Preparation of polystyrene/Sodium monofluorophosphate (cas 12331-99-6) microcapsules by W/O/W solvent evaporation method

Add time:08/13/2019    Source:sciencedirect.com

Polystyrene (PS)/sodium monofluorophosphate (MFP) microcapsules were prepared by solvent evaporation method for direct addition into concrete and the effects of wall material content, MFP content, emulsifier and protective colloid on the morphology of microcapsules were discussed. The results showed that the average diameter of microcapsule particles slightly increased with the increase of PS content and MFP contents. Span 60 was the best emulsifier comparing with sodium lauryl sulfate and Tween 80. Increasing Span 60 content could decrease the size of microcapsules and the appropriate concentration of Span 60 was 0.5%. Lower concentration of polyvinyl alcohol (PVA), as a protective colloid in the external water phase, resulted in larger particles and higher encapsulation efficiency. The optimal PVA content was approximately 2%. PS/MFP microcapsules exhibited a good sustained release in a simulated concrete solution.

We also recommend Trading Suppliers and Manufacturers of Sodium monofluorophosphate (cas 12331-99-6). Pls Click Website Link as below: cas 12331-99-6 suppliers

Prev:Characteristics and release property of polylactic acid/Sodium monofluorophosphate (cas 12331-99-6) microcapsules prepared by spray drying
Next:Detection or quantitative analysis of a corrosion inhibitor, the Sodium monofluorophosphate (cas 12331-99-6), in concrete)