34737-70-7

Upstream product

• 529-20-4 2-methylphenyl aldehyde 
• 36888-18-3 (E)-2,2'-dimethylstilbene 
• 5294-03-1 di-o-tolylethyne 
• 89-95-2 2-methyl-benzyl alcohol 
• 1530-36-5 [(2-methylphenyl)methyl]triphenylphosphonium bromide 
• 4389-39-3 2-hydroxy-1,2-bis(2-methylphenyl)ethanone 
• 89-92-9 2-methylbenzyl bromide 
• 655-48-1 DL-1,2-diphenylethane-1,2-diol 
• 74-88-4 methyl iodide 
• 603-35-0 triphenylphosphine 

Downstream Products

• 916525-60-5 1,2-bis(2-methylphenyl)-2-[(7,8,8-trimethyloctahydro-4,7-methanobenzo[b]furan-2-yl)oxy]ethanol 
• 916525-65-0 [1,2-bis(2-methylphenyl)-2-(2-methylpropoxy)ethoxy]-7,8,8-trimethyloctahydro-4,7-methanobenzo[b]furan 
• 916525-77-4 oxophenylacetic acid (1R,2S)-1,2-bis(2-methylphenyl)-2-(2-methylpropoxy)ethyl ester 
• 916525-82-1 hydroxy(phenyl)acetic acid (1R,2S)-1,2-bis(2-methylphenyl)-2-(2-methylpropoxy)ethyl ester 
• 916525-72-9 (1R,2S)-1,2-bis(2-methylphenyl)-2-(2-methylpropoxy)ethanol 

Relevant academic research and scientific papers

Oxidative carbon-carbon bond cleavage of 1,2-diols to carboxylic acids/ketones by an inorganic-ligand supported iron catalyst

The carbon-carbon bond cleavage of 1,2-diols is an important chemical transformation. Although traditional stoichiometric and catalytic oxidation methods have been widely used for this transformation, an efficient and valuable method should be further explored from the views of reusable catalysts, less waste, and convenient procedures. Herein an inorganic-ligand supported iron catalyst (NH4)3[FeMo6O18(OH)6]·7H2O was described as a heterogeneous molecular catalyst in acetic acid for this transformation in which hydrogen peroxide was used as the terminal oxidant. Under the optimized reaction conditions, carbon-carbon bond cleavage of 1,2-diols could be achieved in almost all cases and carboxylic acids or ketones could be afforded with a high conversion rate and high selectivity. Furthermore, the catalytic system was used efficiently to degrade renewable biomass oleic acid. Mechanistic insights based on the observation of the possible intermediates and control experiments are presented.

CBZ6 as a Recyclable Organic Photoreductant for Pinacol Coupling

A recyclable organic photoreductant (1 mol % CBZ6)-catalyzed reductive (pinacol) coupling of aldehydes, ketones, and imines has been developed. Irradiated by purple light (407 nm) using triethylamine as an electron donor, a variety of 1,2-diols and 1,2-diamines could be prepared. The oxidation potential of the excited state of CBZ6 is established as -1.92 V (vs saturated calomel electrode (SCE)). The relative high reductive potential enables the reductive coupling of carbonyl compounds and their derivatives. CBZ6 can be prepared in gram scale and is acid/base- or air-stable. It could be applied in large-scale photoreductive synthesis and recovered in high yield after the reaction.

Oxidative and Redox-Neutral Approaches to Symmetrical Diamines and Diols by Single Electron Transfer/Hydrogen Atom Transfer Synergistic Catalysis

Homocoupling reactions of benzylamines and benzyl alcohols were examined under synergistic catalysis conditions with a photoredox catalyst and thiobenzoic acid as a hydrogen atom abstractor. When pivalaldehyde was used as an electron acceptor, oxidative dimerization proceeded selectively, whereas the use of benzaldehydes or iminium ions as electron acceptors resulted in redox-neutral coupling. These reactions afforded symmetrical 1,2-diamines and 1,2-diols in good yields.

Diborative Reduction of Alkynes to 1,2-Diboryl-1,2-Dimetalloalkanes: Its Application for the Synthesis of Diverse 1,2-Bis(boronate)s

Reduction of alkynes with alkali metals in the presence of B2pin2 results in diboration of alkynes. Distinct from conventional dissolving metal hydrogenations, two carbon-boron bonds and also two carbon-alkali metal bonds can be constructed in one operation to form 1,2-diboryl-1,2-dimetalloalkanes. The 1,2-diboryl-1,2-dimetalloalkanes generated are readily convertible to a wide range of vicinal bis(boronate)s. In particular, oxidation of the 1,2-dianionic species provides (E)-1,2-diborylalkenes, unique anti-selective diboration of alkynes being thus executed.

