Structural, textural and toluene adsorption properties of NH4HF2 and alkali modified USY zeolite
-
Add time:09/09/2019 Source:sciencedirect.com
The non-framework aluminum is inevitably formed in the process of preparing the ultra-stable Y zeolite (USY), which severely blocks the mesopores of USY zeolite. It is necessary to treat the USY with the appropriate acid and/or alkali. In this paper, the USY zeolite is firstly dealuminated with NH4HF2 solution and then desiliconized with NaOH or NH4OH solution. The effect and mechanism of NH4HF2 and different alkali treatments on the structural and textural property of USY zeolite are elaborately demonstrated. It is found that the non-framework Al remaining in the mesopores of USY is significantly removed by the NH4HF2 solution. The desiliconization reaction is more likely to start near the mesoporous wall because the Al concentration in here is low and the repulsive force against OH− is weak. The OH− ions from NaOH solution not only etch the framework Si near the inner wall of the mesopores, but also remove the Si on the surface of NH4HF2-etched USY zeolite. However, the concentration of OH− ions is too low when NH4OH is used as the desiliconization agent, the OH− ions just react with silicon around the mesopores. Therefore, the NaOH/NH4HF2-etched USY contains both some micropores and macropores, and the NH4OH/NH4HF2-etched USY only possesses more mesopores with pore sizes of ~10 nm. In addition, NaOH/NH4HF2-etched USY exhibits excellent toluene adsorption performance at low pressure stage, while NH4OH/NH4HF2-etched USY has the highest adsorption capacity on toluene at high pressure stage.
We also recommend Trading Suppliers and Manufacturers of TOLUENE, [3H] (cas 16713-13-6). Pls Click Website Link as below: cas 16713-13-6 suppliers
Prev:Dispersed WO3 nanoparticles with porous nanostructure for ultrafast toluene sensing
Next:Full length articlePhotothermocatalytic performance of ACo2O4 type spinel with light-enhanced mobilizable active oxygen species for toluene oxidation) - 【Back】【Close 】【Print】【Add to favorite 】
- Related Information
- Synthesis of graphitic mesoporous carbon supported Ce-doped nickel catalyst for steam reforming of toluene10/01/2019
- Photocatalytic oxidation of gaseous benzene, toluene and xylene under UV and visible irradiation over Mn-doped TiO2 nanoparticles09/27/2019
- Ferric nitrate-promoted oxidative esterification of toluene with N-hydroxyphthalimide: Synthesis of N-hydroxyimide esters09/26/2019
- Electrochemical reduction of toluene to methylcyclohexane for use as an energy carrier09/25/2019
- In-situ fabrication of cellulose foam HKUST-1 and surface modification with polysaccharides for enhanced selective adsorption of toluene and acidic dipeptides09/24/2019
- Full length articlePhotothermocatalytic performance of ACo2O4 type spinel with light-enhanced mobilizable active oxygen species for toluene oxidation09/10/2019
- Dispersed WO3 nanoparticles with porous nanostructure for ultrafast toluene sensing09/08/2019
- Lanthanum-doped CuMn composite oxide catalysts for catalytic oxidation of toluene☆09/07/2019
- PerspectiveCuO-modified activated carbon for the improvement of toluene removal in air09/06/2019
-
Health and Chemical more >
-
Related Products


