4065-81-0Relevant articles and documents
Incorporation of redox-inactive cations promotes iron catalyzed aerobic C-H oxidation at mild potentials
Chantarojsiri, Teera,Ziller, Joseph W.,Yang, Jenny Y.
, p. 2567 - 2574 (2018)
The synthesis and characterization of the Schiff base complexes Fe(ii) (2M) and Fe(iii)Cl (3M), where M is a K+ or Ba2+ ion incorporated into the ligand, are reported. The Fe(iii/ii) redox potentials are positively shifted by 440 mV
A Mononuclear Nonheme Iron(IV)-Oxo Complex of a Substituted N4Py Ligand: Effect of Ligand Field on Oxygen Atom Transfer and C-H Bond Cleavage Reactivity
Singh, Reena,Ganguly, Gaurab,Malinkin, Sergey O.,Demeshko, Serhiy,Meyer, Franc,Nordlander, Ebbe,Paine, Tapan Kanti
, p. 1862 - 1876 (2019/01/25)
A mononuclear iron(II) complex [FeII(N4PyMe2)(OTf)](OTf)(1), supported by a new pentadentate ligand, bis(6-methylpyridin-2-yl)-N,N-bis((pyridin-2-yl)methyl)methanamine (N4PyMe2), has been isolated and characterized. Introduction of methyl groups in the 6-position of two pyridine rings makes the N4PyMe2 a weaker field ligand compared to the parent N4Py ligand. Complex 1 is high-spin in the solid state and converts to [FeII(N4PyMe2)(CH3CN)](OTf)2 (1a) in acetonitrile solution. The iron(II) complex in acetonitrile displays temperature-dependent spin-crossover behavior over a wide range of temperature. In its reaction with m-CPBA or oxone in acetonitrile at -10 °C, the iron(II) complex converts to an iron(IV)-oxo species, [FeIV(O)(N4PyMe2)]2+ (2). Complex 2 exhibits the M?ssbauer parameters δ = 0.05 mm/s and ΔEQ = 0.62 mm/s, typical of N-ligated S = 1 iron(IV)-oxo species. The iron(IV)-oxo complex has a half-life of only 14 min at 25 °C and is reactive toward oxygen-atom-transfer and hydrogen-atom-transfer (HAT) reactions. Compared to the parent complex [FeIV(O)(N4Py)]2+, 2 is more reactive in oxidizing thioanisole and oxygenates the C-H bonds of aliphatic substrates including that of cyclohexane. The enhanced reactivity of 2 toward cyclohexane results from the involvement of the S = 2 transition state in the HAT pathway and a lower triplet-quintet splitting compared to [FeIV(O)(N4Py)]2+, as supported by DFT calculations. The second-order rate constants for HAT by 2 is well correlated with the C-H bond dissociation energies of aliphatic substrates. Surprisingly, the slope of this correlation is different from that of [FeIV(O)(N4Py)]2+, and 2 is more reactive only in the case of strong C-H bonds (>86 kcal/mol), but less reactive in the case of weaker C-H bonds. Using oxone as the oxidant, the iron(II) complex displays catalytic oxidations of substrates with low activity but with good selectivity.
Mn(III)-porphyrin/graphene oxide nanocomposite as an efficient catalyst for the aerobic oxidation of hydrocarbons
Rayati, Saeed,Rezaie, Saghar,Nejabat, Fatemeh
, p. 696 - 703 (2018/04/20)
In this study, manganese porphyrin was grafted on the surface of graphene oxide nanosheets via covalent bonding to produce a heterogeneous catalyst. The prepared nanocomposite was characterized using X-ray diffraction, UV–vis spectroscopy, scanning electron microscopy, Fourier transform infrared, and thermogravimetric analysis. Atomic absorption spectroscopy was also used to determine the amount of the loaded catalyst. The catalytic efficiency of the immobilized Mn-porphyrin was investigated for the aerobic oxidation of alkenes and saturated alkanes in acetone under mild reaction conditions. The prepared heterogenized catalyst displays superior catalytic performance as compared to the homogeneous catalyst. Moreover, the excellent turnover number (more than 31,767) achieved for the oxidation of styrene indicates the high longevity of the supported catalyst. The catalyst structure is preserved well after the oxidation reaction and is simply reused at least five times, without any significant loss of the catalytic efficiency.
