Hydrothermal vanadium manganese oxides: Anode and cathode materials for lithium-ion batteries

Add time:07/21/2019    Source:sciencedirect.com

Vanadium manganese oxides with Mn content up to 33 at% were synthesized by a low temperature hydrothermal route allowing for the preparation of both anodic and cathodic materials for Li-ion batteries. Low amounts of manganese (below 13 at%) lead to the formation of elongated particles of layered hydrated vanadium oxides with manganese and water intercalated between the V2O5 slabs, while for higher Mn content of 33 at%, monoclinic MnV2O6 is formed. Former materials are suitable for high energy cathodes while the latter one is an anodic compound. The material containing 10 at% Mn has the composition Mn0.2V2O5·0.9H2O and shows the best cathodic activity with 20% capacity improvement over V2O5·0.5H2O. Lithiated MnV2O6 with Li5MnV2O6 composition prepared electrochemically was evaluated for the first time as anode in a full-cell against Mn0.2V2O5·0.9H2O cathode. An initial capacity ca. 300 A h kg−1 was measured with this battery corresponding to more than 500 Wh kg−1. These results confirm the prospect of using Li5MnV2O6 anodes in lithium-ion batteries as well as high-capacity layered hydrated vanadium oxides cathodes such as V2O5·0.5H2O and Mn0.2V2O5·0.9H2O.

We also recommend Trading Suppliers and Manufacturers of manganese vanadium oxide (cas 14986-95-9). Pls Click Website Link as below: cas 14986-95-9 suppliers

Prev:The effect of manganese additions on the high temperature oxidation behaviour of the high-vanadium cast iron
Next:Electrical conductivity and dielectric behaviour of manganese and vanadium mixed oxide prepared by conventional solid state method)