Journal of Medicinal Chemistry
Article
(35.0 mL) according to the method of 1, to give the title compound 29
as an off-white solid (5.64 g, 13.7 mmol, 89%). H NMR (300 MHz,
DMSO-d6): δ 9.75 (s, 1H), 8.00 (s, 2H), 3.57 (s, 3H), 1.93 (s, 3H),
1.72 (s, 3H). HRMS (m/z): [MH+] calcd for C12H13N3SO2Cl2Br,
411.9283; found 411.9282.
6-Chloropyridine-3-sulfonic Acid (1,3,5-Trimethyl-1H-pyrazol-4-
yl)amide (37). 37 was prepared from 6-chloropyridine-3-sulfonyl
chloride (4.8 g, 22.7 mmol) and 4-amino-1,3,5-trimethyl-1H-pyrazole
(2.84 g, 22.7 mmol) in pyridine (35.0 mL) according to the method of
1, to give the title compound 37 as an off-white solid (5.13 g, 17.1
mmol, 75%). 1H NMR (500 MHz, DMSO-d6): δ 9.51 (s, 1H), 8.59 (d,
J = 2.3 Hz, 1H), 8.03 (dd, J = 7.6 Hz, 2.3 Hz, 1H), 7.77 (d, J = 7.6 Hz,
1H), 3.58 (s, 3H), 1.84 (s, 3H), 1.63 (s, 3H). HRMS (m/z): [MH+]
calcd for C11H14N4SO2Cl, 301.0521; found 301.0523.
Enzyme Inhibition Assay. N-Myristoyltransferase is an enzyme
that catalyzes the addition of myristic acid from myristoyl-CoA to the
N-terminal glycine residue of numerous substrate proteins and
peptides with the subsequent release of coenzyme A. 3H-labeled
myristoyl-CoA (GE Healthcare) can be used in the reaction to transfer
3H-myristic acid to a biotinylated substrate peptide (GCGGSKVKPQ-
PPQAK(biotin)-amide, Pepceuticals Inc.). The reaction can be measured
by the subsequent binding of the labeled peptide to streptavidin-
coated scintillation proximity assay (SPA) beads (GE Healthcare) and
monitoring of β-particle excitation of the embedded scintillant (Figure 1).
Measurement of the ability of compounds to inhibit the N-
myristoyltransferase enzyme(s) of human (HsNMT-1 and HsNMT-2)
and kinetoplast (T. brucei, T. cruzi, and L. major) species was per-
formed using a modification of the scintillation proximity assay
platform described previously by Panethymitaki et al.20 as follows:
Compounds were solubilized in DMSO at a top concentration of
10 mM and serially diluted in half log steps to achieve a range of final
assay concentrations of 100 μM to 1.5 nM. Compound at each
concentration was added to white 384-well plates in a volume of
0.5 μL. N-Myristoyltransferase enzyme (HsNMT-1, HsNMT-2,
TcNMT, TbNMT, or LmNMT), dissolved to a working concentration
of 10 nM in assay buffer (30 mM Tris-HCl, pH 7.4, 0.5 mM EGTA,
0.5 mM EDTA, 1.25 mM DTT, 0.1% Triton X-100), was then added
to columns 1−11 and 13−23 of the plates in a volume of 20 μL. To
columns 12 and 24, 20 μL of assay buffer was added to provide a no
enzyme control. Following a 5 min incubation at room temperature
the substrates (GCGGSKVKPQPPQAK(biotin)-amide and myristoyl-
CoA), dissolved in assay buffer, were added to all wells in a volume of
20 μL to start the reaction. The final concentrations of peptide and
3H-myristoyl-CoA were 0.5 μM and 125 nM, respectively, and the
specific activity of the radiolabel was 8 Ci/mmol. Plates were then
incubated at room temperature for up to 50 min (dependent upon the
period of linearity for the different enzyme species) before SPA beads,
suspended to 1 mg/mL in a stop solution (200 mM phosphoric acid/
NaOH, pH 4, 750 mM MgCl2), were added in a volume of 40 μL.
