1124-52-3Relevant articles and documents
Application of chemical shifts in 1H and 13C NMR spectra to configuration assignment of Schiff bases in the liquid phase
Afonin,Pavlov,Ushakov,Levanova,Levkovskaya
, p. 1117 - 1121 (2013)
In 1H and 13C NMR spectra of N-substituted dimethylketimines chemical shifts of protons and carbon atoms of the methyl groups in the cis-position with respect to the unshared electron pair of the nitrogen are larger than those of the CH3 groups in the trans-position by 0.2-0.4 and 8-11 ppm respectively. This effect is accompanied by the reduction of the corresponding direct spin-spin coupling constant 13C-13C by 10 Hz. The experimental trends in the variation of the spectral parameters are well reproduced by ab initio quantum-chemical calculations. The discovered stereochemical dependence of the chemical shifts of 1H and 13C may underlie a simple and efficient method of the configuration assignment in various compounds with a C=N bond.
Uncatalysed Domino Reaction in Hexafluoroisopropanol: A Simple Protocol for the Synthesis of Tetrahydroquinoline Derivatives
Di Salvo, Andrea,Spanedda, Maria Vittoria,Ourevitch, Michele,Crousse, Benoit,Bonnet-Delpon, Daniele
, p. 2231 - 2235 (2003)
A range of tetrahydroquinolines were synthesised in excellent yields through a domino reaction performed in hexafluoropropanol, starting from anilines and enol ethers and in the absence of Lewis acid catalysis. This solvent was shown to promote the nucleophilic addition of anilines to enol ethers as well as the aza-Diels-Alder reaction.
The preparation and photocatalytic activity of Ag-Pd/g-C3N4 for the coupling reaction between benzyl alcohol and aniline
Ma, Jingjing,Yu, Xiujuan,Liu, Xiaoling,Li, Haiying,Hao,Li, Jingyi
, (2019)
In this study, the carrier g-C3N4 was prepared by melamine, and the Ag-Pd/g-C3N4 catalyst was synthesized by the NaBH4 reduction method. Different characterization techniques, including SEM, TEM, XRD, UV–vis DRS, XPS, photoluminescence spectra (PL) and BET, were employed to investigate the morphology and optical properties of the as-prepared samples. The Ag-Pd/g-C3N4 catalyst was used for the synthesis of imine from a benzyl alcohol and aniline. The results show that when the total loading of Ag and Pd is 2 wt%, and the mass ratio of Ag and Pd is 1:1, the activity of the catalyst is the highest (The highest conversion of aniline is 86.7% and the product selectivity is >99%.). The reaction is optimized by changing the type of solvent, the type and amount of base, the type of catalyst, and the amount of reactants. The optimal reaction conditions are 6 ml of n-hexane, 1.4 mmol of Cs2CO3, 50 mg of the Ag-Pd/g-C3N4 (2 wt%, 1:1), and 2:1 mol ratio of benzyl alcohol and aniline. Under optimal reaction conditions, alcohol derivatives and amine derivatives were investigated to determine the suitable range of the catalyst for alcohols and amines. Then, the effects of different light intensities and wavelengths on the reaction were explored. Additionally, the catalyst's recycling ability was tested, and it was found to be relatively stable. The effect of reactive groups on the mechanism shows that the reaction is mainly achieved by the synergy between h+, e? and ·O2?.
Carbon dioxide-promoted selective reductive amination of aliphatic ketones with aniline and hydrogen using a Pt/C catalyst
Ichikawa, Shinichiro,Seki, Tsunetake,Ikariya, Takao
, p. 1628 - 1629 (2012)
Product selectivity in the reductive amination of aliphatic ketones with aniline and H2 using a 5% Pt/C catalyst was improved remarkably in the presence of CO2. The CO formed in situ by the reverse watergas shift reaction selectively poisoned the Pt sites active for undesired side reactions.
Ultrasound-assisted construction of a Z-scheme heterojunction with g-C3N4 nanosheets and flower-like Bi2WO6 microspheres and the photocatalytic activity in the coupling reaction between alcohols and amines under visible light irradiation
Hao, Xueli,Li, Enbo,Li, Haiying,Li, Jingyi,Wang, Yan,Wang, Zhibao,Yu, Xiujuan,Zhang, Zhiying
, (2020)
Flower-like Bi2WO6 microspheres and bulk g-C3N4 were prepared by the hydrothermal method and high-temperature calcining method, respectively. A new method based on the combination of ultrasonic stripping and mechanical stirring was used to obtain uniform composite x-Bi2WO6/g-C3N4 (x is the Bi2WO6 mass ratio) photocatalysts with a Z-scheme heterojunction. In the reaction of benzyl alcohol and aniline to form imine, the optimal composite, 30percent-Bi2WO6/g-C3N4, showed a conversion rate of 87.6percent, which is much higher than that of pure Bi2WO6 and g-C3N4. Characterization by SEM and TEM showed that the ultrasonically stripped g-C3N4 significantly reduced the radial dimension compared to bulk g-C3N4. A uniformly dispersed photocatalytic material was formed, and it maintained a flower-like microsphere structure. Materials characterized by N2 adsorption–desorption isotherms (BET) showed that the specific surface area of the g-C3N4 nanosheets increased by approximately ten times after ultrasonic stripping. The photostability of the composite was verified by cyclic experiments. Under visible light irradiation, the activation energy of the coupling reaction between benzyl alcohol and aniline was found to be decreased by 29.8 kJ mol?1. A capture experiment was used to verify the active species in the photocatalytic system, with the reaction found to be mainly completed through the synergistic action of h+, e? and ?O2?.
