Rapid responsible optical CO2 sensor of the combination of colorimetric change of α-Naphtholphthalein (cas 1301-55-9) in poly(trimethylsiliylpropyne) layer and internal reference fluorescent porphyrin in polystyrene layer

Add time:08/13/2019    Source:sciencedirect.com

An optical CO2 sensor based on the overlay of the CO2 induced absorbance change of pH indicator dye α-naphtholphthalein in poly(trimethylsiliypropyne) (poly(TMSP))layer with the fluorescence of tetraphenylporphyrin (TPP) in polystyrene layer is developed. The observed luminescence intensity from TPP at 655 nm increased with increasing the CO2 concentration. The ratio I100/I0 value of the sensing film, where I0 and I100 represent the detected luminescence intensities from a layer exposed to 100% argon and 100% CO2, respectively, that the sensitivity of the sensor, is estimated to be 10.3. The response and recovery times of the sensing film are less than 3.0 s for switching from argon to CO2, and for switching from CO2 to argon. The signal changes are fully reversible and no hysteresis is observed during the measurements. The highly sensitive and fast responsible optical CO2 sensor based on fluorescence intensity changes of TPP due to the absorption change of α-naphtholphthalein with CO2 is achieved using poly(TMSP) film.

We also recommend Trading Suppliers and Manufacturers of Naphtholphthalein (cas 1301-55-9). Pls Click Website Link as below: cas 1301-55-9 suppliers

Prev:Optical CO2 sensor of the combination of colorimetric change of α-Naphtholphthalein (cas 1301-55-9) in poly(isobutyl methacrylate) and fluorescent porphyrin in polystyrene
Next:An optical sensor with the combination of colorimetric change of α-Naphtholphthalein (cas 1301-55-9) and internal reference luminescent dye for CO2 in water)