1015477-65-2

Upstream product

• 694-53-1 phenylsilane 
• 100-52-7 benzaldehyde 
• 100-51-6 benzyl alcohol 
• 18164-03-9 phenylsilane-d3 
• 98-13-5 Phenyltrichlorosilane 

Downstream Products

• 100-51-6 benzyl alcohol 

Relevant academic research and scientific papers

Coating of polydopamine on polyurethane open cell foams to design soft structured supports for molecular catalysts

Polydopamine-coated polyurethane open cell foams are used as structured supports for molecular catalysts through the covalent anchoring of alkoxysilyl arms by the catechol groups of the mussel-inspired layer. This strong bonding prevents their leaching. No alteration of the mechanical properties of the flexible support is observed after repeated uses of the catalytic materials.

Cp(Pri2MeP)FeH2SiR3: Nonclassical iron silyl dihydride

Reactions of a new borohydride complex 2 with hydrosilanes afford half-sandwich dihydride silyl complexes 3a-f. According to X-ray and DFT evidence complexes 3 have unprecedented double H·...H interligand interactions. Copyright

Efficient Solvent-Free Hydrosilylation of Aldehydes and Ketones Catalyzed by Fe2(CO)9/C6H4-o-(NCH2PPh2)2BH

An efficient solvent-free catalyst system for hydrosilylation of aldehydes and ketones was developed based on iron pre-catalyst Fe2(CO)9/C6H4-o-(NCH2PPh2)2BH. The reactions were tolerant of many functional groups and the corresponding alcohols were isolated in good to excellent yields following basic hydrolysis of the reaction products. The reaction is likely catalyzed by an in situ generated pincer ligated iron hydride complex. Graphic Abstract: [Figure not available: see fulltext.]

Synthesis and catalytic activity of N-heterocyclic silylene (NHSi) iron (II) hydride for hydrosilylation of aldehydes and ketones

A novel silylene supported iron hydride [Si, C]FeH (PMe3)3 (1) was synthesized by C (sp3)-H bond activation with zero-valent iron complex Fe (PMe3)4. Complex 1 was fully characterized by spectroscopic methods and single crystal X-ray diffraction analysis. To the best of our knowledge, 1 is the first example of silylene-based hydrido chelate iron complex produced through activation of the C (sp3)?H bond. It was found that complex 1 exhibited excellent catalytic activity for hydrosilylation of aldehydes and ketones. The catalytic system showed good tolerance and catalytic activity for the substrates with different functional groups on the benzene ring. It is worth mentioning that, the experimental results showed that both ketones and aldehydes could be reduced in good to excellent yields under the same catalytic conditions. Based on the experiments and literature reports, a possible catalytic mechanism was proposed.

Seeking Heteroatom-Rich Compounds: Synthetic and Mechanistic Studies into Iron Catalyzed Dehydrocoupling of Silanes

A detailed synthetic investigation into the dehydrocoupling of silanes with amines, phosphines, and alcohols using an iron precatalyst (1) is presented. We have furnished over 30 examples of aminosilane synthesis along with kinetic studies using MeBnNH and MePhSiH2 as coupling partners. The kinetic studies suggest a reversible reaction with silane which generates aminosilane and an Fe-hydride dimer that undergoes rate-limiting protonolysis with amine with N-H bond cleavage in the transition state, consistent with a primary KIE of 2.42(3). The presence of dimers as on-cycle intermediates was analyzed in depth. Beyond this we have explored the substrate scope of phosphinosilane formation which shows a preferential heterodehydrocoupling to give the phosphinosilane with primary and secondary silanes. Silylethers can also be prepared and alcohols that contain alkene functionality do not show any tendency to reduce the double bond.

Hydrosilylation of Aldehydes and Ketones Catalysed by Bis(phosphinite) Pincer Platinum Hydride Complexes

Bis(phosphinite) pincer platinum hydride complexes, [2,6-(R2PO)2C6H3]PtH (R=tBu, iPr), were synthesized, characterized and applied to the hydrosilylation of aldehydes and ketones. NMR study and single crystal X-ray diffraction analysis indicated that the hydrides in these two platinum complexes are comparatively less hydridic: down-field 1H NMR resonances (0.71 and 0.98 ppm) and weak Pt?H interactions were observed. Both the platinum complexes were found to be good catalysts for the hydrosilylation of aldehydes and ketones with phenylsilane. The corresponding alcohols were isolated in good to excellent yields following basic hydrolysis of the resultant hydrosilylation products and turnover frequencies (TOFs) up to 3200 h?1 were achieved at 60 °C in toluene, which are much higher than those of the hydrosilylation catalysed by the corresponding nickel pincer hydride complexes. A possible mechanism for the present hydrosilylation process was discussed. (Figure presented.).

