Chiral-Substrate-Assisted Stereoselective Epoxidation
[
23]
Tesque Inc. (Kyoto, Japan). Heptanoic acid, 1,2-epoxyethylbenzene, (R)-
fen-bound P450SPa was solved by molecular replacement with MolRep.
[
24]
(
+)-1,2-epoxyethylbenzene, (p-isopropylphenyl)acetic acid, (S)-(+)-nap-
Model building and refinement were performed by using COOT and
[
25]
roxen, and hydrogen peroxide were obtained from WAKO Pure Chemi-
cal Industries, Ltd (Osaka, Japan). Styrene, methyl phenylacetate, n-vale-
ric acid, and (S)-(+)-ibuprofen were obtained from Tokyo Chemical In-
dustry Co. (Tokyo, Japan). p-Methylphenylacetic acid, (R)-(ꢀ)-naproxen,
REFMAC5.
The (R)-ibuprofen model was generated by using
[
26]
a Dundee PRODRG server and used in the refinement with COOT
and REFMAC5. Alternative conformations were introduced to Glu-89
with occupancies of 0.6 and 0.4, Arg-187, Val-313, and Ser-344 with occu-
pancies of 0.7 and 0.3, and to Glu-64, Val-292, and His-412 with occupan-
cies of 0.5 and 0.5. TLS refinement was performed at the final stage of
the refinement by defining each chain in the asymmetric unit as a sepa-
rate TLS group. The produced model showed a final Rfact =15.8% and
4
-(2-hydroxyethyl)-1-piperazineethanesulfonic acid (HEPES), and (ꢁ)-2-
[27]
methyl-2,4-pentanediol (MPD) were purchased from Sigma–Aldrich Co.
(
USA). (R)-(ꢀ)-Ibuprofen was purchased from Funakoshi Co., Ltd.
(
Tokyo, Japan). 2-(N-morpholino)ethanesulfonic acid (MES) was pur-
chased from Dojindo Laboratories (Kumamoto, Japan). Phenylacetic
acid was prepared by the hydrolysis of methyl phenylacetate and purified
by re-crystallization.
Rfree =18.6% (Table 3). The final model consisted of one polypeptide
chain with residues 9–415 of P450SPa, 1 heme, 1 (R)-ibuprofen, 2 (R)-2-
methyl-2,4-pentanediol (MRD), and 274 water molecules. Structure vali-
[28]
dation was performed by using PROCHECK. All protein figures were
Measurements
[29]
depicted by using PyMOL.
UV/Vis spectra were recorded on a Shimadzu UV-2400 PC spectropho-
tometer. GC analysis was performed on a Shimadzu GC-2014 that was
equipped with a cyclosil-b column (Agilent Technologies, Inc., 30 mꢂ
Docking Simulations
0
.25 mm).
Table 3. Data collection and refinement of (R)-ibuprofen-bound WT
Preparation of WT, L78F, and F288G P450SPa
P450SPa.
Data collection
WT, L78F, and F288G P450SPa were prepared according to literature pro-
[
16]
cedures. The concentrations of WT P450SPa and the mutants were de-
l [ꢀ]
space group
1000
[
20]
termined from their CO difference spectra.
P3 21
1
cell dimensions
a, b, c [ꢀ]
a, b, g [8]
Epoxidation of Styrene
94.390, 94.390, 112.863
90.000, 90.000, 120.000
20.0–1.94 (2.01-1.94)
452029
43560
4.8 (29.7)
100 (100)
53.1 (8.2)
10.4 (10.7)
Styrene was purified by column chromatography on alumina to remove
the polymerization inhibitor before measurements; styrene was used im-
mediately on purification. The epoxidation reactions were performed
as follows: 4 mm styrene, 4 mm H , and 1 mm WT P450SPa were mixed
in 0.1m potassium phosphate buffer (pH 7.0) at 258C. A solution of the
carboxylic acid in EtOH was added as a decoy molecule to a final con-
centration of 20 mm, except for (R)- and (S)-naproxen; because of their
poor solubility, the concentrations of (R)- and (S)-naproxen were 5 mm in
the reaction mixture. The reactions were performed at least three times
resolution [ꢀ]
no. of total observed reflections
no. of unique reflections
[
21]
2
O
2
[
a,b]
R
merge
[%]
[
a]
completeness [%]
[
a]
I/s(I)
redundancy
[
a]
Refinement statistics
2 2
with each decoy molecule. CH Cl was added immediately into the reac-
resolution range [ꢀ]
19.76–1.94
1
15.8/18.6
0.012
1.193
3614
tion mixture for quenching and methyl phenylacetate was added as an in-
ternal standard. The extract was evaporated and the resulting solution
was analyzed by GC that was equipped with a cyclosil-b column (Agilent
Technologies, Inc.). The absolute configuration of styrene oxide was de-
termined by using an authentic sample of (R)-styrene oxide. GC analyti-
cal conditions were as follows: injector temperature: 2008C, detector
temperature: 2508C, initial oven temperature: 908C (30 min), ramp rate:
no. of monomer/asymmetric unit
[c,d]
R
fact/Rfree
[%]
[
e]
e]
r.m.s.d. bond length [ꢀ]
r.m.s.d. bond angles [8]
no. of atoms
average B-factor [ꢀ ]
[
2
19.5
ꢀ
1
1
08Cmin , final oven temperature 1908C (20 min), carrier gas: He.
