4780-79-4Relevant articles and documents
The lewis base-catalyzed silylation of alcohols-a mechanistic analysis
Patschinski, Pascal,Zhang, Cong,Zipse, Hendrik
, p. 8348 - 8357 (2014)
Reaction rates for the base-catalyzed silylation of primary, secondary, and tertiary alcohols depend strongly on the choice of solvent and catalyst. The reactions are significantly faster in Lewis basic solvents such as dimethylformamide (DMF) compared with those in chloroform or dichloromethane (DCM). In DMF as the solvent, the reaction half-lives for the conversion of structurally similar primary, secondary, and tertiary alcohols vary in the ratio 404345:20232:1. The effects of added Lewis base catalysts such as 4-N,N-dimethylaminopyridine (DMAP) or 4-pyrrolidinopyridine (PPY) are much larger in apolar solvents than in DMF. The presence of an auxiliary base such as triethylamine is required in order to drive the reaction to full conversion.
Leaving Group Effects on the Selectivity of the Silylation of Alcohols: The Reactivity-Selectivity Principle Revisited
Patschinski, Pascal,Zipse, Hendrik
, p. 3318 - 3321 (2015)
TBS protection of primary alcohol naphthalen-1-ylmethanol (4a) and secondary alcohol 1-(naphthalen-1-yl)ethanol (4b) has been studied under various reaction conditions. The primary/secondary selectivity is largest in the comparatively slow Lewis base catalyzed silylation in apolar solvents and systematically lower in DMF. Lowest selectivities (and fastest reaction rates) are found for TBS triflate 1b, where only minor effects of solvent polarity or Lewis base catalysis can be observed. (Chemical Equation Presented).
Supported Iridium Catalyst for Clean Transfer Hydrogenation of Aldehydes and Ketones using Methanol as Hydrogen Source
Zhu, Longfei,Ye, Sen,Wang, Jing,Zhu, Jiazheng,He, Guangke,Liu, Xiang
, (2022/02/01)
The use of methanol as abundant and low-toxic hydrogen source under mild and clean conditions is promising for the development of safe and sustainable reduction processes, but remains a daunting challenge. This work presents a recyclable ZnO-supported Ir
Chemoselective Cleavage of Acylsulfonamides and Sulfonamides by Aluminum Halides
Sang, Dayong,Dong, Bingqian,Liu, Yunfeng,Tian, Juan
, p. 3586 - 3595 (2022/02/25)
The chemoselective cleavage of C-N bonds of amides, sulfonamides, and acylsulfonamides by aluminum halides is described. AlCl3and AlI3display complementary reactivities toward N-alkyl and N-acyl moieties. N-Alkylacylsulfonamides, sec
A Bifunctional Copper Catalyst Enables Ester Reduction with H2: Expanding the Reactivity Space of Nucleophilic Copper Hydrides
Kaicharla, Trinadh,Ngoc, Trung Tran,Teichert, Johannes F.,Tzaras, Dimitrios-Ioannis,Zimmermann, Birte M.
supporting information, p. 16865 - 16873 (2021/10/20)
Employing a bifunctional catalyst based on a copper(I)/NHC complex and a guanidine organocatalyst, catalytic ester reductions to alcohols with H2 as terminal reducing agent are facilitated. The approach taken here enables the simultaneous activation of esters through hydrogen bonding and formation of nucleophilic copper(I) hydrides from H2, resulting in a catalytic hydride transfer to esters. The reduction step is further facilitated by a proton shuttle mediated by the guanidinium subunit. This bifunctional approach to ester reductions for the first time shifts the reactivity of generally considered "soft"copper(I) hydrides to previously unreactive "hard"ester electrophiles and paves the way for a replacement of stoichiometric reducing agents by a catalyst and H2.
Efficient and chemoselective hydrogenation of aldehydes catalyzed by well-defined PN3-pincer manganese(ii) catalyst precursors: An application in furfural conversion
Gholap, Sandeep Suryabhan,Dakhil, Abdullah Al,Chakraborty, Priyanka,Li, Huaifeng,Dutta, Indranil,Das, Pradip K.,Huang, Kuo-Wei
supporting information, p. 11815 - 11818 (2021/11/30)
Well-defined and air-stable PN3-pincer manganese(ii) complexes were synthesized and used for the hydrogenation of aldehydes into alcohols under mild conditions using MeOH as a solvent. This protocol is applicable for a wide range of aldehydes containing various functional groups. Importantly, α,β-unsaturated aldehydes, including ynals, are hydrogenated with the CC double bond/CC triple bond intact. Our methodology was demonstrated for the conversion of biomass derived feedstocks such as furfural and 5-formylfurfural to furfuryl alcohol and 5-(hydroxymethyl)furfuryl alcohol respectively.
Synthesis, crystal and structural characterization, Hirshfeld surface analysis and DFT calculations of three symmetrical and asymmetrical phosphonium salts
Delaram, Behnaz,Gholizadeh, Mostafa,Makari, Faezeh,Nokhbeh, Seyed Reza,Salimi, Alireza
, (2021/07/01)
Three stable phosphonium salts of 1,4-butanediylebis(triphenylphosphonium) dibromide I, butane-4?bromo-1-(triphenylphosphonium) bromide II and 1,3-propanediylbis(triphenylphosphonium) tetrahydroborate III were synthesized and structurally characterized. Single crystal X-ray diffraction analysis, spectroscopic methods and thermal analysis methods were used for the characterization of titled compounds. Crystallographic data showed that compound I crystallized in the triclinic crystal system with Pī space group and compound II crystallized in the monoclinic crystal system with P21/c space group. The crystal packing structures of I and II were stabilized by various intermolecular interactions, especially of C–H···π contacts. The molecular Hirshfeld surface analysis and 2D fingerprint revealed that the C···H contacts have 24.3% and 18.4% contributions in the crystal packings of compounds I and II, respectively. In addition, the H···Br (28.5%) contact has a considerable contribution to the crystal architecture of compound II. Theoretical studies were performed by DFT method to investigate the structural properties of the titled compounds. The isotopic ratio of boron in tetrahydroborate anion of compound III calculated by 1H NMR spectroscopy. The isotopic ratio for 10B/11B was 19.099 / 80.900%. Reduction of some carbonyl compounds to corresponding alcohols was performed by compound III and the optimum conditions were determined.
