Enhancing solar disinfection of water in PET bottles by optimized in-situ formation of iron oxide films. From heterogeneous to homogeneous action modes with H2O2 vs. O2 – Part 2: Direct use of (natural) iron oxides
-
Add time:09/01/2019 Source:sciencedirect.com
Solar disinfection (SODIS) is a well-accepted intervention method, leading to an improvement in contaminated water sources. In this work, we attempted to further enhance the bacterial inactivation process during light exposure. By means of iron oxide addition, we generated a film on the inner surface of PET bottles used in SODIS, in order to induce further pathways of solar-mediated inactivation. More specifically, in this 2nd part, the deposition process has been systematically assessed, using iron oxides (Fe-Ox). The deposition parameters, namely, the precursor concentration (50 mg/L to 1 g/L), deposition time (1–4 h), oxide type (semiconductor, Fe species), size (μm vs. nm), and specific surface area (∼5–150 m2/g), were assessed. The use of H2O2 as the electron acceptor (and heterogeneous photo-Fenton induction) enhanced the efficacy without decreasing the reuse potential. More than 60% and 75% reduction in the treatment time was observed, compared with that for SODIS in a normal bottle, with O2 and H2O2 (in situ photo-Fenton) as the electron acceptors, respectively. The semiconductor mode of action and controlled iron leaching in the system both demonstrated bactericidal capacity; particularly, it was found that the factors affecting the process partially correlated with the oxide characteristics (size, band gap, and isoelectric point), rather than the capacity to photo-dissolve iron. Consequently, the use of a natural Fe source yielded results (deposition parameters and efficacy) resembling those for iron salts, indicating the dominant inactivation pathways governing the process in the presence or absence of H2O2. Finally, the disinfection of natural lake water with natural Fe–deposed bottles showed similar results to those of Fe-salt–deposed bottles, indicating that in a suitable matrix, the process can work equally well.
We also recommend Trading Suppliers and Manufacturers of Natural iron oxide (cas 1345-27-3). Pls Click Website Link as below: cas 1345-27-3 suppliers
Prev:Production of biodiesel from castor oil using iron (II) doped zinc oxide nanocatalyst
Next:Literature review on the use of natural products in the flotation of iron oxide ores) - 【Back】【Close 】【Print】【Add to favorite 】
- Related Information
- Effects of metal cations on the fulvic acid (FA) adsorption onto Natural iron oxide (cas 1345-27-3) in iron ore pelletizing process09/09/2019
- Original ArticleIron oxides as efficient sorbents for CO2 capture09/08/2019
- Photodegradation kinetics of 2,6-dimetylphenol by Natural iron oxide (cas 1345-27-3) and oxalate in aqueous solution09/07/2019
- Kinetics, adsorption and desorption of Cd(II) and Cu(II) on natural allophane: Effect of iron oxide coating09/06/2019
- The removal of arsenic from water using Natural iron oxide (cas 1345-27-3) minerals09/05/2019
- Underestimation of phosphorus fraction change in the supernatant after phosphorus adsorption onto iron oxides and iron oxide–natural organic matter complexes09/04/2019
- The removal of arsenic from water using Natural iron oxide (cas 1345-27-3) minerals☆09/03/2019
- Literature review on the use of natural products in the flotation of iron oxide ores09/02/2019
-
Health and Chemical more >


