10.1002/cctc.202000704
ChemCatChem
FULL PAPER
spectrum images 20 to 50 ms of dwell times have been used with 0.1
nm pixel size.
[1]
a) A. J. Marchi, J. L. G. Fierro, J. Santamaría, A. Monzón, Appl. Catal.
A-Gen. 1996, 142, 375- 386; b) P. Mäki-Avela, J. Hájek, T. Salmi, D.
Yu. Murzin, Appl. Catal. A-Gen. 2005, 292, 1-49; c) M. J. Suh, S. K.
Ihm, Top. Catal. 2010, 53, 447-454, d) X. M. Liu, G. Q. Lu, Z. F. Yan,
J. Beltramini, Ind. Eng. Chem. Res. 2003, 42, 6518-6530.
H2-TPR was conducted on an Autochem chemisorption analyzer
(Micromeritics), equipped with a TCD. Consumed H2 was driven from
the TCD signal after calibration. Before H2-TPR run, the solid was
activated up to its calcination temperature (from room temperature to
500 °C, heating ramp of 10 °C min-1, and isothermal time of 1 h) under
simulated air at a total flow rate of 50 mL min-1. After cooling down to
35 °C, the H2 containing flow was stabilized (50 mL min-1, 5.0 vol.% H2
in Ar) and the temperature-programmed reduction was performed (from
50 °C to 900 °C, with a temperature ramp of 10 °C min-1).
[2]
[3]
D. K. Mishra, A. A. Dabbawala, J. J. Park, S. H. Jhung, J. -S. Hwang,
Catal. Today, 2014, 232, 99-107.
a) L. Jiao, J. R. Regalbuto, J. Catal. 2008, 260, 342-350; b) N. Brodie-
Linder, R. Besse, F. Audonnet, S. LeCaer, J. Deschamps, M. Impéror-
Clerc, A. Simionesco, Microp. Mesop. Mater. 2010, 132, 518-525; c)
P. C. M. van Stiphout, D. E. Stobbe, F. T. V. D. Scheur, J. W. Geus,
Appl. Catal. 1988, 40, 219-246; d) J. R. A. Sietsma, J. D. Meeldijk, J.
P. den Breejen, M. Versluijs-Helder, A. J. van Dillen, P. E. de Jongh,
K. P. de Jong, Angew. Chem. 2007, 119, 4641-4633, Angew. Chem.
Int. Ed. 2007, 46, 4547-4549. e) R. M. Bullock, Science 2013, 342,
1054-1055; f) J. R. Ludwig, C. S. Schindler, Chem 2017, 2, 313-316.
a) J. R. A. Sietsma, H. Friedrich, A. Broersma, M. Versluijs-Helder, A.
J. van Dillen, P. E. de Jongh, K. P. de Jong, J. Catal. 2008, 260, 227-
235; b) H. Friedrich, J. R. A. Sietsma, P. E. de Jongh, A. J. Verkleij, K.
P. de Jong, J. Am. Chem. Soc. 2007, 129, 10249-10254; c) J. R. A.
Sietsma, J. D. Meeldijk, M. Versluijs-Helder, A. Broersma, A. J. van
Dillen, P. E. de Jongh, K. P. de Jong, Chem. Mater. 2008, 20, 2921-
2931; d) P. de Jong, P.E. de Jongh, Catal. Today 2011, 163, 27-32.
a) Z. Bian, I. Y. Suryawinata, S. Kawi, Appl.Catal. B: Environ. 2016,
195, 1-8; b) Z. Bian, Z. Li, J. Ashok, S. Kawi, Chem. Commun. 2015,
51, 16324-16326; c) J. Ashok, Z. Bian, Z. Wang, S. Kawi, Catal. Sci.
Technol. 2018, 8, 1730-1742; d) S. Das, J. Ashok, Z. Bian, N.
Dewangan, M.H. Wai, Y. Du, A. Borgna, K. Hidajat, S. Kawi, Appl.
Catal.B: Environ. 2018, 230, 220-236; e) J. Ashok, M.L. Ang,
P.Z.L.Terence, S. Kaw ChemCatChem, 2016, 8, 1308-1318, f) Z. Bian,
S. Kawi, ChemCatChem, 2018, 10, 320-328; g) J. W. Geus, Stud. Surf.
Sci. Catal. 1983, 16, 1-33; h) C. J. G. Van der Grift, A. Mulder, J.W.
Geus, Appl. Catal. 1990, 60, 181-192; i) P. Burattin, M. Che, C. Louis,
J. Phys. Chem. B 1998, 102, 2722-2732.
General Procedures for the catalytic hydrogenations of imines,
oximes and N-heterocycles under hydrogen pressure -
Heterocycles
Heterocycle reagent (0.7 mmol, 1 eq.), selected reduced catalyst
(0.0050 g) were introduced in an autoclave and dried under vacuum for
10 minutes. Under a nitrogen flow, the dry isopropanol solvent (4 mL)
was added. The autoclave was then filled with hydrogen at a pressure
of 50 bar after 3 purges. The reaction mixture was then heated at 80 °C
under stirring during the selected time (usually 13 hours). At the end of
the reaction, autoclave was cooled then degassed. The crude reaction
product was recovered after filtration over Celite and solvent evaporation
under vacuum. It was then directly purified by flash chromatography.
