Effect of cosolvent on the phase behavior of binary and ternary mixture for the poly(2-dimethylaminoethyl methacrylate) in supercritical solvents
-
Add time:07/14/2019 Source:sciencedirect.com
Cloud-point behaviors at pressure up to 230 MPa and temperatures up to 463 K were measured for poly(2-dimethylaminoethyl methacrylate) [P(2-DMAEMA)] in CO2 (carbon dioxide), C3H8 (propane), C3H6 (propylene), C4H10 (butane), C4H8 (1-butene), and CH3OCH3 [dimethyl ether (DME)], as well as for the P(2-DMAEMA) + 2-dimethylaminiethyl methacrylate (2-DMAEMA) (or DME) in supercritical CO2. The phase behavior for the P(2-DMAEMA) + CO2 + 2-DMAEMA mixture was measured in changes of the pressure–temperature (p, T) slope and with 2-DMAEMA mass fraction of 0.0 wt%, 5.5 wt%, 11.6 wt%, 21.2 wt% and 48.1 wt%. With 51.4 wt% and 60.4 wt% 2-DMAEMA to the P(2-DMAEMA) + CO2 solution, the cloud point curves take on the appearance of a typical lower critical solution temperature (LCST) boundary, liquid + liquid transition and liquid + vapor transition. The cloud point curves for the P(2-DMAEMA) + CO2 + (0.0–95.0) wt% DME systems change the (p, T) curve from upper critical solution temperature region to lower critical solution temperature region as the DME mass fraction increases. The phase behavior curves for P(2-DMAEMA) in alkane hydrocarbons were about 50–60 K higher than P(2-DMAEMA) + alkene hydrocarbons curves, at a fixed pressure of about 70.0 MPa. Also, the impact by 2-DMAEMA and DME mass fraction for the P(2-DMAEMA) + propane + 2-DMAEMA + DME system was measured at temperatures to about 453 K and a pressure range of 4.3–192.9 MPa.The experimental data was presented for the CO2 + 2-DMAEMA system at temperatures ranging from 313.2 to 393.2 K and pressures up to 19.07 MPa. The CO2 + 2-DMAEMA system exhibits type-I phase behavior with a continuous critical mixture curve and was correlated with Peng–Robinson equation of state using a van der Waals one-fluid mixing rule including two adjustable parameters. The property of 2-DMAEMA was obtained by Constantinou-Gani group contribution method.
We also recommend Trading Suppliers and Manufacturers of 2-(2-dimethylaminoethyl)-3-methyl-2-phenyl-butanenitrile (cas 2809-45-2). Pls Click Website Link as below: cas 2809-45-2 suppliers
Prev:Substituent-directed reduction of cyclic aminals leading to two different heterocycles selectively: syntheses of functionalized nicotines and pyrido[2,3-b]azepines
Next:Preparation of redispersible polymer latexes using cationic stabilizers based on 2-dimethylaminoethyl methacrylate hydrochloride and 2,2′-azobis[2-(2-imidazolin-2-yl)propane]dihydrochloride) - 【Back】【Close 】【Print】【Add to favorite 】
- Related Information
- Linear amphiphilic diblock copolymers of lactide and 2-dimethylaminoethyl methacrylate using bifunctional-initiator and one-pot approaches07/22/2019
- Poly(N,N-dimethylaminoethyl methacrylate-co-2-acrylamido-2-methyl-propanosulfonic acid)/Laponite nanocomposite hydrogels and cryogels with improved mechanical strength and rapid dynamic properties07/20/2019
- Functionalization of lignin through ATRP grafting of poly(2-dimethylaminoethyl methacrylate) for gene delivery07/21/2019
- Synthesis of ‘living’ poly(2-dimethylaminoethyl methacrylate) and stimuli responsive/multifunctional block copolymers effective in fabrication of CdS ‘smart’ ‘Q-Particles’07/19/2019
- Synthesis and fluorescent properties investigation of CdSe quantum dots embedded in a biopolymer based on poly((2-dimethylaminoethyl) methacrylate) grafted onto κ-Carrageenan07/18/2019
- Synthesis of poly(2-dimethylaminoethyl methacrylate)-block- poly(styrene-alt-N-phenylmaleimide) and its thermo-tolerant nanoporous films prepared by selective swelling07/16/2019
- Preparation of redispersible polymer latexes using cationic stabilizers based on 2-dimethylaminoethyl methacrylate hydrochloride and 2,2′-azobis[2-(2-imidazolin-2-yl)propane]dihydrochloride07/15/2019


