of olefins – the functionalized cyclic β-enamides. Again, both enantiomers of the reduced amides could be obtained by changing the metal from Ir to Rh. We also demonstrated that environmentally friendly propylene carbonate can be used with no loss of enantioselectivity. Another advantage of the new ligands over the PHOX ligands is that the best ligands are derived from the affordable (S)-phenylglycinol rather than from the expensive (S)-tert-leucinol. (Figure presented.).

Highly Enantioselective Iridium-Catalyzed Hydrogenation of Cyclic Enamides

The MaxPHOX–Ir catalyst system provided the highest selectivity ever reported for the reduction of cyclic enamides derived from α- and β-tetralones. This result indicates that iridium catalysts are also proficient in reducing alkenes bearing metal-coordinating groups. In the present system, selectivity was pressure-dependent: In most cases, a decrease in the H2pressure to 3 bar resulted in an increase in enantioselectivity. Moreover, the process can be carried out in environmentally friendly solvents, such as methanol and ethyl acetate, with no loss of selectivity.

PHOX-Based Phosphite-Oxazoline Ligands for the Enantioselective Ir-Catalyzed Hydrogenation of Cyclic Β-Enamides

Simple Ir-PHOX-based phosphite-oxazoline catalysts have been successfully applied in the asymmetric hydrogenation of cyclic β-enamides providing better enantioselectivities than previous effective Ru and Rh catalysts. This protocol allows the synthesis of

Asymmetric hydrogenation reactions with Rh and Ru complexes bearing phosphine-phosphites with an oxymethylene backbone

Phosphine-phosphites 3a and 3b, derived from diphenylhydroxymethyl phosphine have been prepared. From these ligands [Rh(COD)(3a)]BF4 5a and RuCl2(3b)[(S,S)-DPEN] 6b (DPEN = 1,2-diphenylethylenediamine) were synthesized and their stru