[4]
[5]
Imines: Imine reagent (0.7 mmol, 1 eq.), selected reduced catalyst
(0.0050 g) were introduced in an autoclave and dried under vacuum for
10 minutes. Under a nitrogen flow, the dry isopropanol solvent (4 mL)
was added. The autoclave was then filled with hydrogen at a pressure
of 10 bar after 3 purges. The reaction mixture was then heated at 80 °C
under stirring during the selected time (usually 13 hours). At the end of
the reaction, autoclave was cooled then degassed. The crude reaction
product was recovered after filtration over Celite and solvent evaporation
under vacuum. It was then directly purified by flash chromatography.
[6]
[7]
P. Burattin, M. Che, C. Louis, J. Phys. Chem. B 1997, 101, 7060-7074;
b) T. Lehman, T. Wolff, C. Hamel, P. Veit, B. Garke, A. Seidel-
Morgenstern, Microp. Mesop. Mater. 2012, 151, 113-125.
Oximes: Oxime reagent (0.7 mmol, 1 eq.), selected reduced catalyst
(0.0050 g) were introduced in an autoclave and dried under vacuum for
10 minutes. Under a nitrogen flow, the dry isopropanol solvent (4 mL)
was added. The autoclave was then filled with hydrogen at a pressure
of 20 bar after 3 purges. The reaction mixture was then heated at 80 °C
under stirring during the selected time (usually 36 hours). At the end of
the reaction, autoclave was cooled then degassed. The crude reaction
product was recovered after filtration over Celite and solvent evaporation
under vacuum. It was then directly purified by flash chromatography.
a) C. J. G. Van Der Grift, A. F. H. Wielers, B. P. J. Joghi, J. Van Beijnum,
M. De Boer, M. Versluijs-Helder, J. W. Geus, J. Catal. 1991, 131, 178-
189; b) Z. Huang, F. Cui, J. Xue, J. Zuo, J. Chen, C. Xia, Catal. Today
2012, 183, 42-51; c) L.F. Chen, P.J. Guo, M. H. Qiao, S.R. Yan, H.X.
Li, W. Shen, H. Xua, K. N. Fan, J. Catal. 2008, 257, 172-180; d) T.
Vrålstad, H.K. Magnusson, J. Sjöblom, Microp. Mesop. Mater. 2007,
106, 155-161; e) A. Loaiza-Gil, J. Arenas, M. Villarroel, F. Imbert, H.
del Castillo, B. Fontal, J. Mol. Catal. A: Chem. 2005, 228, 339-344.
J. C. Park, H. J. Lee, J. U. Bang, K. H. Park, H. Song, Chem. Commun.
2009, 7345-7347.
[8]
[9]
Acknowledgements
M. V. Sivaiah, S. Petit, J. Barrault, C. Batiot-Dupeyrat, S. Valange,
Catal. Today 2010, 157, 397-403.
The CNRS, the Chevreul Institute (FR 2638), the Ministère de
l’Enseignement Supérieur et de la Recherche, the Région
Hauts-de-France, the FEDER and Partenariat Hubert Curien -
Toubkal-No.18/40 are acknowledged for supporting and funding
partially this work. Dr. Stéphane Pronier (Institut de Chimie des
Milieux et des Matériaux de Poitiers - IC2MP- UMR CNRS
7285) are thanked for HRTEM, EDX analyses. Mrs Céline
Delabre (UCCS) is thanked for GC and GC–MS analyses. The
TEM facility in Lille (France) is supported by the Conseil
Regional du Nord-Pas de Calais and the European Regional
Development Fund (ERDF).
[10] M. V. Sivaiah, S. Petit, M. F. Beaufort, D. Eyidi, J. Barrault, C. Batiot-
Dupeyrat, S. Valange, Microp. Mesop. Mater. 2011, 140, 69-80.
[11] G. J. de A. A. Soler-Illia, E. L. Crepaldi, D. Grosso, C. Sanchez, Curr.
Opin. Colloid Interface Sci. 2003, 8, 109-126.
[12] C. Ciotonea, B. Dragoi, A. Ungureanu, A. Chirieac, S. Petit, S. Royer,
E. Dumitriu, Chem. Commun. 2013, 49, 7665-7667.
[13] Z. Bian, S. Kawi, Catal. Today 2020,339, 3-23.
[14] D. Y. Zhao, J. L. Feng, Q. S. Huo, N. Melosh, G. H. Fredrickson, B. F.
Chmelka, G. D. Stucky, Science 1998, 279, 548-552.
[15] H. Liu, H. Wang, J. Shen, Y. Sun, Z. Liu, Appl. Catal. A-Gen. 2008,
337,138-147.
[16] T. Wang, C. Liu, X. Ma, W. Zhu, X. Lv, H. Zhang, Nanomaterials 2019,
9, 998-1010.
[17] P. Burattin, M. Che, C. Louis, J Phys. Chem. B 1999, 103, 6171-6178.
[18] Z. Bian, S. Kawi, J.CO2 Util. 2017, 18, 345-352.
[19] J. C. Park, H. J. Lee, J. U. Bang, K. H. Park, H. Song, Chem. Commun.
2009, 7345–7347.
Keywords: Cobalt • Nickel • phyllosilicates • bimetallic
nanoparticles • hydrogenation
[20] P. Gallezot, D. Richard, Catal. Rev. Sci. Eng. 1998, 40, 81-126.
This article is protected by copyright. All rights reserved.