Plates were then read on a TopCount microplate luminometer and
data analyzed by calculating the percentage inhibition compared to the
maximum and minimum assay controls. Concentration effect curves
were fitted using nonlinear regression using XLFit 4.2, and IC50 values
were determined.
Cell Viability Assay. Measurement of the ability of the com-
pounds to inhibit human (MRC5, human lung fibroblast cells) and
trypanosome (T. b. brucei, BSF427, VSG118) cell growth was performed
using a modification of the cell viability assay previously described by
Raz et al.29 Compounds were dissolved in DMSO at a top concentration
of 10 mM and serially diluted in half log steps to achieve a range of final
assay concentrations of 50 μM to 0.5 nM. Compound at each
concentration (200-fold final) was added to clear 96-well tissue culture
plates in a volume of 1 μL. Then 2000 cells per well in relevant growth
medium (HMI-9T for T. brucei, a modification of HMI-9 as described by
Hurumi et al.,30 where 0.2 mM 2-mercaptoethanol was replaced with
0.056 mM thiolglycerol, and MEM with 10% FBS for MRC5) were then
added to columns 1−11 of the plates in a volume of 199 μL. To column
12, 200 μL of medium was added to provide a no cells control. Plates
were then incubated at 37 °C in an atmosphere of 5% CO2 for 69 h,
before the addition of 20 μL of 500 μM rezasurin solution, and a further
incubation period of 4 h. Plates were then read on a BioTek flx800
fluorescent plate reader, and percentage inhibition was compared to the
maximum and minimum assay controls. Concentration effect curves were
fitted using nonlinear regression using XLFit 4.2 and EC50 values
determined.
1
Prototypical Procedure for N-Alkylation of Compound
2. N-(1-Propyl-3,5-dimethyl-1H-pyrazol-4-yl)-4-methoxy-2,3,6-tri-
methylbenzenesulfonamide (3). A solution of N-(3,5-dimethyl-1H-
pyrazol-4-yl)-4-methoxy-2,3,6-trimethylbenzenesulfonamide 2 (100 mg,
0.31 mmol), cesium carbonate (202 mg, 0.62 mmol), and 1-
bromopropane (76 mg, 0.62 mmol) in DMF (10.0 mL) was heated
to 80 °C for 1 h in a microwave. The mixture was partitioned between
ethyl acetate (25 mL) and brine (25 mL), dried (MgSO4), filtered, and
concentrated to dryness in vacuo. The resulting residue was purified by
column chromatography (SiO2, 1:1 ethyl acetate/hexane) to give the
1
title compound as an off-white solid (27 mg, 0.07 mmol, 24%). H
NMR (500 MHz, DMSO-d6): δ 8.67 (s, 1H), 6.45 (s, 1H), 4.46 (t, J =
6.9 Hz, 2H), 3.78 (s, 3H), 2.58 (s, 3H), 2.36 (s, 3H), 2.16 (s, 3H),
2.04 (s, 3H), 1.98 (m, 2H), 1.83 (s, 3H), 1.21 (t, J = 6.9 Hz, 3H).
HRMS (m/z): [MH+] calcd for C18H28N3SO3, 366.1846; found
366.1847.
