Simultaneous removal of ammonia and manganese from electrolytic metal manganese residue leachate using phosphate salt

Add time:07/20/2019    Source:sciencedirect.com

Ammonia and manganese were simultaneously removed from electrolytic metal manganese residue leachate using phosphate salt. The influence of different N:P ratios and pH were investigated. Phase transition and decomposing behavior of precipitates and the characterization of the precipitates pyrolysis were characterized by X-ray diffraction, Fourier transform infrared spectroscopy, thermogravimetric analysis, differential thermal analysis, and scanning electron microscope. In the laboratory experiment, under the condition of 1:1.15 N:P ratio and 9.5 pH value, removal efficiencies of ammonia and manganese from the residue leachate were achieved 95.0% and 99.9%, respectively, and remaining concentration of orthophosphate was as low as 12 mg L−1. In the process, manganese was first removed as Mn3(PO4)2·7H2O, and then ammonia was removed as NH4MgPO4·6H2O. In addition, MgNaPO4, MgHPO4, Mg2P2O7, Na3PO4 and MnO2 were generated during precipitate pyrolysis process, and the ammonia removal efficiency decreased from 84.0% in the first cycle to 66.0% in the fifth, and manganese removal efficiency was approximately 99.0%. Economic evaluation shows that recycling the precipitates for three times could save 68.4% cost on average, compared to the use of pure chemicals.

We also recommend Trading Suppliers and Manufacturers of formic acid, manganese salt (cas 14998-38-0). Pls Click Website Link as below: cas 14998-38-0 suppliers

Prev:Fabrication of hydrophobic coating on electrolytic manganese surface for enhancing corrosion resistance
Next:Simultaneous optimizing removal of manganese and ammonia nitrogen from electrolytic metal manganese residue leachate using chemical equilibrium model)