Thermochemical conversion of animal by-products and rendering products
-
Add time:08/31/2019 Source:sciencedirect.com
This paper presents a preliminary study of the characterization of real waste from slaughterhouses as well as their rendering products (protein and fat) through different pyrolytic techniques: thermogravimetric analysis (TG), analytical pyrolysis in a pyroprobe equipment and hydrothermal liquefaction process (HTL). The experiments have allowed a deeper knowledge about the thermal behavior of these wastes under different conditions: slow pyrolysis up to 800 °C (TG), flash pyrolysis at 500 °C and room pressure (pyroprobe) and slow pyrolysis at 290 °C and 110–130 bar (HTL batch reactor). Experiments with each one of the materials (real waste, PAP and fat) as well as some mixtures have been performed. Gas chromatography and mass spectrometry techniques were used to identify the pyrolytic products obtained. The results indicate that fatty acids and fatty esters are the major group obtained in the pyrolysis of fat samples, followed by aliphatic hydrocarbons. In the case of PAP pyrolysis, heterocyclic aromatic compounds, which includes typical products coming from protein degradation, is the major group obtained. Oxygenated aliphatics are also obtained in high amounts. In the case of the HTL experiments, significant glycerine amounts were detected in the aqueous phase. The yield of biocrude obtained under HTL conditions is about 30%, with a high proportion of nitrogenated compounds (amides, pyrrole and pyridine derivatives). Generation of amides is much higher under HTL conditions than in the analytical pyrolysis runs while the proportion of acids is reduced.
We also recommend Trading Suppliers and Manufacturers of Naphthalene, Reaction Products with Tetradecene (cas 132983-41-6). Pls Click Website Link as below: cas 132983-41-6 suppliers
Prev:Mild hydrotreatment of low temperature coal tar distillate: Product composition
Next:Effect of hydrothermal pretreatment on product distribution and characteristics of oil produced by the pyrolysis of Huadian oil shale) - 【Back】【Close 】【Print】【Add to favorite 】
- Related Information
- Characterization and comparison of pyrolysis products from fast pyrolysis of commercial Chlorella vulgaris and cultivated microalgae09/07/2019
- Full Length ArticleAnalysis of hydrogenation products of biocrude obtained from hydrothermally liquefied algal biomass by comprehensive gas chromatography mass spectrometry (GC×GC-MS)09/06/2019
- Characterization of products obtained from pyrolysis and steam gasification of wood waste, RDF, and RPF09/05/2019
- Influence of heating rates on the products of high-temperature pyrolysis of waste wood pellets and biomass model compounds09/04/2019
- Impact of fast and slow pyrolysis on the degradation of mixed plastic waste: Product yield analysis and their characterization09/03/2019
- Original articleNatural products of Alternaria sp., an endophytic fungus isolated from Salvadora persica from Saudi Arabia09/02/2019
- Effect of hydrothermal pretreatment on product distribution and characteristics of oil produced by the pyrolysis of Huadian oil shale09/01/2019
- Mild hydrotreatment of low temperature coal tar distillate: Product composition08/30/2019
- Research paperCo-pyrolysis of rice straw and water hyacinth: Characterization of products, yields and biomass interaction effect08/29/2019


