83426-49-7Relevant articles and documents
Room-temperature copper-catalyzed electrophilic amination of arylcadmium iodides with ketoximes
Korkmaz, Adem
, p. 3119 - 3125 (2021/05/10)
We started our study by preparation two ketoximes. Later, there were studies to reveal these ketoximes' effects in the electrophilic amination reaction with organocadmium reagents. Primarily, it was observed that arylcadmium iodides could not be reacted with ketoximes at room temperature in the absence of a catalyst. CuCN was a suitable catalyst for this electrophilic amination reaction of arylcadmium iodides and allowed the preparation of functionalized aniline derivatives in good yields under mild reaction conditions. We obtained the results indicated that the yield of primary arylamines was strongly dependent on the steric and electronic effects of organocadmium reagent and amination agent. In the case of both amination reagents, meta-substituted arylamines were obtained in higher yields than para-substituted arylamines. We observed that acetone O-(4-chlorophenylsulfonyl)oxime, 1, as an aminating agent, was more successful than acetone O-(2-Naphthylsulfonyl)oxime, 2, in the synthesis of functionalized arylamines by electrophilic amination of corresponding aryl cadmium iodides. In this method, there is no cadmium release to the environment.
Switching from biaryl formation to amidation with convoluted polymeric nickel catalysis
Sen, Abhijit,Dhital, Raghu N.,Sato, Takuma,Ohno, Aya,Yamada, Yoichi M.A.
, p. 14410 - 14418 (2020/12/21)
A stable, reusable, and insoluble poly(4-vinyl-pyridine) nickel catalyst (P4VP-NiCl2) was prepared through the molecular convolution of poly(4-vinylpyridine) (P4VP) and nickel chloride. We proposed a coordination structure of the Ni center in the precatalyst based on elemental analysis and Ni K-edge XANES, and we confirmed that it is consistent with Ni K-edge EXAFS. The Suzuki?Miyaura-type coupling of aryl halides and arylboronic esters proceeded using P4VP-NiCl2 (0.1 mol % Ni) to give the corresponding biaryl compounds in up to 94% yield. Surprisingly, when the same reaction of aryl halides and arylboronic acid/ester was carried out in the presence of amides, the amidation proceeded predominantly to give the corresponding arylamides in up to 99% yield. In contrast, the reaction of aryl halides and amides in the absence of arylboronic acid/ester did not proceed. P4VP-NiCl2 successfully catalyzed the lactamization for preparing phenanthridinone. P4VP-NiCl2 was reused five times without significant loss of catalytic activity. Pharmaceuticals, natural products, and biologically active compounds were synthesized efficiently using P4VPNiCl2 catalysis. Nickel contamination in the prepared pharmaceutical compounds was not detected by ICP-MS analysis. The reaction was scaled to multigrams without any loss of chemical yield. Mechanistic studies for both Suzuki?Miyaura and amidation were performed.
Modular Continuous Flow Synthesis of Imatinib and Analogues
Fu, Wai Chung,Jamison, Timothy F.
supporting information, p. 6112 - 6116 (2019/08/26)
A modular continuous flow synthesis of imatinib and analogues is reported. Structurally diverse imatinib analogues are rapidly generated using three readily available building blocks via a flow hydration/chemoselective C-N coupling sequence. The newly developed continuous flow hydration and amidation modules each exhibit a broad scope with good to excellent yields. Overall, the method described does not require solvent switches, in-line purifications, or packed-bed apparatuses due to the judicious manipulation of flow setups and solvent mixtures.
