N,N-Dimethylcyclohexylmethylamine (CAS NO.: ), which is also known as methylamine, N,N-dimethyl-, could be produced through the following synthetic routes.

A. N,N-Dimethylcyclohexanecarboxamide (CAS NO.: ). In a 1-l. three-necked flask equipped with a reflux condenser and a dropping funnel, both carrying drying tubes, is placed 128 g. (1.0 mole) of cyclohexanecarboxylic acid. (179 g., 1.5 moles) is added during 5 minutes to the acid, with stirring by a magnetic stirrer. The flask is placed in an oil bath and heated at a bath temperature of 150° for 1 hour. The reflux condenser is then replaced by a distillation head, 200 ml. of anhydrous benzene is added, and the mixture is distilled until the temperature of the vapors reaches 95°. The mixture is cooled, another 200 ml. of anhydrous benzene is added, and the distillation is continued until the temperature of the vapors again reaches 95°. The cooled residual acid chloride is transferred with a little benzene to a dropping funnel which is attached to a 2-l. three-necked flask. The flask is fitted with an efficient mechanical stirrer and a drying tube and is immersed in an ice bath. A solution of 135 g. (3.0 moles) of anhydrous dimethylamine in 150 ml. of anhydrous benzene is introduced into the flask. The acid chloride is added very slowly from the dropping funnel to the vigorously stirred solution, the addition taking about 2 hours. The mixture is then stirred at room temperature overnight. Two hundred milliliters of is added, the layers are separated, and the aqueous phase is extracted with two 100-ml. portions of ether. The extracts are combined with the benzene layer, washed with saturated sodium chloride solution, and dried over 100 g. of anhydrous magnesium sulfate. Most of the solvent is removed by distillation through a 20-cm. Vigreux column at atmospheric pressure, and the residual liquid is distilled through the column under reduced pressure. The fraction boiling at 85–86°/1.5 mm. is collected. The yield of N,N-dimethylcyclohexanecarboxamide is 133–138 g. (86–89%), n²⁵D 1.4800–1.4807.

B. N,N-Dimethylcyclohexylmethylamine (CAS NO.: ). In a 3-l. three-necked flask equipped with a reflux condenser and a dropping funnel, both protected by drying tubes, is placed a suspension of 32 g. (0.85 mole) of lithium aluminum hydride in 400 ml. of anhydrous ether. The mixture is stirred with a magnetic stirrer using a 40-mm. -covered stirring bar. A solution of 133 g. (0.86 mole) of N,N-dimethylcyclohexanecarboxamide in 300 ml. of anhydrous ether is added at such a rate as to maintain gentle reflux. The addition requires about 1 hour. The flask is then placed in an electric heating mantle, and the mixture is stirred and heated under reflux for 15 hours. The heating mantle is replaced by an ice bath, and the flask is fitted with an efficient mechanical, sealed stirrer. Water (70 ml.) is added slowly with vigorous stirring. Stirring is continued for 30 minutes after the addition of water is complete. A cold solution of 200 g. of sodium hydroxide in 500 ml. of water is added at once, and the flask is fitted for steam distillation. The mixture is steam-distilled until the distillate is neutral; about 1.5 l. is collected. The distillate is acidified by careful addition, with water cooling, of 95 ml. of concentrated hydrochloric acid. The two layers are separated and the ether layer washed with 50 ml. of 10% hydrochloric acid. The combined acidic solutions are concentrated until no more distillate comes over at steam bath temperature and 20 mm. pressure. The residue is dissolved in 200 ml. of water, the solution cooled, and 110 g. of sodium hydroxide pellets is added slowly, with stirring and external cooling with ice. The two layers are separated, and the aqueous phase is extracted with three 100-ml. portions of ether. The combined amine layer and ether extracts are dried over 40 g. of potassium hydroxide pellets for 3 hours. The drying agent is separated by decantation, and the solvent is removed by distillation through a 20-cm. Vigreux column. The residue, on distillation under reduced pressure, yields 106–107 g. (88%) of N,N-dimethylcyclohexylmethylamine, b.p. 76°/29 mm., n²⁵D 1.4462–1.4463.