1654-87-1

Upstream product

• 98-82-8 Isopropylbenzene 
• 26581-25-9 trans-octahydro-[4a]naphthyl hydroperoxide 
• 493-01-6 cis-decalin 
• 76402-75-0 (+/-)-2-(4'-iodobutyl)cyclohexanone 
• 493-02-7 trans-Decalin 
• 10028-15-6 ozone 
• 91-17-8 decalin 
• 87307-15-1 6-bromocyclododecanone 
• 694-59-7 pyridine N-oxide 

Downstream Products

• 26581-25-9 trans-octahydro-[4a]naphthyl hydroperoxide 
• 51953-08-3 2-(4-bromo-butyl)-cyclohexanone 
• 87307-15-1 6-bromocyclododecanone 
• 76402-75-0 (+/-)-2-(4'-iodobutyl)cyclohexanone 
• 1126-18-7 2-butylcyclohexanone 
• 1502-06-3 cyclodecanone 

Relevant academic research and scientific papers

Ozonation of decalin as a model saturated cyclic molecule: A spectroscopic study

Ozonolysis is used for oxidation of a model cyclic molecule-decalin, which may be consid-ered as an analog of saturated cyclic molecules present in heavy oil. The conversion of decalin exceeds 50% with the highest yield of formation of acids about 15–17%. Carboxylic acids, ketones/aldehydes, and alcohols are produced as intermediate products. The methods of UV-visible, transmission IR, at-tenuated total reflection IR-spectroscopy, NMR and mass-spectrometry were used to identify reaction products and unravel a possible reaction mechanism. The key stage of the process is undoubtedly the activation of the first C-H bond and the formation of peroxide radicals.

Enhancing Chemo- And Stereoselectivity in C-H Bond Oxygenation with H2O2by Nonheme High-Spin Iron Catalysts- And Role of Lewis Acid and Multimetal Centers

Spin states of iron often direct the selectivity in oxidation catalysis by iron complexes using hydrogen peroxide (H2O2) on an oxidant. While low-spin iron(III) hydroperoxides display stereoselective C-H bond hydroxylation, the reactions are nonstereoselective with high-spin iron(II) catalysts. The catalytic studies with a series of high-spin iron(II) complexes of N4 ligands with H2O2 and Sc3+ reported here reveal that the Lewis acid promotes catalytic C-H bond hydroxylation with high chemo- and stereoselectivity. This reactivity pattern is observed with iron(II) complexes containing two cis-labile sites. The enhanced selectivity for C-H bond hydroxylation catalyzed by the high-spin iron(II) complexes in the presence of Sc3+ parallels that of the low-spin iron catalysts. Furthermore, the introduction of multimetal centers enhances the activity and selectivity of the iron catalyst. The study provides insights into the development of peroxide-dependent bioinspired catalysts for the selective oxygenation of C-H bonds without the restriction of using iron complexes of strong-field ligands.

Iron Complex Catalyzed Selective C-H Bond Oxidation with Broad Substrate Scope

The use of a peroxidase-mimicking Fe complex has been reported on the basis of the biuret-modified TAML macrocyclic ligand framework (Fe-bTAML) as a catalyst to perform selective oxidation of unactivated 3° C-H bonds and activated 2° C-H bonds with low catalyst loading (1 mol %) and high product yield (excellent mass balance) under near-neutral conditions and broad substrate scope (18 substrates which includes arenes, heteroaromatics, and polar functional groups). Aliphatic C-H oxidation of 3° and 2° sites of complex substrates was achieved with predictable selectivity using steric, electronic, and stereoelectronic rules that govern site selectivity, which included oxidation of (+)-artemisinin to (+)-10β-hydroxyartemisinin. Mechanistic studies indicate FeV(O) to be the active oxidant during these reactions.

Alkane oxidation catalysed by a self-folded multi-iron complex

A preorganised ligand scaffold is capable of coordinating multiple Fe(II) centres to form an electrophilic CH oxidation catalyst. This catalyst oxidises unactivated hydrocarbons including simple, linear alkanes under mild conditions in good yields with selectivity for the oxidation of secondary CH bonds. Control complexes containing a single metal centre are incapable of oxidising unstrained linear hydrocarbons, indicating that participation of multiple centres aids the CH oxidation of challenging substrates.