Aluminosilicates with different pores structure in the synthesis of 2,2,4-trimethyl-1,2-dihydroquinoline and N-phenyl-2-propanimine
Grigor’eva,Filippova,Gataulin,Bubennov,Agliullin,Kutepov,Narender, Nama
, (2017)
Physicochemical characteristics of microporous zeolites of various structural type (FAU, BEA, MTW), micro-meso-macroporous zeolite (H-Ymmm), and mesoporous aluminosilicate (ASM) were studied. Their catalytic activity in the reaction of aniline with aceton
Room-temperature copper-catalyzed electrophilic amination of arylcadmium iodides with ketoximes
Korkmaz, Adem
, p. 3119 - 3125 (2021/05/10)
We started our study by preparation two ketoximes. Later, there were studies to reveal these ketoximes' effects in the electrophilic amination reaction with organocadmium reagents. Primarily, it was observed that arylcadmium iodides could not be reacted with ketoximes at room temperature in the absence of a catalyst. CuCN was a suitable catalyst for this electrophilic amination reaction of arylcadmium iodides and allowed the preparation of functionalized aniline derivatives in good yields under mild reaction conditions. We obtained the results indicated that the yield of primary arylamines was strongly dependent on the steric and electronic effects of organocadmium reagent and amination agent. In the case of both amination reagents, meta-substituted arylamines were obtained in higher yields than para-substituted arylamines. We observed that acetone O-(4-chlorophenylsulfonyl)oxime, 1, as an aminating agent, was more successful than acetone O-(2-Naphthylsulfonyl)oxime, 2, in the synthesis of functionalized arylamines by electrophilic amination of corresponding aryl cadmium iodides. In this method, there is no cadmium release to the environment.
Reductive amination of ketones/aldehydes with amines using BH3N(C2H5)3as a reductant
Zou, Qizhuang,Liu, Fei,Zhao, Tianxiang,Hu, Xingbang
supporting information, p. 8588 - 8591 (2021/09/04)
Herein, we report the first example of efficient reductive amination of ketones/aldehydes with amines using BH3N(C2H5)3 as a catalyst and a reductant under mild conditions, affording various tertiary and secondary amines in excellent yields. A mechanistic study indicates that BH3N(C2H5)3 plays a dual function role of promoting imine and iminium formation and serving as a reductant in reductive amination. This journal is
Copper-Catalyzed Intramolecular Amination of C(sp3)-H Bond of Secondary Amines to Access Azacycles
Jin, Ruo-Xing,Dai, Jing-Cheng,Li, Yan,Wang, Xi-Sheng
supporting information, p. 421 - 426 (2021/01/26)
The cross-coupling of C-N bond directly from inert C-H bonds is an ideal approach to synthesize saturated azacycles due to its high efficiency and atom economy. In this article, a copper-catalyzed intramolecular amination via the cross coupling of C(sp3)-H and N-H bonds of secondary amine has been reported, which exhibit excellent chemo- and regioselectivity, extensive substrate scope, and functional group tolerance in good to excellent yield, offering an efficient pathway to build nitrogen-containing heterocycle skeletons.
Cu/Ni-doped sulfated zirconium oxide immobilized on CdFe2O4 NPs: a cheap, sustainable and magnetically recyclable inorgano-catalyst for the efficient preparation of α-aminonitriles in aqueous media
Nasseri, Mohammad Ali,Ramezani-Moghadam, Simin,Kazemnejadi, Milad,Allahresani, Ali
, p. 4233 - 4256 (2020/07/08)
Abstract: A new multifunctional bimetallic nanocatalyst was prepared by immobilization of Cu/Ni-doped sulfated zirconium oxide on magnetic cadmium ferrite (CdFe2O4@SiO2@ZrO2/SO42?/Cu/Ni) and used as an efficient recyclable catalyst for one-pot as well as stepwise preparation of α-aminonitriles under mild conditions. The magnetic nanocatalyst was characterized by FTIR, TGA, VSM, XRD, EDX, FE-SEM, and TEM analyses. Also, the surface acidity of the catalyst was measured by pyridine adsorption assay. The catalyst possesses various active sites which could catalyst a variety of aromatic and aliphatic aldehydes to the corresponding α-amionitriles under moderate to high yields in the presence of aniline. Furthermore, transformation of ketones to the desired α-amionitriles and some bis-aminonitriles was also performed by this method. The catalyst could be readily recovered from the reaction mixture and reused for several times without significant loss of activity. Graphic abstract: A general and efficient method has been developed for transformation of a variety of aliphatic, aromatic aldehydes and ketones to the corresponding α-aminonitriles using a multifunctional recyclable CdFe2O4@SiO2@ZrO2/SO42?/Cu/Ni nanocatalyst.[Figure not available: see fulltext.]
