The removal of phosphates using electrocoagulation with Al−Mg anodes

Add time:07/11/2019    Source:sciencedirect.com

The removal of phosphates, to levels below the detection limit, was achieved over a 30 to 60 min period, depending on the initial phosphate concentration, with Al−Mg anodes in an electrocoagulation cell at 11.0 mA cm−2 with a surface area to volume ratio of 11.7 m−1. The Al−Mg alloy performed well in low chloride concentrations of 4.2 mM NaCl and the complete removal of phosphates from two real water samples was achieved after a 15−min period. The removal efficiency, although depending on the initial pH, appears to depend on the evolution of pH during electrocoagulation with more efficient removal at a final pH of 7.5. Using the Freundlich adsorption model, the adsorption capacity, kF, was computed as 146 mg g−1, corresponding to the adsorption of 146 mg of phosphate per gram of the aluminium−hydroxy coagulant. The efficient removal of the phosphates was attributed to the low corrosion potentials and the lack of a passive region observed using polarisation and cyclic polarisation experiments, which in turn facilitate dissolution of the anode.

We also recommend Trading Suppliers and Manufacturers of (2E)-but-2-en-1-yl phosphate (cas 33170-77-3). Pls Click Website Link as below: cas 33170-77-3 suppliers

Prev:Enzymatic hydrolytic resolution of (R,S)-tropic acid esters and (R,S)-ethyl α-methoxyphenyl acetate in biphasic media
Next:A facile stable-isotope dilution method for determination of sphingosine phosphate lyase activity)