Bi(TFA)3 and Bi(OTf)3 catalyzed conversions of epoxides to thiiranes with ammonium thiocyanate and thiourea under non-aqueous conditions

Article abstract of DOI:10.3390/61200996

Various epoxides are converted to their corresponding thiiranes in excellent yields with ammonium thiocyanate and thiourea under non-aqueous conditions in the presence of catalytic amounts of Bi(TFA)₃ and Bi(OTf)₃.

Full text of DOI:10.3390/61200996

Molecules 2001, 6, 996-1000
molecules
ISSN 1420-3049
http://www.mdpi.org
Bi(TFA) and Bi(OTf) Catalyzed Conversions of Epoxides to
3
3
Thiiranes with Ammonium Thiocyanate and Thiourea under
Non-Aqueous Conditions
Iraj Mohammadpoor-Baltork* and Ahmad R. Khosropour
Department of Chemistry, Isfahan University, Isfahan 81744, Iran; Fax: (+98) 311 6689732.
*
Author to whom correspondence should be addressed; e-mail: Imbaltork@sci.ui.ac.ir
Received: 30 July 2001; in revised form 10 October 2001 / Accepted: 23 October 2001 / Published: 30
November 2001
Abstract: Various epoxides are converted to their corresponding thiiranes in excellent yields
with ammonium thiocyanate and thiourea under non-aqueous conditions in the presence of
catalytic amounts of Bi(TFA) and Bi(OTf) .
3
3
Keywords: Bi (III) salts, Epoxides, Lewis acids, Thiiranes.
Introduction
Epoxides are important intermediates in organic synthesis. One of the most important reactions of
these compounds is the conversion to their corresponding thiiranes by an oxygen-sulfur exchange
process. Many methods have already been reported in the literature for this purpose [1-11]. However,
some of these methods often suffer from one or more disadvantages such as low yields of the products,
long reaction times, difficult workup procedures, use of expensive reagents, formation of polymeric by-
products and the need for aqueous reaction conditions, therefore, the introduction of new, efficient
methods for this transformation is a desirable objective. Recently we have reported the bismuth (III)
chloride catalyzed conversion of epoxides to thiiranes in the presence of ammonium thiocyanate [12],
but in the presence of thiourea this catalyst is not effective. As a continuation of our studies on
catalysis by Bi(III) salts [13], we now report that Bi(TFA) or Bi(OTf) can act as efficient catalysts for
3
3
the conversion of epoxides to their corresponding thiiranes in the presence of both ammonium
thiocyanate and thiourea.

Molecules 2001, 6
997
Results and Discussion
The reactions of various epoxides with NH SCN were performed in the presence of 0.05 molar
4
equivalent of Bi(TFA) or 0.02 molar equivalent of Bi(OTf) in refluxing acetonitrile to afford the
3
3
corresponding thiiranes in excellent yields (Scheme 1, Table 1). The substrates used (cyclohexene and
styrene oxides, epichlorohydrin, glycidyl phenyl ether, glycidyl isopropyl ether, allyl glycidyl ether
and 1,2-epoxyoctane) were selected as examples of aliphatic, cyclic, activated and deactivated
epoxides.
Scheme 1
NH SCN, CH CN, reflux
4
3
O
S
Bi(TFA) or Bi(OTf) 3
3
10- 40 min, 90-99%
R
R
Table 1. Conversion of Epoxides to Thiiranes with NH SCN
4
Catalyzed by Bi(TFA) or Bi(OTf) in Refluxing CH CN
3
3
3
Bi(TFA)3
Bi(OTf)3
Epoxide
a
a
Yield% Cat./epoxide (Time, Min) Yield% Cat./epoxide (Time, Min)
O
9
9
6
4
0.05(30)
99
0.02(15)
O
0.05(20)
0.05(35)
98
99
0.02(15)
0.02(25)
Ph
O
Cl
94
O
PhO
9
9
0
5
0.05(40)
0.05(15)
93
97
0.02(10)
0.02(10)
O
O
O
O
92
0.05(15)
0.05(20)
99
98
0.02(10)
0.02(10)
O
9
2
a
All products were identified by comparison of their physical and spectral data
b
with those of authentic samples. Isolated yields.

Molecules 2001, 6
998
Although the methodology has not been tested on 1,1-disubstituted, trisubstituted or
tetrasubstituted epoxides at this time, based on our experience with mono- and 1,2-disubstituted ones
we have no reason to believe it will not work equally well with those substrates too. We have also
investigated the catalytic abilities of these two catalysts for the conversion of epoxides to thiiranes with
thiourea as sulfur-introducing reagent (Scheme 2). In comparison with ammonium thiocyanate,
thiourea is a less reactive and more stable sulfurating agent and further its handling is easier. Therefore,
the proposed method based on using thiourea can be considered as a practical and useful achievement
in synthesis of thiiranes from epoxides.
Scheme 2.
(
NH ) C=S, CH CN, reflux
2 2 3
O
S
Bi(TFA) or Bi(OTf) 3
3
40- 90 min, 75-98%
R
R
Table 2. Conversion of Epoxides to Thiiranes with (NH ) C=S
2
2
Bi(TFA)3
Bi(OTf)3
Epoxide
a
a
Yield%
Cat./epoxide(Time, Min) Yield% Cat./epoxide(Time, Min)
O
9
2
0.1 (60)
95
0.05 (40)
O
9
8
0
0
0.1 (75)
92
90
0.05 (60)
0.07 (60)
Ph
O
0.15 (70)
Cl
O
PhO
7
9
5
0
0.15 (75)
0.15 (60)
88
98
0.07 (70)
0.07 (60)
O
O
O
O
8
7
5
7
0.15 (90)
0.15 (75)
92
93
0.07 (90)
0.07 (60)
O
a
All products were identified by comparison of their physical and spectral data
b
with those of authentic samples. Isolated yields.