Prototypical Procedure for Preparation of a 2-Aminopyridine
by SNAr Reaction of 2-Chloropyridine (37) with an Alkyl-
amine. 6-[2-(4-Methylpiperazin-1-yl)ethylamino]pyridine-3-sul-
fonic Acid (1,3,5-Trimethyl-1H-pyrazol-4-yl)amide (42). 6-Chloro-
N-(1,3,5-trimethyl-1H-pyrazol-4-yl)pyridine-3-sulfonamide (37) (225 mg,
0.75 mmol) and 4-(2-aminoethyl)methylpiperazine (215 mg,
1.5 mmol) in ethanol (2.0 mL) were heated at 155 °C for 1 h by
microwave in a sealed vessel. Dilution with DCM (25 mL), washing
with saturated aqueous sodium hydrogen carbonate solution (2 ×
5 mL), drying (MgSO4), and concentration in vacuo gave a residual oil
which was subjected to chromatography (SiO2, 10:90 MeOH/EtOAc)
to give the title compound as an off-white powder (198 mg, 0.49
1
mmol, 65%). H NMR (300 MHz, DMSO-d6): δ 8.77 (s, 1H), 8.07
(d, J = 2.2 Hz, 1H), 7.45 (dd, J = 2.2 Hz, 8.9 Hz, 1H), 7.28 (s br, 1H),
6.54 (d, J = 8.9 Hz, 1H), 3.57 (s, 3H), 3.44−3.39 (m, 2H), 2.41 (t, J =
6.1 Hz, 2H), 2.41 (s br, 4H), 2.36−2.31 (s br, 4H and 3H), 2.16 (s,
3H), 1.89 (s, 3H), 1.67 (s, 3H). HRMS (m/z): [MH+] calcd for
C18H30N7SO2, 408.2176; found 408.2185.
Prototypical Procedure for the Suzuki Reaction between an
Aryl Bromide and a Boronic Acid/Boronate Ester. 2,6-Dichloro-
4-(2-piperazin-1-ylpyridin-4-yl)-N-(1,3,5-trimethyl-1H-pyrazol-4-yl)-
benzenesulfonamide (63).17 A deoxygenated solution of 4-bromo-
2,6-dichloro-N-(1,3,5-trimethyl-1H-pyrazol-4-yl)benzenesulfonamide
(29) (13.84 g, 33.3 mmol), 2-(1-piperazinyl)pyridine-4-boronic acid
pinacol ester (11.57 g, 40.0 mmol), tribasic potassium phosphate (9.73 g,
44.0 mmol), and Pd(PPh3)4 (1.50 g, 0.96 mmol) in DMF (200 mL)
and water (40 mL) in a round-bottomed flask under argon was heated
at 120 °C for 1 h. The reaction mixture was then concentrated in
vacuo, diluted with DCM (400 mL), washed with saturated aqueous
ammonia solution (2 × 100 mL), dried (MgSO4), and concentrated in
vacuo. The residual solid was triturated from Et2O and collected by
filtration to give a solid which was recrystallized from EtOAc to give
the title compound 63 as an off-white powder (15.22 g, 30.7 mmol,
Crystallography. The expression construct for 6xHis-TEV site,
LmNMT (5-421), was obtained from the Structural Genomics
Consortium (SGC), Toronto, Canada. The protein was expressed in
E. coli Rosetta (DE3) using autoinduction medium. Cells were
harvested by centrifugation and resuspended in 50 mM HEPES,
pH 7.5, 0.5 M NaCl, 5 mM imidazole, 5% glycerol (plus DNase,
lysozyme, and a protease inhibitor cocktail) and lysed by passage
through a constant cell disruptor (Constant Cell Systems).
Chromatography steps were carried out using an AKTA system
1
92%). H NMR (500 MHz, DMSO-d6): δ 9.79 (s, 1H), 8.25 (d, J =
5.9 Hz, 1H), 8.20 (s, 2H), 7.61 (s, 1H), 7.40 (d, J = 5.9 Hz, 1H),
4.08 (s br, 4H), 3.63 (s, 3H), 3.28 (s br, 4H), 2.00 (s, 3H), 1.77 (s,
3H). 13C NMR (125 MHz, DMSO-d6): 147.5, 147.3, 143.8, 137.4,
136.3, 135.2, 129.8, 111.8, 111.7, 109.1, 108.9, 42.7, 42.0, 36.2, 10.4.
HRMS (m/z): [MH+] calcd for C21H25N6SO2Cl2, 495.1131; found
495.1124.
150
dx.doi.org/10.1021/jm201091t|J. Med. Chem. 2012, 55, 140−152