Water-dispersible Triethylenetetramine (cas 112-24-3)-functionalized graphene: Preparation, characterization and application as an amperometric glucose sensor
-
Add time:08/24/2019 Source:sciencedirect.com
The triethylenetetramine-functionalized graphene (TFGn) was prepared using graphene oxide (GO) and triethylenetetramine as raw materials through a one-step reaction under alkaline condition. The triethylenetetramine not only acted as cross-linker to combine GO, but also as reductant of GO. The TFGn was characterized by its ultraviolet spectrum (UV), Fourier transform infrared spectroscopy (FTIR), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), Raman spectroscopy and Scanning electron microscopy (SEM). The results showed that triethylenetetramine was successfully grafted onto the surface of the GO through covalent bonding between amine and epoxy groups. The resultant TFGn was uniformly dispersed in water over several weeks, suggesting that the introduction of amino groups greatly increased the hydrophilicity of TFGn. The triethylenetetramine-functionalized graphene was then applied to fabricate glucose biosensors with IO4− oxidized glucose oxidase (GOx) through layer-by-layer (LBL) self-assembly by the covalent bonding between the aldehyde groups of GOx and amino groups of TFGn. The gold electrodes modified with the (GOx/TFGn)n multilayer films were studied by cyclic voltammetry (CV) and showed outstanding electrocatalytical response to the oxidation of glucose when ferrocenemethanol was used as an artificial redox mediator. The response increased with an increasing number of GOx/TFGn bilayers, indicating that the analytical performance, such as the sensitivity of the glucose biosensor, could be adjusted by tuning the number of deposited GOx/TFGn bilayers. The linear response range of the biosensor constructed with six bilayers of GOx/TFGn to the concentration of glucose can extend to at least 8 mM with a sensitivity of 19.9 μA mM− 1 cm− 2. In addition, the sensor exhibited good stability due to the covalent interactions between the GOx and TFGn.
We also recommend Trading Suppliers and Manufacturers of Triethylenetetramine (cas 112-24-3). Pls Click Website Link as below: cas 112-24-3 suppliers
Prev:Data on Triethylenetetramine (cas 112-24-3) effect on steel-rebar corrosion-rate in concrete immersed in 0.5 M H2SO4
Next:Full Length ArticleGraphene/Si solar cells employing Triethylenetetramine (cas 112-24-3) dopant and polymethylmethacrylate antireflection layer) - 【Back】【Close 】【Print】【Add to favorite 】
- Related Information
- ArticleThe CO2 absorption and desorption performance of the Triethylenetetramine (cas 112-24-3) + N,N-diethylethanolamine + H2O system☆08/29/2019
- Research articleImprovement of polyvinyl chloride nanofiltration membranes by incorporation of multiwalled carbon nanotubes modified with Triethylenetetramine (cas 112-24-3) to use in treatment of dye wastewater08/28/2019
- Full Length ArticleCytocompatibility of polyethylene grafted with Triethylenetetramine (cas 112-24-3) functionalized carbon nanoparticles08/27/2019
- Triethylenetetramine (cas 112-24-3) promoted rGO-Fe3O4 nanocomposites for highly efficient Fenton-like reaction08/26/2019
- Full Length ArticleGraphene/Si solar cells employing Triethylenetetramine (cas 112-24-3) dopant and polymethylmethacrylate antireflection layer08/25/2019
- Data on Triethylenetetramine (cas 112-24-3) effect on steel-rebar corrosion-rate in concrete immersed in 0.5 M H2SO408/23/2019
- Adsorption of Cu2+ and Zn2+ on SBA-15 mesoporous silica functionalized with Triethylenetetramine (cas 112-24-3) chelating agent08/22/2019
- Multicavity Triethylenetetramine (cas 112-24-3)-chitosan/alginate composite beads for enhanced Cr(VI) removal08/21/2019
- Mechanisms of Cu2+, Triethylenetetramine (cas 112-24-3) (TETA), and Cu-TETA sorption on rectorite and its use for metal removal via metal-TETA complexation08/20/2019