Molecules 2001, 6
999
As shown in Table 2, different classes of epoxides reacted with thiourea in the presence of 0.05-0.15
molar equivalent of the catalysts in refluxing acetonitrile and the corresponding thiiranes were obtained
in high yields. In contrast, the conversion of epoxides to thiiranes with thiourea under wet (solvent
free) conditions or in aqueous ethanol suffers from long reaction times and low yields of the products
[
2]. It is also worth mentioning that while in an aqueous medium the pH must be controlled to avoid
polymerization of the thiiranes, in this method, since the reactions occur under non-aqueous
conditions, no polymerization was observed and thiiranes were obtained in excellent yields. The
experimental results also show that Bi(OTf) is more reactive than Bi(TFA) in these reactions.
3
3
Conclusions
We have shown that Bi(TFA) or Bi(OTf) can be used as efficient catalysts for the conversion of
3
3
epoxides to thiiranes with ammonium thiocyanate and thiourea. Noteworthy advantages of this method
are the high yields of the products, short reaction times, easy workup, stability, availability, and non-
toxicity of the catalysts.
Experimental
General
All products are known compounds and were identified by comparison of their physical and
spectral data with those of authentic samples. Yields refer to isolated products. IR spectra were run on
1
a Philips PU9716 spectrophotometer. H-NMR spectra were recorded in CDCl on a Bruker AM 80
3
MHz spectrometer using TMS as an internal standard. GC analysis was performed using a column of
15% Carbowax 20M Chromosorb-W 60-80 mesh on a Shimadzu 16A GC equipped with a FID.
Bi(TFA) and Bi(OTf) were prepared according to described procedures [14].
3
3
General Procedure for the Conversion of Epoxides to Thiiranes
A solution of epoxide (1 mmol) and NH SCN or thiourea (2 mmol) in CH CN (5 mL) was prepared
4
3
in a round-bottomed flask (25 mL) equipped with a condenser and a magnetic stirrer, Bi(TFA) or
3
Bi(OTf) (0.02-0.15 mmol) were added to the solution and the reaction mixture was stirred
3
magnetically under reflux conditions for 10-90 min. The progress of the reaction was monitored by
GLC. After completion of the reaction, the solvent was evaporated and H O (10 mL) was added. The
2
mixture was extracted with CHCl (2 ×10 mL) and the organic solution was dried with Na SO . The
3
2
4
solvent was evaporated and the crude product was purified on a short column of silica-gel (4:1 n-
hexane/EtOAc as eluent) to afford the pure thiiranes in 75-99% yields (Tables 1 and 2).
References
1. Sander, M. Chem. Rev. 1966, 66, 297.
2. Bouda, H.; Borredon, M. E.; Delmas, M.; Gaset, A. Synth. Commun. 1989, 19, 491 and references
cited therein.

Molecules 2001, 6
1000
3
4
5
6
7
. Calo, V.; Lopez, L.; Marchese, L.; Pesce, G. J. Chem. Soc. Chem. Commun. 1975, 621.
. Korn, A. C.; Finkenbine, J. R. J. Chem. Res.(S) 1995, 102.
. Takido, T.; Kobayashi, Y.; Itabashi, K. Synthesis 1986, 779.
. Bordwell, F. G.; Andersen, H. M. J. Am. Chem. Soc. 1953, 75, 4959.
. Brimeyer, M. O.; Mehrota, A.; Quici, S.; Nigam, A.; Regen, S. L. J. Org. Chem. 1980, 45,
4254.
8
. Tamami, B.; Kiasat, A. R. Synth. Commun .1996, 26, 3953.
. (a) Iranpoor, N.; Kazemi, F. Tetrahedron 1997, 53, 11377.
9
(
b) Iranpoor, N.; Zeynizadeh, B. Synth.Commun. 1998, 28, 3913.
0. (a) Mohammadpoor-Baltork, I.; Khosropour, A. R. Indian. J. Chem. 1999, 605.
b) Mohammadpoor-Baltork, I.; Aliyan, H. J .Chem. Res.(S) 2000, 122.
1. (a) Tangestaninejad, S.; Mirkhani, V. Synth. Commun. 1999, 29, 2079.
b) Tangestaninejad, S.; Mirkhani, V. J. Chem. Res.(S) 1999, 370.
1
1
(
(
1
2. Mohammadpoor-Baltork, I.; Aliyan, H. Synth Commun 1998, 28, 3943.
3. (a) Mohammadpoor-Baltork, I.; Aliyan, H. Synth. Commun. 1999, 29, 2741.
1
(
b) Mohammadpoor-Baltork, I.; Tangestaninejad, S.; Aliyan, H.; Mirkhani, V. Synth. Commun.
000, 30, 2365.
c) Firouzabadi, H.; Mohammadpoor-Baltork, I.; Kolagar, S. Synth. Commun. 2001, 31, 905.
2
(
14. (a) Garner, C. D.; Hughes, B. “Advances in Inorganic Chemistry and Radiochemistry”, Vol 17,
Academic Press: New York, 1975.
(
b) Singh, S.; Verma, A. R. D. Indian J. Chem. 1983, 22A, 814.
Sample Availability: Samples are available from MDPI.
2001 by MDPI (http://www.mdpi.org). Reproduction is permitted for noncommercial purposes.
©