Sorption potential of Haro river sand for the removal of antimony from acidic aqueous solution
-
Add time:08/31/2019 Source:sciencedirect.com
The sorption of antimony (V) from 9.55 × 10−7 to 9.55 × 10−5 mol dm−3 on the sand of Haro river (10 mg-1 g) has been investigated to optimize the maximum adsorption with respect to the selection of an appropriate electrolyte, shaking time, concentration of antimony and amount of sand. Maximum sorption of antimony (9.53 × 10−7 mol dm−3) from 0.3 mol dm−3 nitric acid solution has been achieved after 10 min shaking at a v/w ratio of 450 cm3 g−1. Among the ions tested, EDTA, citrate, sulphite, thiosulphate, iodide, Zr(IV), tartrate and fluoride reduce the sorption drastically whereas Al(III) and Pb(II) enhance the sorption significantly. Under optimal conditions chosen for antimony, larger distribution ratios are obtained for Ru(III) and Ni(II) whereas Sn(IV), Cu(II) and Fe(III) have shown substantial sorption. Zn(II), Cs(I) and Cr(III) are sorbed to a lesser extent (<5%). These elements can be separated from Sb(V), Ni(II) and Ru(III) using this sand as a column bed. The sorption data followed Freundlich and DR isotherms over the entire concentration range of antimony investigated. The values of 1/n = 0.7 and of A = 64.5 μmol g−1 have been computed for the sorption system. The DR parameters yielded the values: Cm = 16.7 μmol g−1, B = −0.004195 mol2 kJ−2 and E = 10.9 KJ mol−1. The sorption on the sand can be exploited for the preconcentration and removal of trace concentrations of antimony including radioactive isotopes from aqueous solutions or natural waters as well as from industrial and radioactive process waste water.
We also recommend Trading Suppliers and Manufacturers of antimony pentoxide sol (cas 12712-36-6). Pls Click Website Link as below: cas 12712-36-6 suppliers
Prev:Facile synthesis of antimony-doped tin oxide nanoparticles by a polymer-pyrolysis method
Next:Full Length ArticleAb-initio study on the structural and spectral properties of Ce3+ in strontium silicate (cas 12712-63-9)s phosphors) - 【Back】【Close 】【Print】【Add to favorite 】
- Related Information
- Facile synthesis of antimony-doped tin oxide nanoparticles by a polymer-pyrolysis method08/30/2019
- Sol-gel vanadium-titanium-molybdenum mixed oxides for oxidative dehydrogenation of ethane08/29/2019
- Effect of calcination temperatures on physicochemical properties of vanadium–antimony mixed oxide catalysts08/28/2019
- The formation of a peroxoantimonate thin film coating on graphene oxide (GO) and the influence of the GO on its transformation to antimony oxides and elemental antimony08/27/2019
- Review ArticleElectrochromic properties of sol–gel prepared hybrid transition metal oxides – A short review08/26/2019
- The effects of Sb incorporation into vanadium pentoxide xerogel08/25/2019
- Adsorption characteristics of strontium on synthesized antimony silicate08/24/2019
- Derivation methods of soils, water and sediments toxicity guidelines: A brief review with a focus on antimony08/23/2019
-
Health and Chemical more >
-
Related Products


