A photoresponsive molecularly imprinted polymer with rapid visible-light-induced photoswitching for 4-ethylphenol in red wine

Add time:09/02/2019    Source:sciencedirect.com

The trans to cis isomerization of the azobenzene chromophore in most azobenzene-based photoresponsive molecularly imprinted polymers (MIPs) is initiated by UV irradiation. This limits the application of these materials in cases where UV light toxicity is an issue, such as in biological systems, food monitoring, and drug delivery. Herein we report a tetra-ortho-methyl substituted azobenzene, (4-[(4-methacryloyloxy)-2,6-dimethyl phenylazo]-3,5-dimethyl benzenesulfonic acid (MADPADSA). The photoswitching of MADPADSA could be induced by visible-light irradiation (550 nm for trans to cis and 475 nm for cis to trans) in 4-hydroxyethylpiperazineethanesulfonic acid (HEPES) buffer-ethanol (4:1, v/v) at pH 7.0, however, the photoisomerization was slow. With the use of MADPADSA as a functional monomer, NaYF4:Yb3+,Er3+ as a substrate, 4-ethylphenol (4-EP) as a template, a novel photoresponsive surface molecularly imprinted polymer NaYF4:Yb3+,Er3+@MIP was obtained. The NaYF4:Yb3+,Er3+@MIP displayed rapid visible-light-induced photoswitching. The NaYF4:Yb3+,Er3+ substrate could efficiently increase the trans to cis isomerization rate of the photoresponsive MIP on its surface, which was faster than that of the corresponding azobenzene monomer MADPADSA. Possible reasons for this effect were investigated by fluorescence spectroscopy. NaYF4:Yb3+,Er3+@MIP displayed good specificity toward 4-EP with a specific binding constant (Kd) of 3.67 × 10−6 mol L−1 and an apparent maximum adsorption capacity (Qmax) of 10.73 μmol g−1, respectively. NaYF4:Yb3+,Er3+@MIP was applied to determine the concentration of 4-EP in red wine with good efficiency and a limit of detection lower than the value that could cause an unpleasant off-flavor.

We also recommend Trading Suppliers and Manufacturers of RED 4 (cas 1342-35-4). Pls Click Website Link as below: cas 1342-35-4 suppliers

Prev:Chapter 4 - Use of Non-Saccharomyces Yeasts in Red Winemaking
Next:Comparison of hemoglobin and hematocrit levels at 1, 4 and 24 h after red blood cell transfusion)