Hydrogen Bonding-Assisted Enhancement of the Reaction Rate and Selectivity in the Kinetic Resolution of d,l-1,2-Diols with Chiral Nucleophilic Catalysts

An extremely efficient acylative kinetic resolution of d,l-1,2-diols in the presence of only 0.5 mol% of binaphthyl-based chiral N,N-4-dimethylaminopyridine was developed (selectivity factor of up to 180). Several key experiments revealed that hydrogen bonding between the tert-alcohol unit(s) of the catalyst and the 1,2-diol unit of the substrate is critical for accelerating the rate of monoacylation and achieving high enantioselectivity. This catalytic system can be applied to a wide range of substrates involving racemic acyclic and cyclic 1,2-diols with high selectivity factors. The kinetic resolution of d,l-hydrobenzoin and trans-1,2-cyclohexanediol on a multigram scale (10 g) also proceeded with high selectivity and under moderate reaction conditions: (i) very low catalyst loading (0.1 mol%); (ii) an easily achievable low reaction temperature (0 °C); (iii) high substrate concentration (1.0 M); and (iv) short reaction time (30 min). (Figure presented.).

Photoredox-Catalyzed Reductive Coupling of Aldehydes, Ketones, and Imines with Visible Light

Ketyl radical and amino radical anions, valuable reactive intermediates for C-C bond-forming reactions, are accessible through a C=O/C=NR umpolung. However, their utilization in catalysis remains largely underdeveloped owing to the high reduction potential of carbonyl compounds and imines. In the context of photoredox catalysis, tertiary amines are commonly employed as sacrificial co-reducing agents. Herein, an additional role of the amine is proposed, in which it is essential for the organocatalytic substrate activation. The combination of photoredox catalysis and carbonyl/imine activation enables the reductive coupling of aldehydes, ketones, and imines under mild reaction conditions.

Alkene anti-Dihydroxylation with Malonoyl Peroxides

Malonoyl peroxide 1, prepared in a single step from the commercially available diacid, is an effective reagent for the anti-dihydroxylation of alkenes. Reaction of 1 with an alkene in the presence of acetic acid at 40 °C followed by alkaline hydrolysis leads to the corresponding diol (35-92%) with up to 13:1 anti-selectivity. A mechanism consistent with experimental findings is proposed that accounts for the selectivity observed.

Mechanistic aspects of aldehyde and imine electro-reduction in a liquid-liquid carbon nanofiber membrane microreactor

A simple and electrolyte-free ion-transfer electrosynthesis micro-reactor system (volume 100 μL, up to 10 mg batches) for processes at liquid-liquid interfaces is developed and demonstrated for the reduction of aldehydes and imines. These cathodic reactions occur at an amphiphilic carbon nanofiber membrane accompanied by proton cation transfer from an aqueous phase into an organic phase.

Metal-free dihydroxylation of alkenes using cyclobutane malonoyl peroxide

Cyclobutane malonoyl peroxide (7), prepared in a single step from the commercially available diacid 6, is an effective reagent for the dihydroxylation of alkenes. Reaction of a chloroform solution of 7 with an alkene in the presence of 1 equiv of water at 40 °C followed by alkaline hydrolysis leads to the corresponding diol (30-84%). With 1,2-disubstituted alkenes, the reaction proceeds with syn-selectivity (3:1 → 50:1). A mechanism consistent with experimental findings is proposed, which is supported by deuterium and oxygen labeling studies and explains the stereoselectivity observed. Alternative reaction pathways that are dependent on the structure of the starting alkene are also described leading to the synthesis of allylic alcohols and γ-lactones.

Alkene syn dihydroxylation with malonoyl peroxides

Cyclopropyl malonoyl peroxide (1), which can be prepared in a single step from the commercially available diacid, is an effective reagent for the dihydroxylation of alkenes. Reaction of 1 with an alkene in the presence of 1 equiv of water at 40 °C followed by alkaline hydrolysis leads to the corresponding diol (40-93%). With 1,2-disubstituted alkenes, the reaction proceeds with syn selectivity (3:1 to >50:1). A mechanism consistent with the experimental findings that is supported by oxygen-labeling studies is proposed.