433-97-6Relevant articles and documents
Substrate docking algorithms and prediction of the substrate specificity of cytochrome P450(cam) and its L244A mutant
De Voss, James J.,Sibbesen, Ole,Zhang, Zhoupeng,Ortiz De Montellano, Paul R.
, p. 5489 - 5498 (1997)
The substrate specificity of cytochrome P450, defined as the ability of a compound to promote NAD(P)H and O2 utilization in the production of either organic or reduced oxygen metabolites, is largely determined by steric and hydrophobic interactions. P450 specificity may therefore be determined by the 'fit' of a compound within the active site. A receptor-constrained three- dimensional screening program (DOCK) has been used to select 11 compounds predicted to fit within the P450(cam) active site and 5 compounds predicted to fit within the L244A P450(cam) but not wild-type active site. The 16 compounds were evaluated as P450(cam) substrates by measuring (a) binding to the enzyme, (b) stimulation of NADH and O2 consumption, (c) enhancement of H2O2 production, and (d) formation of organic metabolites. Seven of the compounds predicted to fit in the active site, and none of the compounds predicted not to fit, were found to be substrates. Compounds predicted to fit very tightly within the active site were poor or non-substrates. The L244A P450(cam) mutant was constructed, expressed, purified, and shown to readily oxidize some of the larger compounds incorrectly predicted to be substrates for the wild-type enzyme. The 5 ligands selected to fit the L244A but not wild-type sites were not detectable substrates, presumably because they fit too tightly into the active site. Retroactive adjustments of the docking program based on an analysis of the docking parameters, particularly variation of the minimum distance allowed between ligand and protein atoms, allow correct predictions for the activity of 15 of the 16 compounds with wild-type P450(cam). The DOCK predictions for the L244A mutant were also improved by changing the minimum contact distances to disfavor the larger compounds. The results indicate that ligands that fill the active site are marginal or non-substrates. A degree of freedom of motion is required for substrate positioning and catalytic function. If parameters are chosen to allow for this requirement, P450(cam) substrate predictions based on ligand docking in the active site can be reasonably accurate.
Desilylative carboxylation of aryltrimethylsilanes using CO2 in the presence of catalytic phosphazenium salt
Yonemoto-Kobayashi, Misato,Inamoto, Kiyofumi,Kondo, Yoshinori
, p. 477 - 479 (2014)
An efficient method for the desilylative carboxylation of aryltrimethylsilanes with CO2 catalyzed by phosphazenium salt has been developed. This protocol can provide various arylcarboxylic acids that are important structural motifs in biologically active chemical compounds.
Aerobic oxidation of aldehydes to carboxylic acids catalyzed by recyclable ag/c3 n4 catalyst
Wu, Chaolong,Yao, Xiaoquan,Yu, Min,Zhou, Li,Zhu, Li
, p. 167 - 175 (2021/03/19)
The oxidation of aldehydes is an efficient methodology for the synthesis of carboxylic acids. Herein we hope to report a simple, efficient and recyclable protocol for aerobic oxidation of aldehydes to carboxylic acid by using C3N4 supported silver nanoparticles (Ag/C3N4) as a catalyst in aqueous solution under mild conditions. Under standard conditions, the corresponding carboxylic acids can be obtained in good to excellent yields. In addition, Ag/C3N4 is convenient for recovery and could be reused three times with satisfactory yields.
Oxidative α-C-C Bond Cleavage of 2° and 3° Alcohols to Aromatic Acids with O2at Room Temperature via Iron Photocatalysis
Zhang, Zongnan,Zhang, Guoxiang,Xiong, Ni,Xue, Ting,Zhang, Junjie,Bai, Lu,Guo, Qinyue,Zeng, Rong
, p. 2915 - 2920 (2021/05/05)
The selective α-C-C bond cleavage of unfunctionalized secondary (2°) and tertiary alcohols (3°) is essential for valorization of macromolecules and biopolymers. We developed a blue-light-driven iron catalysis for aerobic oxidation of 2° and 3° alcohols to acids via α-C-C bond cleavages at room temperature. The first example of oxygenation of the simple tertiary alcohols was reported. The iron catalyst and blue light play critical roles to enable the formation of highly reactive O radicals from alcohols and the consequent two α-C-C bond cleavages.
Continuous Platform to Generate Nitroalkanes On-Demand (in Situ) Using Peracetic Acid-Mediated Oxidation in a PFA Pipes-in-Series Reactor
Tsukanov, Sergey V.,Johnson, Martin D.,May, Scott A.,Kolis, Stanley P.,Yates, Matthew H.,Johnston, Jeffrey N.