Selective activation of secondary C-H bonds by an iron catalyst: Insights into possibilities created by the use of a carboxyl-containing bipyridine ligand

In this work, we report the discovery of a carboxyl-containing iron catalyst 1 (FeII-DCBPY, DCBPY = 2,2′-bipyridine-4,4′- dicarboxylic acid), which could activate the C-H bonds of cycloalkanes with high secondary (2°) C-H bond selectivity. A turnover number (TN) of 11.8 and a 30% yield (based on the H2O2 oxidant) were achieved during the catalytic oxidation of cyclohexane by 1 under irradiation with visible light. For the transformation of cycloalkanes and bicyclic decalins with both 2° and tertiary (3°) C-H bonds, 1 always preferred to oxidise the 2° C-H bonds to the corresponding ketone and alcohol products; the 2°/3° ratio ranged between 78/22 and >99/1 across 7 examples. 18O isotope labelling experiments, ESR experiments, a PPh3 method and the catalase method were used to characterize the reaction process during the oxidation. The success of 1 showed that, in addition to using a bulky catalyst, high 2° C-H bond selectivity could also be achieved using a less bulky molecular iron complex as the catalyst.

Oxidation with the "O2 - H2O2 - Vauauium complex - Pyrazine-2-carboxylic acid" reagent 9. Oxidation of cyclohexene and decalin

The oxidation of cyclohexene with hydrogen peroxide catalyzed by a vanadium complex and pyrazine-2-carboxylic acid (PCA) in air results in the formation of cyclohex-2-enyl hydroperoxide as the main product and cyclohex-2-enol, cyclohex-2-enone, cyclohex-3-enyl hydroperoxide, cyclohex-3-enol, cyclohexanol, cyclohexane, and 1,2-epoxycyclohexane in lesser amounts. The composition of the products of oxidation of decalin isomers with the system in question is similar to those obtained in the photochemical oxidation with hydrogen peroxide in air and in the oxidation with air in the presence of anthraquinone. A proposed mechanism for the oxidation includes the initiation by hydroxyl radicals generated from hydrogen peroxide under the action of the V - PCA system.

The selective functionalization of saturated hydrocarbons. Part 46. An investigation of Udenfriend's system under Gif conditions

Under Gif conditions using ascorbic acid as reductant and oxygen as oxidant in pyridine, the selectivity for secondary hydrogen functionalization is exceptional. EDTA (ethylenediamine-tetra-acetic acid) is not needed as a ligand for iron.

Oxidations by Methyl(trifluoromethyl)dioxirane. 2. Oxyfunctionalization of Saturated Hydrocarbons

The reaction of methyl(trifluoromethyl)dioxirane (1b), a novel dioxirane species, with two open-chain, four cyclic, and five polycyclic saturated hydrocarbons and two aralkyl hydrocarbons in CH2Cl2/1,1,1-trifluoropropanone has been studied; under mild conditions (-22 to 0 deg C), it gives alcohols and/or ketones (deriving from further oxidation of secondary alcohols) in high yields and within very short reaction times.Primary C-H bonds are not appreciably oxidized and high regioselectivities were determined for attack at tertiary over secondary C-H bonds, with theexception of norbornane, which showed opposite regioselectivity.The reaction is also highly stereoselective, since hydroxylations of cis- and trans-decalin and of cis- and trans-1,2-dimethylcyclohexane were found to be in each case stereospecific with retention.From kinetic data, Ea = 14.3 kcal mol-1 and log A = 9.9 were estimated for cyclohexane oxidation.Relative rates change in the order cyclohexane (0.78) octane (9.2) adamantane (146); cis-1,2-dimethylcyclohexane was observed to be 7-fold more reactive than its trans isomer, demonstrating remarkable discrimination for equatorial vs axial C-H attack (also noticed in the case of cis- and trans-decalin).The relative rate of oxidation of cumene vs ethylbenzene was found to be ca. 3.1 (after statistical correction), i.e., in sharp excess over values usually recorded in classical radical H-atom abstraction from benzylic position.Rate constants determined for the reactions of cumene and of ethylbenzene show the title dioxirane (1b) is more reactive than dimethyldioxirane (1a) by factors of ca. 600 and over 700, respectively.The whole of theobservations is better accommodated by an "oxenoid" mechanism, involving concerted O-atom insertion by dioxirane into C-H bonds of hydrocarbons.

FUNCTIONALISATION OF SATURATED HYDROCARBONS. Part X. A COMPARATIVE STUDY OF CHEMICAL AND ELECTROCHEMICAL PROCESSES (GIF AND GIF-ORSAY SYSTEMS) IN PYRIDINE, IN ACETONE AND IN PYRIDINE-CO-SOLVENT MIXTURES

Six saturated hydrocarbons (cyclohexane, 3-ethylpentane, methylcyclopentane, cis- and trans-decalin and adamantane) were oxidised by the Gif system (iron catalyst, oxygen, zinc, carboxylic acid) and its electrochemical equivalent (Gif-Orsay system).Results obtained using various solvents (pyridine, acetone, pyridine-acetone mixtures) were similar for both systems.Total or partial replacement of pyridine with acetone affects the selectivity for secondary positions and lowers the ketone/secondary alcohol ratio.The formation of the same ratio of cis- and trans-decal-9-ol from both cis- and trans-decalin clearly demonstrates that tertiary alcohols result from a mechanism essentially radical in nature.