7495-84-3Relevant academic research and scientific papers
Iridium-Catalyzed Amidation of in Situ Prepared Silyl Ketene Acetals to Access α-Amino Esters
Chang, Sukbok,Gwon, Yunyeong,Kim, Dongwook,Lee, Minhan
supporting information, p. 1088 - 1093 (2022/02/10)
Disclosed herein is a convenient Ir-catalyzed amidation of esters to access α-amido esters. Initially prepared silyl ketene acetals are directly employed, without separate purification, for subsequent amidation with an oxycarbonylnitrenoid precursor using the Cp*(LX)Ir(III) catalyst. The α-amidation was facile for both α-aryl and α-alkyl esters. Density functional theory studies revealed that the generation of a putative Ir-nitrenoid is facilitated by the chelation of the countercation additive during the N-O bond cleavage of the nitrene precursor.
Electrodimerization of N-Alkoxyamides for Zinc(II) Catalyzed Phenolic Ester Synthesis under Mild Reaction Conditions
Subramanian, Kripa,Yedage, Subhash L.,Bhanage, Bhalchandra M.
, p. 2511 - 2521 (2018/05/14)
An electrochemical On-Off method for phenolic ester synthesis from N-alkoxyamides has been reported. This one-pot protocol begins with rapid and selective electrodimerization of the amide using n-Bu4NI (TBAI) as an electrocatalyst. The reaction proceeds further in the absence of current via Zn catalyzed C?N bond activation of the amide dimer followed by its coupling with phenol to form the ester. The present methodology is ligand-free and takes place under mild reaction conditions. This transformation incorporates a wide variety of phenols and amide substrates leading to the formation of functionalized esters highlighting its versatility. (Figure presented.).
How much does the hybridization of a carbon atom affect the transmission of the substituent effect on the chemical shift?
Jeong, Eun Jeong,Lee, In-Sook Han
, p. 295 - 299 (2015/03/03)
1H and 13C NMR spectra of aryl esters of propionic acid, acrylic acid, and propiolic acid were systematically examined to find out the substituent effect on the chemical shift. The values of the chemical shift of the carbonyl carbon showed an inverse correlation with the Hammett ?3 values, and the magnitude of the slope was the largest with the propiolates. The ?± carbons of acrylates and propiolates also showed an inverse correlation with much smaller values of the slopes than those of the carbonyl carbons; but those of the propionates showed absolutely no correlation. However, the ?2 carbons of acrylates and propiolates showed normal correlation with larger values of the slopes. The signs and the magnitudes of the slopes may be understood by the transmission of the substituent electronic effect through bonds as well as through space. The propiolyloxy group also showed a significantly large effect on the 13C chemical shift values of the benzene ring.
Active and deactive modes of modified montmorillonite in p-cresol acylation
Venkatesha,Chandrashekara,Jai Prakash,Bhat
, p. 181 - 187 (2014/06/24)
para-Toluene sulphonic acid (p-TSA)-treated montmorillonite clay used as heterogeneous catalyst in acylation of para-cresol (PC) with aliphatic carboxylic acids. Reactions were studied under microwave and conventional modes of heating and reaction conditions were optimized by varying mole ratio, temperature, amount of catalyst and reaction time. Under optimized conditions the reaction was carried out involving p-cresol and decanoic acid. The reaction involved two steps, O-acylation involving ester formation followed by the Fries rearrangement involving C-acylation resulting in ketone product. Microwave heating mode showed higher conversion and the catalytic activity almost retained in repeated use. On the other hand the catalytic activity dropped by more than 50% in the case of conventional heating indicating rapid deactivation. A change in the color of the used catalyst was more intense in the case of conventional than in the microwave heating. Used catalysts were characterized for surface area and pore volume by BET technique, acidity by FTIR spectroscopy and amount of coke by TGA. Further investigations on the catalyst used in conventional heating revealed that the deactivation occurred during the O-acylation and not in the subsequent Fries rearrangement. However, the catalyst in the microwave irradiated reaction, exhibited a retarded rate of formation of coke precursors on the surface during O-acylation, thus preventing any decrease in catalytic activity. Present study indicates that the technique chosen for heating the reaction medium plays an important role in suppressing deactivation.
