5465-09-8Relevant academic research and scientific papers
Highly Selective Hydrogenation of Phenols to Cyclohexanone Derivatives Using a Palladium@N-Doped Carbon/SiO2Catalyst
Sheng, Xueru,Wang, Chao,Wang, Wentao
supporting information, p. 2425 - 2431 (2021/11/16)
A new palladium-based heterogeneous material was synthesized by means of immobilization of Pd(OAc)2/1,10-phenanthroline on commercially available SiO2and subsequent pyrolysis at 600 °C for 2 h in air, namely, a Pd@N-doped carbon/SiO2catalyst. The obtained catalyst was studied by X-ray diffraction (XRD), high-resolution transmission electron microscopy (HRTEM), and X-ray photoelectron spectroscopy (XPS) techniques, and was effectively applied in the highly selective hydrogenation of phenols to give the corresponding cyclohexanone derivatives with 93-98% yields at 100 °C under 0.4 MPa H2in EtOH. It was demonstrated that introducing nitrogen could effectively promote the Pd dispersion and enhance the electronic interaction of Pd, both of which facilitate the improvement of the catalytic activity and selectivity. The likely reaction pathway was outlined to elucidate the selective hydrogenation mechanism according to experimental results.
Stereoselective oxidation of alkanes with: M -CPBA as an oxidant and cobalt complex with isoindole-based ligands as catalysts
Nesterova, Oksana V.,Kopylovich, Maximilian N.,Nesterov, Dmytro S.
, p. 93756 - 93767 (2016/10/21)
Two complexes with isoindole-core ligands of general formula [M{C6H4C(NH2)NC(ONCMe2)2}2](NO3)2 (M = Co for 1 and M = Ni for 2) were studied as catalysts for the mild stereoselective alkane oxidation with m-chloroperbenzoic acid (m-CPBA) as an oxidant and cis-1,2-dimethylcyclohexane (cis-1,2-DMCH) as a main model substrate. Complex 1 disclosed a pronounced activity, with high retention of stereoconfiguration of substrates (>98% for cis-1,2-DMCH) and highest cis/trans ratio of tertiary alcohols (products) of 56, under mild conditions. The best achieved yields of tertiary cis-alcohols were of 13.7 and 50.5%, based on the substrate (cis-1,2-DMCH) and the oxidant (m-CPBA) respectively. Kinetic experiments, high bond and stereoselectivity parameters, kinetic isotope effect of 7.2(2) in the oxidation of cyclohexane, and incorporation of 18O from H218O support the involvement of CoIVO high-valent metal-oxo intermediates as main C-H attacking species.
From DNA to catalysis: A thymine-acetate ligated non-heme iron(III) catalyst for oxidative activation of aliphatic C-H bonds
Al-Hunaiti, Afnan,R?is?nen, Minn?,Repo, Timo
supporting information, p. 2043 - 2046 (2016/02/05)
A non-heme, iron(iii)/THA(thymine-1-acetate) catalyst together with H2O2 as an oxidant is efficient in oxidative C-H activation of alkanes. Although having a higher preference for tertiary C-H bonds, the catalyst also oxidizes aliphatic secondary C-H bonds into carbonyl compounds with good to excellent conversions. Based on the site selectivity of the catalyst and our mechanistic studies the reaction proceeds via an Fe-oxo species without long lived carbon centered radicals.
Oxidation of Alkanes by Periodate Using a MnV Nitrido Complex as Catalyst
Ma, Li,Chen, Lingjing,Lau, Tai-Chu
, p. 2846 - 2848 (2016/10/25)
The design of catalytic systems that can selectively oxidize unactivated C?H bonds under mild conditions is a challenge to chemists. We report here that the manganese(V) nitrido complex [MnV(N)(CN)4]2? is a highly efficient catalyst for the oxidation of alkanes by periodate (IO4 ?) at ambient conditions. Excellent yields of alcohols and ketones (>95 %) are obtained with a maximum turnover number (TON) of 3000.
Catalytic oxidation of alkanes by a (salen)osmium(VI) nitrido complex using H2O2 as the terminal oxidant
Chen, Man,Pan, Yi,Kwong, Hoi-Ki,Zeng, Raymond J.,Lau, Kai-Chung,Lau, Tai-Chu
supporting information, p. 13686 - 13689 (2015/09/02)
The osmium(vi) nitrido complex, [OsVI(N)(L)(CH3OH)]+ (1, L = N,N′-bis(salicylidene)-o-cyclohexyldiamine dianion) is an efficient catalyst for the oxidation of alkanes under ambient conditions using H2O2 as the oxidant. Alkanes are oxidized to the corresponding alcohols and ketones, with yields up to 75% and turnover numbers up to 2230. Experimental and computational studies are consistent with a mechanism that involves O-atom transfer from H2O2 to [OsVI(N)(L)]+ to generate an [OsVIII(N)(O)(L)]+ active intermediate.
