anhydride to activate the pyridine ring, which complements
the previous routes and offers an advantage in terms of
convenience and yield.
4-(2-Oxoalkyl)-1,4-dihydropyridines 5a-i.6 Treatment
of ketones 3a-i with pyridine 1 (4 equiv) and triflic
anhydride (3 equiv) in CH2Cl2 at 0 °C gave 4-(2-oxoalkyl)-
1,4-dihydropyridines 5a-i (in an average yield of 88%)
rather than enol triflates 2 (Scheme 2). No regioisomeric 2-(2-
Scheme 2a
Figure 1. Perspective view of the X-ray crystal structure of 5f.
reaction. The dihydropyridine ring has a conformation similar
to those previously reported for three other 1-triflyl-1,4-
dihydropyridines.7
Table 1. 4-Substituted 1,4-Dihydropyridines 5
entry
R1
R2
mp (°C)
yield (%)
5a
5b
5c
5d
5e
5f
5g
5h
5i
(CH3)2CH
CH3
4-BrC6H4
C6H5
C6H4CH2CH2
C6H5
2-thienyl
2-furyl
C6H5
4-CH3OC6H4
C6H5
44-45
47-48
104-105
119-120
96
86
88
98
81
95
85
91
a Conditions and reagents: (i) CH2Cl2, 0 °C; (ii) t-BuOK, DMSO
or t-BuOH, rt; (iii) TBAF in THF, 70 °C; (iv) KOH in DMSO, 70
°C.
C6H5
Bt
Bt
Bt
Bt
125-126
138
114-115
125-126
oxoalkyl)-1,2-dihydropyridines were detected from the NMR
spectra of the crude products 5a-i. In the case of 5i, the
starting material 3i was recovered in 15% yield. The
structures of these novel 1,4-dihydropyridines 5a-i were
supported by their NMR spectra, and structure 5f was
confirmed by X-ray crystallography (Figure 1). This crystal
structure determination confirmed the regiochemistry of the
(CH3)3C
72 (15)a
a Recovered starting material in parentheses.
4-(2-Oxoalkyl)pyridines 6a-d,f-i.8 1,4-Dihydropyridines
5a-d,f-i on treatment with t-BuOK in DMSO or t-BuOH
afforded 6a-d,9,10 f-i (average 92% yield). Treatment of
5h with KOH in DMSO at 70 C gave 3h in quantitative
yield. Pyridine derivative 6e was not obtained as a result of
o
(3) (a) Akiba, Y.; Nishihara, Y.; Wada, M. Tetrahedron Lett. 1983, 24,
5269. (b) Wada, M.; Nishihara, Y.; Akiba, Y. Tetrahedron Lett. 1985, 26,
3267.
(4) Doering, W. von E.; McEwen, W. E. J. Am. Chem. Soc. 1951, 73,
2104.
(5) (a) Katritzky, A. R.; Beltrami, H.; Keay, J. G.; Rogers, D. N.;
Sammes, M. P.; Leung, C. W. F.; Lee, C. M. Angew. Chem., Int. Ed. Engl.
1979, 18, 792. (b) Lee, C. M.; Sammes, M. P.; Katritzky, A. R. J. Chem.
Soc., Perkin Trans. 1 1980, 2458.
(7) (a) Toscano, R. A.; Hernadez-Galindo, M. del C.; Rosas, R.; Garcia-
Mellado, O.; Portilla, F. del R.; Amabile-Cuevas, C.; Alvarez-Toledano,
C. Chem. Pharm. Bull. 1997, 45, 957. (b) Toscano, R. A.; Rosas, R.;
Hernadez-Galindo, M. del C.; Alvarez-Toledano, C.; Garcia-Mellado, O.
Transition Met. Chem. 1998, 23, 113.
(6) Typical Procedure for the Preparation of 5. To a cooled (0 °C)
solution of a ketone 3 (10 mmol) in CH2Cl2 (50 mL) was added pyridine
(dried over NaOH, 3.2 mL, 40 mmol), and then triflic anhydride (5.0 mL,
30 mmol) was added dropwise over 30 min at 0 °C. The ice bath was
removed, and the reaction mixture stirred at room temperature overnight.
The reaction mixture was washed with saturated NH4Cl (2 × 50 mL) and
H2O (2 × 50 mL). The organic layer was dried over MgSO4. The crude
products were purified by recrystallization or chromatography to afford the
desired 1,4-dihydropyridines 5 in good to excellent yields.
(8) Typical Procedure for the Preparation of 6. To a solution of
compound 5 (5 mmol) in DMSO (20 mL) was added t-BuOK (1.68 g, 15
mmol) at 10 °C. The reaction mixture was stirred at room temperature for
10-30 min. The reaction was quenched with brine and extracted with
EtOAc. The organic layer was washed with H2O and dried over MgSO4.
Recrystallization from hexanes-ethyl acetate afforded product 6 in 81-
97% yields.
(9) Anders, E.; Will, W.; Stankowiak, A. Chem. Ber. 1983, 116, 3192.
(10) Raynolds, S.; Levine, R. J. Am. Chem. Soc. 1960, 82, 472.
2808
Org. Lett., Vol. 3, No. 18, 2001