[a] The values in parentheses are for the highest-resolution shell.
b] Rmerge =SjIꢀ<I> j/SI. [c] Rfact =Sj jF jꢀkjF j j/SjF j where F and
are the observed and calculated structure-factor amplitudes, respec-
[
o
c
o
o
Co-Crystallization of (R)-Ibuprofen-Bound P450SPa WT
F
c
tively. [d] Rfree was calculated as the Rfact for 5% of the reflection that
were not included in the refinement. [e] r.m.s.d.=root mean square devi-
ation.
P450SPa WT that is expressed in E. coli contains palmitic acid, even after
[
16]
purification. After the removal of glycerol and KCl from P450SPa by
solvent exchange to 0.1m KPi buffer (pH 7.0), residual fatty acids, includ-
ing palmitic acid, were removed from P450SPa by passing thorough a Hy-
droxyalkoxypropyl-Dextran, Type VI column (Sigma–Aldrich, Co., USA)
that was equilibrated with 0.1m potassium phosphate buffer (pH 7.0) at
RT. The fractions were collected and the solvent was exchanged to
[18]
The docking experiments were performed by using AutoDock4
and
AutoGrid4 in combination with AutoDock Tools according to literature
[
30]
procedures. The styrene model was generated by using Dundee Pro-
5
0 mm MES buffer that contained 20% glycerol (pH 7.0). The resulting
[
26]
drug Server and used as a ligand. The X-ray crystal structure of (R)-
ibuprofen-bound P450SPa WT was used as a rigid receptor for the docking
of styrene. Met-69, Leu-77, Leu-78, and Phe-288, which were located
around the hydrophobic and hydrophilic channels, were set as flexible
residues for the access of styrene into the active site from the protein sur-
face. For the docking of styrene to the pentanoic-acid-bound-form of
P450SPa, the model was generated by shortening the alkyl-chain length of
P450SPa was used as its substrate-free form. Co-crystallization of sub-
strate-free P450SPa WT and (R)-ibuprofen were performed by a sitting-
drop vapor-diffusion method. The reservoir solution was prepared by
mixing 0.1m HEPES-NaOH (99 mL, pH 7.0), 35% MPD, and 1m (R)-ibu-
profen (1 mL) in EtOH to prepare a total solution volume of 100 mL. A
solution of substrate-free P450SPa WT (2 mL) was mixed with the reser-
voir solution (2 mL). Crystals were grown at 208C over 1 week.
palmitic acid in the crystal structure of palmitic-acid-bound WT P450SPa
.
Data Collection and Refinement
The model was used as a rigid receptor and Met-69, Leu-77, Leu-78, and
Phe-288 were set as flexible residues. Docked conformations were
ranked automatically by Autodock4 as a free-energy-scoring function.
Crystals were flash-cooled in liquid nitrogen. X-ray-diffraction data sets
were collected on beam-line BL26B1 that was equipped with an ADSC
Quantum 315 CCD detector at the RIKEN SPring-8 (Hyogo, Japan) with
[29]
These results were visualized by using PyMOL.
[
22]
a 1.0 ꢀ wavelength at 100 K. The program HKL2000 was used to inte-
grate the diffraction intensities and scaling. The structure of (R)-ibupro-
Chem. Asian J. 2012, 00, 0 – 0
ꢁ 2012 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim
www.chemasianj.org
7
&
&
&
These are not the final page numbers! ÞÞ