Highly efficient alkane oxidation catalyzed by [MnV(N)(CN) 4]2-. Evidence for [MnVII(N)(O)(CN) 4]2- as an active intermediate
Ma, Li,Pan, Yi,Man, Wai-Lun,Kwong, Hoi-Ki,Lam, William W.Y.,Chen, Gui,Lau, Kai-Chung,Lau, Tai-Chu
, p. 7680 - 7687 (2014/06/10)
The oxidation of various alkanes catalyzed by [MnV(N)(CN) 4]2- using various terminal oxidants at room temperature has been investigated. Excellent yields of alcohols and ketones (>95%) are obtained using H2O2 as oxidant and CF3CH 2OH as solvent. Good yields (>80%) are also obtained using (NH4)2[Ce(NO3)6] in CF 3CH2OH/H2O. Kinetic isotope effects (KIEs) are determined by using an equimolar mixture of cyclohexane (c-C6H 12) and cyclohexane-d12 (c-C6D12) as substrate. The KIEs are 3.1 ± 0.3 and 3.6 ± 0.2 for oxidation by H2O2 and Ce(IV), respectively. On the other hand, the rate constants for the formation of products using c-C6H12 or c-C6D12 as single substrate are the same. These results are consistent with initial rate-limiting formation of an active intermediate between [Mn(N)(CN)4]2- and H2O2 or CeIV, followed by H-atom abstraction from cyclohexane by the active intermediate. When PhCH2C(CH3)2OOH (MPPH) is used as oxidant for the oxidation of c-C6H12, the major products are c-C6H11OH, c-C6H10O, and PhCH2C(CH3)2OH (MPPOH), suggesting heterolytic cleavage of MPPH to generate a Mn=O intermediate. In the reaction of H2O2 with [Mn(N)(CN)4]2- in CF 3CH2OH, a peak at m/z 628.1 was observed in the electrospray ionization mass spectrometry, which is assigned to the solvated manganese nitrido oxo species, (PPh4)[Mn(N)(O)(CN)4] -·CF3CH2OH. On the basis of the experimental results the proposed mechanism for catalytic alkane oxidation by [MnV(N)(CN)4]2-/ROOH involves initial rate-limiting O-atom transfer from ROOH to [Mn(N)(CN)4]2- to generate a manganese(VII) nitrido oxo active species, [MnVII(N)(O) (CN)4]2-, which then oxidizes alkanes (R'H) via a H-atom abstraction/O-rebound mechanism. The proposed mechanism is also supported by density functional theory calculations.
Site-selective oxidation of unactivated C sp 3-H bonds with hypervalent iodine(III) reagents
Moteki, Shin A.,Usui, Asuka,Zhang, Tiexin,Solorio Alvarado, Cesar R.,Maruoka, Keiji
supporting information, p. 8657 - 8660 (2013/09/12)
By design: The site-selective oxidation of unactivated secondary C sp 3-H bonds was accomplished with hypervalent iodine(III) reagents and tert-butyl hydroperoxide (see scheme). The preparation and derivatization of the hypervalent iodine(III) reagent are simple, thus allowing the rational design of these reagents to optimize the site selectivity of the oxidation. Copyright
An iron catalyst for oxidation of alkyl C-H bonds showing enhanced selectivity for methylenic sites
Prat, Irene,Gomez, Laura,Canta, Merce,Ribas, Xavi,Costas, Miquel
supporting information, p. 1908 - 1913 (2013/03/14)
Many are called but few are chosen: A nonheme iron complex catalyzes the oxidation of alkyl C-H bonds by using H2O2 as the oxidant, showing an enhanced selectivity for secondary over tertiary C-H bonds (see scheme). Copyright
Selective activation of secondary C-H bonds by an iron catalyst: Insights into possibilities created by the use of a carboxyl-containing bipyridine ligand
Cheng, Shi,Li, Jing,Yu, Xiaoxiao,Chen, Chuncheng,Ji, Hongwei,Ma, Wanhong,Zhao, Jincai
, p. 3267 - 3273 (2013/10/01)
In this work, we report the discovery of a carboxyl-containing iron catalyst 1 (FeII-DCBPY, DCBPY = 2,2′-bipyridine-4,4′- dicarboxylic acid), which could activate the C-H bonds of cycloalkanes with high secondary (2°) C-H bond selectivity. A turnover number (TN) of 11.8 and a 30% yield (based on the H2O2 oxidant) were achieved during the catalytic oxidation of cyclohexane by 1 under irradiation with visible light. For the transformation of cycloalkanes and bicyclic decalins with both 2° and tertiary (3°) C-H bonds, 1 always preferred to oxidise the 2° C-H bonds to the corresponding ketone and alcohol products; the 2°/3° ratio ranged between 78/22 and >99/1 across 7 examples. 18O isotope labelling experiments, ESR experiments, a PPh3 method and the catalase method were used to characterize the reaction process during the oxidation. The success of 1 showed that, in addition to using a bulky catalyst, high 2° C-H bond selectivity could also be achieved using a less bulky molecular iron complex as the catalyst.
Catalyst-controlled aliphatic c-h oxidations with a predictive model for site-selectivity
Gormisky, Paul E.,White, M. Christina
supporting information, p. 14052 - 14055 (2013/10/21)
Selective aliphatic C-H bond oxidations may have a profound impact on synthesis because these bonds exist across all classes of organic molecules. Central to this goal are catalysts with broad substrate scope (small-molecule-like) that predictably enhance or overturn the substrate's inherent reactivity preference for oxidation (enzyme-like). We report a simple small-molecule, non-heme iron catalyst that achieves predictable catalyst-controlled site-selectivity in preparative yields over a range of topologically diverse substrates. A catalyst reactivity model quantitatively correlates the innate physical properties of the substrate to the site-selectivities observed as a function of the catalyst.