, p. 971 - 977 (2018/08/28)
The synthetic utility of the aza-Henry reaction can be diminished on scale by potential hazards associated with the use of peracid to prepare nitroalkane substrates and the nitroalkanes themselves. In response, a continuous and scalable chemistry platform to prepare aliphatic nitroalkanes on-demand using the oxidation of oximes with peracetic acid and direct reaction of the nitroalkane intermediate in an aza-Henry reaction is reported. A uniquely designed pipes-in-series plug-flow tube reactor addresses a range of process challenges, including stability and safe handling of peroxides and nitroalkanes. The subsequent continuous extraction generates a solution of purified nitroalkane, which can be directly used in the following enantioselective aza-Henry chemistry to furnish valuable chiral diamine precursors with high selectivity, thus completely avoiding isolation of the potentially unsafe low-molecular-weight nitroalkane intermediate. A continuous campaign (16 h) established that these conditions were effective in processing 100 g of the oxime and furnishing 1.4 L of nitroalkane solution.
Copper-Promoted Conversion of Aromatic Amines into Trifluoromethylated Arenes: One-Pot Sandmeyer Trifluoromethylation
Hong, Jianquan,Wang, Guifu,Huo, Lianguang,Zheng, Changge
supporting information, p. 1761 - 1767 (2017/09/06)
A simple copper-promoted one-pot Sandmeyer trifluoromethylation of aromatic amines with Langlois’ reagent has been demonstrated. The reaction is performed in mild reaction conditions under an air atmosphere with good substrate scope and functional group compatibility. It provides an alternative and straightforward synthetic approach to access a variety of trifluoromethylated arenes.
SO2F2-Mediated One-Pot Synthesis of Aryl Carboxylic Acids and Esters from Phenols through a Pd-Catalyzed Insertion of Carbon Monoxide
Fang, Wan-Yin,Leng, Jing,Qin, Hua-Li
supporting information, p. 2323 - 2331 (2017/09/06)
A one-pot Pd-catalyzed carbonylation of phenols into their corresponding aryl carboxylic acids and esters through the insertion of carbon monoxide has been developed. This procedure offers a direct synthesis of aryl carboxylic acids and esters from inexpensive and abundant starting materials (phenols, SO2F2 and CO) under mild conditions. This method tolerates a broad range of functional groups and is also applicable for the modification of complicated natural products.
A O-between the - trifluoromethyl benzoic acid to synthetic method (by machine translation)
-
, (2017/12/29)
The present invention provides a O-between the - trifluoromethyl benzoic acid to the synthesis method, the method comprises the following steps: (1) between adjacent to methyl benzoic acid acylated preparation between neighbour methyl benzoyl chloride; (2) between the adjacent methyl benzoyl chloride to chlorine light between neighbour trichloromethyl benzoyl chloride is obtained; (3) adjacent to the trichloromethyl benzoyl chloride fluoride obtained between between neighbour trifluoromethyl methyl benzoyle fluoride; (4) adjacent to the trifluoromethyl benzoyle fluoride hydrolysis between the final product is obtained between neighbour trifluoromethyl methyl benzoic acid. The method of the invention cheap raw material, the product yield is high, the process is simple, is favorable for industrial production. (by machine translation)
Oxalic acid as the: In situ carbon monoxide generator in palladium-catalyzed hydroxycarbonylation of arylhalides
Shao, Changdong,Lu, Ailan,Wang, Xiaoling,Zhou, Bo,Guan, Xiaohong,Zhang, Yanghui
supporting information, p. 5033 - 5040 (2017/07/10)
An efficient palladium-catalyzed hydroxycarbonylation reaction of arylhalides using oxalic acid as a CO source has been developed. The reaction features high safety, low catalyst loading, and a broad substrate scope, and provides a safe and tractable approach to access a variety of aromatic carboxylic acid compounds. Mechanistic studies revealed the decomposition pattern of oxalic acid.
Conversion of nitroalkanes into carboxylic acids via iodide catalysis in water
Marcé, Patricia,Lynch, James,Blacker, A. John,Williams, Jonathan M. J.
, p. 1013 - 1016 (2016/01/16)
We report a new method for the conversion of nitroalkanes into carboxylic acids that achieves this transformation under very mild conditions. Catalytic amounts of iodide in combination with a simple zinc catalyst are needed to give good conversions into the corresponding carboxylic acids.