Dual utility of a single diphosphine-ruthenium complex: A precursor for new complexes and, a pre-catalyst for transfer-hydrogenation and Oppenauer oxidation
Mukherjee, Aparajita,Bhattacharya, Samaresh
, p. 15617 - 15631 (2021/05/19)
The diphosphine-ruthenium complex, [Ru(dppbz)(CO)2Cl2] (dppbz = 1,2-bis(diphenylphosphino)benzene), where the two carbonyls are mutually cis and the two chlorides are trans, has been found to serve as an efficient precursor for the synthesis of new complexes. In [Ru(dppbz)(CO)2Cl2] one of the two carbonyls undergoes facile displacement by neutral monodentate ligands (L) to afford complexes of the type [Ru(dppbz)(CO)(L)Cl2] (L = acetonitrile, 4-picoline and dimethyl sulfoxide). Both the carbonyls in [Ru(dppbz)(CO)2Cl2] are displaced on reaction with another equivalent of dppbz to afford [Ru(dppbz)2Cl2]. The two carbonyls and the two chlorides in [Ru(dppbz)(CO)2Cl2] could be displaced together by chelating mono-anionic bidentate ligands, viz. anions derived from 8-hydroxyquinoline (Hq) and 2-picolinic acid (Hpic) via loss of a proton, to afford the mixed-tris complexes [Ru(dppbz)(q)2] and [Ru(dppbz)(pic)2], respectively. The molecular structures of four selected complexes, viz. [Ru(dppbz)(CO)(dmso)Cl2], [Ru(dppbz)2Cl2], [Ru(dppbz)(q)2] and [Ru(dppbz)(pic)2], have been determined by X-ray crystallography. In dichloromethane solution, all the complexes show intense absorptions in the visible and ultraviolet regions. Cyclic voltammetry on the complexes shows redox responses within 0.71 to -1.24 V vs. SCE. [Ru(dppbz)(CO)2Cl2] has been found to serve as an excellent pre-catalyst for catalytic transfer-hydrogenation and Oppenauer oxidation.
Visible Light Induced Reduction and Pinacol Coupling of Aldehydes and Ketones Catalyzed by Core/Shell Quantum Dots
Xi, Zi-Wei,Yang, Lei,Wang, Dan-Yan,Feng, Chuan-Wei,Qin, Yufeng,Shen, Yong-Miao,Pu, Chaodan,Peng, Xiaogang
, p. 2474 - 2488 (2021/02/05)
We present an efficient and versatile visible light-driven methodology to transform aryl aldehydes and ketones chemoselectively either to alcohols or to pinacol products with CdSe/CdS core/shell quantum dots as photocatalysts. Thiophenols were used as proton and hydrogen atom donors and as hole traps for the excited quantum dots (QDs) in these reactions. The two products can be switched from one to the other simply by changing the amount of thiophenol in the reaction system. The core/shell QD catalysts are highly efficient with a turn over number (TON) larger than 4 × 104 and 4 × 105 for the reduction to alcohol and pinacol formation, respectively, and are very stable so that they can be recycled for at least 10 times in the reactions without significant loss of catalytic activity. The additional advantages of this method include good functional group tolerance, mild reaction conditions, the allowance of selectively reducing aldehydes in the presence of ketones, and easiness for large scale reactions. Reaction mechanisms were studied by quenching experiments and a radical capture experiment, and the reasons for the switchover of the reaction pathways upon the change of reaction conditions are provided.
Ruthenium(II) Complex of a Tridentate Azoaromatic Pincer Ligand and its Use in Catalytic Transfer Hydrogenation of Aldehydes and Ketones with Isopropanol
Saha, Tanushri,Prasad Rath, Santi,Goswami, Sreebrata
, p. 1455 - 1461 (2021/05/18)
In this work, a new Ru(II) complex with the redox-active pincer 2,6-bis(phenylazo)pyridine ligand (L) is reported which acts as a metal-ligand bifunctional catalyst for transfer hydrogenation reactions. The isolated complex [(L)Ru(PMe2Ph)2(CH3CN)](ClO4)2; [1](ClO4)2 is characterized by a host of spectroscopic measurements and X-ray structure determination. It is diamagnetic and single-crystal X-ray structure analysis reveals that [1]2+ adopts a distorted octahedral geometry where L binds Ru center in meridional fashion. The observed elongation in the coordinated azo bond length (1.29 ?) is attributed to the extensive π-back bonding, dπ(RuII)→π*(azo)L. The complex [1](ClO4)2 acts as an efficient catalyst, which brings about catalytic transfer hydrogenation reactions of a broad array of aldehydes and ketones in isopropanol and in inert conditions. The selectivity of the catalyst for aldehyde reduction over the other reducible functional groups such as nitro, nitrile, ester etc was also investigated. Mechanistic studies, examined by suitable control reactions and isotope labelling experiments, indicate synergistic participation of both ligand and metal centres via the formation of a fleeting Ru?H intermediate and hydrogen walking to the coordinated azo function of L.
