Antimony sulfide selenide prototype photovoltaic modules surpassing 4% conversion efficiency under the sun – A technological outlook

Add time:08/16/2019    Source:sciencedirect.com

We discuss the performance under the sun, at intensity 1000 W/m2, of prototype photovoltaic modules of antimony sulfide selenide thin films, Sb2S1.06Se1.94, with optical bandgap, 1.35 eV. At 26 °C, a module of seven series-connected cells of total active area 6.97 cm2 has conversion efficiency (η) of 4.38% with open-circuit voltage (Voc), 3.13 V; short circuit current (Isc), 21.2 mA and maximum power (Pm) of 30.5 mW. Under steady state operation at 58 °C, η is 3.54%; Voc, 2.58 V; Isc, 21.73 mA and Pm 24.6 mW. Four such prototype modules connected in series of total area 26.8 cm2 give at 26 °C, η of 4.4%; Voc, 12.54 V, Isc, 21.66 mA and Pm 118 mW. At 58 °C, these values drop to η, 3.24%; Voc, 10.46 V; Isc, 20.02 mA and Pm 87 mW. We prepared these modules on commercial SnO2:F (FTO) with cell structure FTO/CdS(90 nm)/Sb2S1.06Se1.94(210 nm)/C-Ag, where the electrodes of area approximately one cm2 each are of colloidal graphite and silver paints. We deposited CdS film from chemical bath and Sb2S1.06Se1.94 film, by thermal evaporation of Sb2S3, Sb2Se3, and SbCl3. This report contains basic properties and technological outlook for this absorber.

We also recommend Trading Suppliers and Manufacturers of ANTIMONY (III) SELENIDE (cas 1315-05-5). Pls Click Website Link as below: cas 1315-05-5 suppliers

Prev:Reinvestigation of phase equilibria in the thallium(I) selenide–antimony(III) selenide system
Next:Full Length ArticleOptimum chemical composition of antimony sulfide selenide for thin film solar cells)