Methylenecyclohexane oxide (CAS NO.: ), which is also known as Octane, 1-oxaspiro[2.5]-, could be produced through the following synthetic routes.

A. Dimethyloxosulfonium methylide. In a 500-ml., three-necked, round-bottomed flask with a magnetic stirrer are placed 8.8 g. (0.22 mole) of sodium hydride (60% oil dispersion) and 150 ml. of petroleum ether (30–60°). The suspension is stirred, the hydride allowed to settle, the petroleum ether decanted, and 250 ml. of dry dimethyl sulfoxide is added. The flask is immediately fitted with an inlet and outlet for nitrogen and a piece of Gooch tubing connected to a 125-ml. Erlenmeyer flask containing 50.6 g. (0.23 mole) of trimethyloxosulfonium iodide. A gentle stream of dry nitrogen is then continuously passed through the system. With stirring, the oxosulfonium iodide is added, in portions, over a period of 15 minutes and stirring is then continued for an additional 30 minutes.

B. Methylenecyclohexane oxide (CAS NO.: ). The Gooch tubing is removed from the reaction flask and immediately replaced with a sealed, pressure-compensated dropping funnel containing 19.6 g. (0.2 mole) of cyclohexanone, which is then added to the reaction mixture over a 5-minute period. After stirring for 15 minutes, the reaction mixture is heated to 55–60° for 30 minutes with an oil bath and then poured into 500 ml. of cold water and extracted with three 100-ml. portions of ether. The combined ether extracts are washed with 100 ml. of water, then with 50 ml. of saturated aqueous salt solution, dried over anhydrous sodium sulfate, and the ether is distilled at atmospheric pressure through a 20-cm. Vigreux column. The almost colorless residue is transferred to a 50-ml. round-bottomed flask and distilled under reduced pressure through a 5-cm. Vigreux column to yield 15–17 g. (67–76%) of the oxide as a colorless liquid, b.p. 61–62° (39 mm.); n²³D 1.4485. The n.m.r. spectrum (CDCl₃; (CH₃)₄Si internal standard) showed a band at δ 1.58 (10H) and a sharp singlet at δ 2.53