Microwave-induced deactivation-free catalytic activity of BEA zeolite in acylation reactions
Chandra Shekara,Jai Prakash,Bhat
scheme or table, p. 101 - 107 (2012/07/14)
Solventless liquid-phase acylation of p-cresol with different aliphatic carboxylic acids like acetic, propionic, butyric, hexanoic, octanoic, and decanoic acids was investigated over BEA zeolite under conventional as well as microwave heating. An unanticipated huge difference in activity was observed between two modes of heating. Under conventional heating, conversion of all the acids was less than 20%, while under microwave heating, the conversion was in the range of 50-80%. Ester formed through O-acylation and ortho-hydroxyketone formed through Fries rearrangement of the ester were the only products. Conversion of carboxylic acid increased with chain length up to hexanoic acid and then it showed a decrease in the trend. With all the acids, O-acylation occurred rapidly followed by slow conversion to ortho-hydroxyketone. The ketone/ester ratio increased with catalyst amount, temperature, and reaction time. Used catalyst samples were characterized by TGA, XRD, and IR studies to understand lower activity and deactivation behavior under conventional heating. The results showed absence of coke precursor/coke on the catalyst used in microwave-irradiated reactions in contrast to catalyst used in conventionally heated ones. Higher yield in the case of microwave-assisted reactions is attributed to the prevention of coke precursor/coke on the active sites by microwaves.
Intramolecular ketone-olefin radical cyclization with low-valent titanium reagent: Synthesis of benzopyrans
Nayak, Sandip K.,Bhatt, Suchitra,Roy, Kshama
scheme or table, p. 2969 - 2975 (2010/11/05)
A novel protocol for intramolecular ketyl-olefin radical cyclization with low-valent titanium reagent is outlined. It allows the formation of the benzopyran nucleus from ortho-allyloxy propiophenones as the sole product in moderate yields via intramolecular radical cyclization. Copyright Taylor & Francis Group, LLC.
Erbium(III) chloride: A very active acylation catalyst
Dalpozzo, Renato,De Nino, Antonio,Maiuolo, Loredana,Oliverio, Manuela,Procopio, Antonio,Russo, Beatrice,Tocci, Amedeo
, p. 75 - 79 (2008/02/10)
Erbium(iii) chloride is a powerful catalyst for the acylation of alcohols and phenols. The reaction works well for a large variety of simple and functionalized substrates by using different kinds of acidic anhydrides (Ac 2O, (EtCO)2O, (PriCO)2O, (Bu tCO)2O, and (CF3CO)2), without isomerization of chiral centres. Moreover, the catalyst can be easily recycled and reused without significant loss of activity. CSIRO 2007.
Direct esterification of carboxylic acids with p-cresol catalysed by acid activated Indian bentonite
Vijayakumar,Iyengar, Pushpa,Nagendrappa, Gopalpur,Prakash, B.S. Jai
, p. 1950 - 1953 (2007/10/03)
Acid activated Indian bentonite (AAIB) catalyst is used for the first time to esterify various carboxylic acids with p-cresol in average to excellent yields. Optimisation studies have been carried out for p-cresyl stearate synthesis. The catalyst is recoverable and recyclable.
Rate of Enolate Formation Is Not Very Sensitive to the Hydrogen Bonding Ability of Donors to Carboxyl Oxygen Lone Pair Acceptors; A Ramification of the Principle of Non-Perfect Synchronization for General-Base-Catalyzed Enolate Formation
Zhong, Zhenlin,Snowden, Timothy S.,Best, Michael D.,Anslyn, Eric V.
, p. 3488 - 3495 (2007/10/03)
Two series of structures (1 and 2) possessing intramolecular hydrogen bonds to the lone-pair electrons of carbonyl oxygens have been examined to reveal the influence of the pKa of the hydrogen-bond donor on the rate of general-base-catalyzed enolate formation. The geometry of the hydrogen bonds is well accepted to be appropriate for intramolecular hydrogen-bond formation. Yet, as revealed by Bronsted plots, both series show very little dependence of the rate of enolate formation on the hydrogen-bond donor ability. The intramolecular hydrogen bonds give rate enhancements only on the order of 10-100-fold, and corrected Bronsted α-values are slightly below 0.1. The results can be understood by interpreting them in light of the Principle of Non-Perfect Synchronization. The results are consistent with the proton transfer occurring through an asynchronous transition state with the developing negative charge localized on carbon. We postulate that catalysts of enolate formation will be most effective if the binding groups are focused on stabilizing negative charge that is forming on the enolate carbon rather than on the enolate oxygen.
Erbium(III) triflate as an extremely active acylation catalyst
Procopio, Antonio,Dalpozzo, Renato,De Nino, Antonio,Maiuolo, Loredana,Russo, Beatrice,Sindona, Giovanni
, p. 1465 - 1470 (2007/10/03)
Erbium(III) triflate is a powerful catalyst for the acylation of alcohols and phenols. The reaction works well for a large variety of simple and functionalized substrates by using different kinds of acidic anhydrides {Ac 2O, (EtCO)2O, [(CH3)3CO] 2O, Bz2O, and (CF3CO)2O} without isomerisation of chiral centres. Moreover, the catalyst can be easily recycled and reused without significant loss of activity.