Formation of Zn-Zn and Zn-Pd Bonded Complexes by Reactions of Terminal Zinc Hydrides with Pd(II) Species

Divalent palladium-induced homocoupling of terminal zinc hydrides to zinc-zinc bonded complexes was achieved herein. Reactions of zinc hydrides [LZnH] (L = CH3C(2,6-iPr2C6H3N)CHC(CH3)(N(CH2)nCH2PPh2); 1a: n = 1; 1b: n = 2) with 0.5 equiv of allyl(cyclopentadienyl)palladium(II) afforded heterotrinuclear [Zn2Pd] complexes 3 containing direct Zn-Zn and Zn-Pd bonds, with concomitant elimination of propylene and cyclopentadiene. Complexes 3 were also accessed by the reactions of zinc hydrides 1 with allylpalladium(II) chloride with release of propylene and hydrogen chloride. Treatment of zinc hydrides 1 with 1 equiv of allyl(cyclopentadienyl)palladium(II) gave Zn-Pd bonded complex 5 by elimination of propylene, which can be transformed into heterotrinuclear complex 3 by further reaction with one additional molar equivalent of zinc hydrides. Heterobimetallic Zn-Pd complex 5b was found to be an effective catalyst in the hydrosilylation of benzaldehyde and its derivatives. Reaction of 5b with silane reagent Ph2SiH2 produced [Pd2Si2H2] complex 8 with cleavage of the Pd-Zn bond, which served as an initiating species in the catalytic reaction. Complexes 4b, 5, and 8 in this study were characterized by X-ray diffraction.

POCN Ni(ii) pincer complexes: Synthesis, characterization and evaluation of catalytic hydrosilylation and hydroboration activities

A series of iminophosphinite POCN pincer Ni(ii) complexes, (POCN)NiMe and (POCN)NiLn(BX4) (L = CH3CN, n = 0, 1; X = F, Ph, C6F5), have been developed and subjected to catalytic hydrosilylation of alkenes, aldehydes and ketones and hydroboration of carbonyl compounds. The stoichiometric reactivity of (POCN)NiMe and (POCN)Ni(BF4) with PhSiH3 and HBPin suggests that catalytic reactions proceed via the hydride intermediate (POCN)NiH. With regard to reactions with HBPin, efficient and mild hydroboration of a variety of carbonyl compounds, including highly chemoselective hydroboration of benzaldehyde in the presence of other common potent reductive functional groups, such as alkenes, alkynes, esters, amides, nitriles, nitro compounds and even ketones, and the first example of base metal catalyzed hydroboration of amides, including mild direct hydroborative reduction of primary and secondary amides to borylated amines were demonstrated for (POCN)NiMe.

Selective C-F and C-H Activation of Fluoroarenes by Fe(PMe3)4 and Catalytic Performance of Iron Hydride in Hydrosilylation of Carbonyl Compounds

The reactions of perfluorinated toluene (CF3C6F5), pentafluoropyridine (C5NF5), and hexafluorobenzene (C6F6) with the iron(0) complex Fe(PMe3)4 were investigated. The Fe(I) complexes (4-CF3C6F4)Fe(PMe3)4 (1), (4-C5NF4)Fe(PMe3)4 (2), and (C6F5)Fe(PMe3)4 (3) were obtained by selective activation of the C-F bonds. However, under similar reaction conditions, the reaction of Fe(PMe3)4 with perfluoronaphthalene (C10F8) afforded a π-coordinated Fe(0) complex, (η4-1,2,3,4-C10F8)Fe(PMe3)3 (4), and the expected C-F bond activation reaction was not observed. The expected iron hydride (C6F5)FeH(PMe3)4 (6) could be obtained in a yield of 80% by the reaction of bromopentafluorobenzene with Fe(PMe3)4 and subsequent reduction with NaBH4. The molecular structures of complexes 2, 4, and 6 were determined by single-crystal X-ray diffraction. Complexes 1-4 and 6 could be used as catalysts for the hydrosilylation of carbonyl compounds. Among them, complex 6 is the best catalyst. The selective reduction of carbonyl groups of α,β-unsaturated aldehydes and ketones was also realized with 6 as catalyst.

Hydridosilylamido complexes of Ta and Mo isolobal with Berry's zirconocenes: Syntheses, β-Si-H agostic interactions, catalytic hydrosilylation, and insight into mechanism

The syntheses of novel Group 5 and Group 6 hydrosilylamido complexes of the type R(ArN)M{N(tBu)SiMe2-H}X (M = Ta, R = Cp; M = Mo, R = ArN; X = Cl, H, OBn, Me) are described. The various substituents in the X position seem to play the